coal fire Applications

An electrostatic precipitator (ESP), or electrostatic air cleaner is a particulate collection device that removes particles from a flowing gas (such as air) using the force of an induced electrostatic charge. Electrostatic precipitators are highly efficient filtration devices that minimally impede the flow of gases through the device, and can easily remove fine particulate matter such as dust and smoke from the air stream.[1] In contrast to wet scrubbers which apply energy directly to the flowing fluid medium, an ESP applies energy only to the particulate matter being collected and therefore is very efficient in its consumption of energy (in the form of electricity).

By MEVADHASHMA based in Coimbatore, INDIA.

The Cleveland Vibrator Company offers a wide range of pneumatic, piston-driven, industrial vibrators, knockers, impactors and rappers to dislodge collected dust from precipitator wires and plates or baghouse filter bags as well as keep dust free flowing in collection bins and hoppers.

By Cleveland Vibrator Company based in Cleveland, OHIO (USA).

Power Generation Combustion Air Measurements: The need for accurate, repeatable & reliable combustion air measurements in power generation plants is critical to efficient operation and safety throughout the entire facility and processes. Coal-fired power plant applications pose a number of challenges to obtaining these critical flow measurements includ¬ing large ducts, limited metering runs, poor velocity and temperature profiles, high vibration, temperatures up to 750° F and dirty `Fly Ash` laden air.

By Kurz Instruments, Inc. based in Monterey, CALIFORNIA (USA).

By Ametek Process Instruments - THERMOX based in Pittsburgh, PENNSYLVANIA (USA).

Dust filter PPS Filter Bags For Coal Fired Boiler Gas Filtration.

By Zhejiang Grace Envirotech Co., Ltd based in XIAOSHAN, CHINA.

Whether providing high-efficiency, low emissions auxiliary boilers to coal or otherwise fired power plants across the United States, or heat recovery steam generators to natural gas fired turbine plants you will find Superior Boilers serving the needs of power generation customers for years to come.

By Superior Boiler Works, Inc. based in Hutchinson, KANSAS (USA).

Most large coal fired plants have a flue gas desulphurisation (FGD) plant to lower SO2 levels to below emission limit levels. The CODEL GCEM 40 series is used to monitor SO2 levels after the FGD to ensure they are below required levels and to ensure that the process is not too efficient and using too much sorbent. In addition, many plants monitor pre and post the FGD to ascertain the efficiency of the plant.

By Codel International Ltd based in Bakewell, UNITED KINGDOM.

For more than 25 years, coal and biomass fired plants have formed the largest installed user base for Procal CEM systems. Throughout this period, there has been increasing environmental scrutiny and process upgrades, including the near-ubiquitous use of after-treatment systems such as sophisticated FGD and SCR.

By Procal - Parker Hannifin Corp based in Peterborough, UNITED KINGDOM.

Being driven by new legislation, the production of substitute fuel/alternative fuel will be gain momentum in the next few years, as well as the expected increase of recycling rate in municipalities. This means a lot of waste streams can be turned into alternative fuel for the coal fired power plant, cement and lime industry, biomass power plant, or other industrial boiler systems that still burning fossil fuels.

By eFACTOR3 LLC based in Pineville, NORTH CAROLINA (USA).