The most important measurement parameter is irradiation. Since PV systems are becoming ever larger, the accuracy of the irradiation measurement is increasingly important for the efficiency of the system. Wind cools the temperature of the module and must therefore be included in the efficiency calculation. Precipitation leads to contamination or covering (snow). With increasing temperature, the performance of the solar module decreases. Therefore, it is important to measure the temperature of the solar module in...
Numerous technologies and products were evaluated for this application. A monitor with no moving parts, no significant effect from turbidity, and the ability to detect the lube oil at less than 1 ppm was determined to be the best solution. Fast, reliable, and accurate detection of lubricating oil in the water was needed.
Combustion efficiency is of major importance on small boiler plants and the best way to monitor this is by monitoring CO2 emissions. CODEL offer the Model 1010 Cross-Duct CO monitor. Using Infra-red Gas Filter Correlation technology to filter out interferences such as dust and other gases. The Model 1010 has low maintenance requirements and meets the needs of most boiler applications. In addition to small boilers the Model 1010 is also used on Animal carcass incinerators and Crematoriums.
The battery charging is done through the solar panel connected to reduce the energy used from grid power and to save the electricity bills. It increases battery life because of ripple free charging from solar panel.Complete logging and monitoring of Solar (optional)
The system monitors the solar energy generated from the panels and stores the cumulative KWH generated. Monitoring through communication
In order to assure well-founded decisions in designing profitable solar power plants, the solar irradiance should be measured in the assessment phase. Irradiation is a crucial parameter for site selection and plant design and economics of plant. There are many different ways and technologies to measure the irradiance phenomena that influences the power generation of a future solar power plant. Ammonit’s solutions are designed to meet the latest standards with regard to accuracy and affordability of the measurement.
In the earlier days, the chemistry involved in solar cell manufacturing was relatively simple, using commodity chemicals. With cell efficiencies continuously on the rise and new cell concepts slowly being introduced with increased speed of processing, precise chemical concentration control is becoming crucial to obtain consistency and more cost-effective manufacturing of solar panels. This is possible by monitoring on-line the etching bath composition, a small but genuine step forward in your competitive advantage....
Regardless of whether a power plant runs on coal or natural gas, it has a very large environmental impact. Producing and transporting fuel also requires consuming resources and generating emissions. Stricter environmental requirements and increased energy costs are challenges for the industry. Solar energy can be used to preheat the water, the make-up water and the actual steam process. Solar collectors that concentrate the sunlight provide a lot of advantages for the purchaser. Read more about our products and...
Frequency inverter reconstruction of Power Plant promoted heightening of economy benefit. Frequency inverter won acceptance of user as its high reliability, flexible adjustment and simple operation. A Power Plant was set up in June, 2000. Its predecessor was one of key plants of state. The plant put into service in 1957. Now it has 4×50MW, 2×142MW, total ten boilers and six generators. Total capacity is 484MW. The plant supplies power to big enterprise near to it.
PV performance measurements under real outdoor conditions are done in may different ways. However, the concept of all performance investigations is to relate the input energy, which is the solar radiative flux, to the output energy, which is the electrical power produced by the PV module. EKO’s Solar Monitoring Stations, referred to as SMS, is the dedicated facility for this type of evaluation.
Procal supply analysers to monitor many different applications from small combustion plants to large power stations. Examples include University Boiler Plants, Carbon Black Plants, Thermal Oxidisers and Community Heating Projects.
Turboden units allow to convert the heat collected by solar collectors into electricity through an efficient thermodynamic cycle. Concentrating Solar Power systems with Turboden ORC can be cost-effective from 200 kW electric, depending on the irradiation of the installation site.
Is it suitable for you?
Concentrating solar collector field from 2 ha
Hybrid CSP plants, e.g. solar+biomass
Weather data is critical to optimizing the efficiency of solar power generation. Beginning with site assessment, on-site meteorological monitoring factors into overall project performance and ROI. Weather stations provide reliable information on parameter
There is no legislation to control of the proper functioning of pyranometers used to measure solar radiation installed in the PV field.
The control can be effectively carried out with portable
instruments suitable to avoid uninstalling pyranometers set in areas normally inaccessible as placed at the side of panels.
A quick test on the field assesses whether a good maintenance is sufficient to obtain a reliable measurement of the solar radiation or if it is necessary to send radiation sensors to the manufacturer...
Supervision and maintenance on those locations without internet wired connection requires high personnel cost and also means a slow reaction in case of malfunction events and alarms. For companies with a big amount of remote location centers (such as repeaters of operators and telephone companies, production and distribution centers for energy manufacturers or photovoltaic/eolic plants), maintenance and supervision labors involve disproportionately high costs.
When it comes to energy production and protecting the environment, going down new paths is more critical than ever before. We do just that. SCHOTT Solar has more than 50 years of experience in solar technology and combines expert knowledge in receiver technology for solar power plants with parabolic trough technology and photovoltaics under one roof. Welcome to the future.
Anaerobic Digestion plants produce various gas components from a source material (or feedstock) that can be composed either solely or as a mixture of slurries, purpose-grown crops, food and organic waste material. The composition of the gas produced varies depending upon the feedstock and the Anaerobic digestion process itself. As a consequence, it is normal to measure various components of the resultant gas produced to evaluate the efficiency of the Anaerobic Digestion process. Furthermore, due to the flammable...
The continuing establishment of nuclear power stations around the world pose unique environmental challenges for their operators. Ecotech provides air samplers to nuclear power plants for sampling of radionuclides.
A nuclear power plant`s radionuclide monitoring network enables continuous sampling of airborne particles onto sample filters contained within High Volume Air Samplers. These filters are then analysed in a laboratory in order to screen for any radiation releases. The challenge has always been to...