- Home
- Companies
- Adamant Valves
- Articles
- How to Install Stainless Sanitary Ball ...
How to Install Stainless Sanitary Ball Valves
Courtesy of Adamant Valves
Here are some steps for installing a stainless sanitary ball valve.
Remove the protective cap on both sides of the flange first and clean it with the valve fully open. Before installation, it should carry out the whole machine test according to the required signal or gas (to prevent the vibration caused by transportation affecting the performance). After passing the test, it can be installed (wiring should refer to the electric actuator circuit diagram).
Flush and remove any remaining debris from clean lines which may cause damage to the seat and ball before preparing for connection to the pipe.
During installation, do not use the actuator part of the valve as lifting lifting point to avoid damaging the actuator and accessories.
This type of valve should be installed in the pipe horizontal or vertical direction.
Pipelines near the installation point may not be lowered or subjected to external forces. Pipeline supports or supports may be used to eliminate the deviation of the pipelines.
After connecting the pipe, cross-fasten the flange bolts with the specified torque.
-
Most popular related searches
Customer comments
No comments were found for How to Install Stainless Sanitary Ball Valves. Be the first to comment!