Only show results available in Virginia? Ok

gas combustion Applications

  • Coal Combustion Residuals Disposal for Power Plants

    Coal combustion residuals (CCR) are generated during the power generation process and can include fly ash, bottom ash, boilerslag, and flue gas desulfurization (FGD) residuals. CCRs contain trace concentrations of heavy metals and therefore cannot be dumped or stored where rainwater can leach the metals. Liner systems can be used to contain the coal combustion by-products and protect them from leaching into the environment.

    By CETCO based in Hoffman Estates, ILLINOIS (USA).

  • Premium

    Monitoring solutions for the flow combustion efficiency areas

    Combustion efficiency is of major importance on small boiler plants and the best way to monitor this is by monitoring CO2 emissions. CODEL offer the Model 1010 Cross-Duct CO monitor. Using Infra-red Gas Filter Correlation technology to filter out interferences such as dust and other gases. The Model 1010 has low maintenance requirements and meets the needs of most boiler applications. In addition to small boilers the Model 1010 is also used on Animal carcass incinerators and Crematoriums.

    By Codel International Ltd based in Bakewell, UNITED KINGDOM.

  • Premium

    Gas Sensing for Gasification

    Syngas (short for synthetic gas) can be burnt and used as a fuel source, the main constituents of syngas are Carbon Monoxide (CO) and Hydrogen (H), which amount for around 85% of Syngas, and it is produced by a process called Gasification. Gasification starts with a base material which can originate from a wide variety of materials for example wood chips and pellets, plastics, municipal solid waste, sewage, waste crops, and fossil fuels such as coal. During Gasification the base material is reacted at high temperature without combustion with controlled amounts of oxygen (O) or steam. The composition of the base material combined with the amount of oxygen and heat used in the process affects the composition of the resultant SynGas, in which the CO can vary between around 20 and 60%. In addition, large amounts of H and CO are also formed. The measurement of CO is therefore an important feature in the production of SynGas.

    By Edinburgh Instruments Ltd based in Livingston, UNITED KINGDOM.

  • Biogas monitoring

    meet governmental regulations, it is important to accurately monitor methane gas production, removal, venting, and burning. Knowledge of both methane flow and temperature at the flare stack can define when CH4 is being emitted to the atmosphere. The DX99 FlexPower™ Nodes can be installed in EX area with a Zone 0 ATEX certification. Use the analogue input to determine methane production levels and flow and use the thermocouple model to measure the temperature of a vent to verify the continuous combustion of methane.

    By Banner Engineering Corp. based in Minneapolis, MINNESOTA (USA).

  • Power Generation

    Combustion turbines A gas turbine, also called a combustion turbine, is a type of internal combustion engine. It has an upstream rotating compressor coupled to a downstream turbine, and a combustion chamber in-between. The basic operation of the gas turbine is similar to that of the steam power plant except that air is used instead of water. The turbine shaft energy is used to drive the compressor and other devices such as an electric generator that may be coupled to the shaft. The energy that is not used for shaft work comes out in the exhaust gases, so these have either a high temperature or a high velocity. A catalyst is often used to treat these exhaust gases to comply with emissions regulations. EmeraChem has installed OEM and after-market catalyst in over 240 applications

    By EmeraChem based in Knoxville, TENNESSEE (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you