batch gasification system Articles

  • Solid waste gasification pollution abatement - Case study

    Catalytic Products International has partnered with a Gasification System Designer in the design and supply of a unique thermal oxidizer for use with a closed loop batch pyrolysis gasification system. The gasifier is engineered to create a clean combustible syngas from a broad spectrum of dissimilar carbonbased solids, liquids, and other feedstocks. The QUADRANT NR – SEVERE DUTY Thermal ...

  • Thermodynamic analysis of an integrated gasification combined cycle power plant: effect of nitrogen supply on system performance

    A comprehensive thermodynamic analysis of a conceptual integrated coal gasification combined cycle power plant is presented. Energy and exergy efficiencies and exergy destructions of each sub–unit are calculated. The effect of nitrogen, which is supplied from the Air Separation Unit (ASU) of the gasification unit to the combustion chamber of the gas turbine (GT) cycle, on system performance is ...


    By Inderscience Publishers

  • Biomass-fired fuel cells

    The results are presented of a techno-economic analysis of systems integrating biomass gasification plant with phosphoric acid and molten carbonate fuel cells. The cases studied relate to the generation of electricity at a scale of 500 kWe. At this level, the plant would be suitable for small-scale commercial or industrial application and would allow for the export of surplus electricity. The ...


    By Inderscience Publishers

  • Exergy analysis of an integrated two–stage biomass gasifier and Solid Oxide Fuel Cell system

    In this study, an exergy analysis is applied to a conceptual integrated two–stage biomass gasifier and Solid Oxide Fuel Cell (SOFC) system. Several simulations are conducted to assess the effect of some key input parameters on the exergy ratios of the components and the exergy efficiency of the system. The results show that the exergy efficiency of the integrated system varies between 11.6% and ...


    By Inderscience Publishers

  • China must be encouraged to develop hydrogen energy and fuel cell technology using domestic resources

    This paper describes the current situation in China and the reasons for the rapidly increasing consumption of oil and the consequent search for new sources. Some suggestions are made for the rapid development and commercialisation of hydrogen energy systems in China using domestic resources. China could satisfy the energy demand with her domestic resources of renewable energies and depending on ...


    By Inderscience Publishers

  • Biomass power generation in China

    “China is an agricultural country,” said Frank Miao. Farmers used to burn harvest waste, and the government decided to capture this energy by constructing a biomass power plant. At the end of 2006, the total biomass power generation capacity in China was approximately 2,200 megawatts (MW). The planned capacity of biomass power plants is 30,000 MW by 2020. Depending on the size of the plant, three ...

  • The techno-economic assessment of biomass pyrolysis gasification system for central gas supply: a case study of Jinzhou

    The techno-economic assessment of biomass pyrolysis gasification system for central gas supply was conducted using cost and profit method. From the results, it can be seen that Net Present Value (at discount rate of 10%), profit/Cost, and Internal Return Rate of financial analysis in village level under the subsidy of government were 5.61 ? 104 Yuan, 1.09 and 13%, respectively. And Net Present ...


    By Inderscience Publishers

  • Thermophysical characteristics of the biomass tar from a crop stalk gasification system

    Presently, the biomass gasification and centralised gas-supply system fed by crop stalks is still at the stage of development and research in China. The purifier of the system has some problems such as huge device, low purifying efficiency, and poor disposal of tar causing secondary pollution. For this reason, the distillate range, calorific value, ignition temperature, flash point and viscosity ...


    By Inderscience Publishers

  • Commercialisation options for biomass energy technologies in ESCAP countries

    Biomass provides the basic energy requirements for cooking and heating in rural households and for processes in a variety of traditional industries in developing countries. In general, biomass energy uses in such cases are characterised by low efficiency. Potentially, efficiency improvements of existing energy systems could increase the energy supply from biomass substantially. Also, wide ranges ...


    By Inderscience Publishers

  • Hydrogen-rich synthesis gas production from waste wood via gasification and reforming technology for fuel cell application

    The purpose of this study was to establish a fuel process for an advanced power generation system in which hydrogen-rich synthesis gas, as the fuel for the molten carbonate fuel cell (MCFC), can be extracted from biomass via gasification and reforming technologies. Experiments on waste wood gasification were performed using a bench-scale gasification system. The main factors influencing hydrogen ...


    By Springer

  • Exergy analysis of a syngas fuelled cogeneration cycle for combined production of power and refrigeration

    This communication presents a biomass fuelled cogeneration cycle for the combined production of power and refrigeration. The system is an integration of combined gas–steam cycle and absorption refrigeration cycle. A thermodynamic analysis through energy and exergy is employed, to investigate the effects of cycle pressure ratio, gas turbine inlet temperature and evaporator temperature on first–law ...


    By Inderscience Publishers

  • Regulation of Oil-Bearing Hazardous Secondary Materials From the Petroleum Refining Industry Processed in a Gasification System to Produce Synthesis Gas

    The Environmental Protection Agency (EPA) is revising its hazardous waste management regulations under the Resource Conservation and Recovery Act (RCRA) to further promote the environmentally sound recycling of oil-bearing hazardous secondary materials generated by the petroleum refining industry. Specifically, EPA is amending an existing exclusion from the definition of solid ...

  • Integration of Fischer-Tropsch fuel production with a complex oil refinery

    The oil refining industry is facing harder policies on renewable content in its products. One way to meet this is to produce diesel and gasoline from gasification of biomass via a Fischer-Tropsch (FT) synthesis. In this paper, heat integrating a biomass-to-FT syncrude process with a refinery is compared to a stand-alone biomass-to-FT syncrude process, in terms of the consequences for GHG ...


    By Inderscience Publishers

  • Renewable energy programmes in India

    With a strong industrial base and successful commercialisation of technologies in renewable energy, India is in a position today to offer state-of-the-art technology to other developing countries and is poised to play a leading role in the global movement towards sustainable energy development. India has a separate ministry to promote renewable energy sources, which has been named Ministry of ...


    By Inderscience Publishers

  • Value of nuclear power in the global energy system

    With a global energy model which finds the minimum cost energy system over the time range of 1995-2055, the value of nuclear power is analysed. The model incorporates detailed descriptions of energy conversion technologies. For nuclear technologies, light water reactors and fast breeder reactors are taken into account with fuel cycle options. Major findings are: 1) the maximum introduction of ...


    By Inderscience Publishers

  • Economic assessment of regional bioenergy systems in Australia: a flow analysis application

    This paper describes a modelling tool that integrates Material Flow Analysis, energy production and Greenhouse Gas (GHG) emissions accounting for biomass flows at a regional scale. This tool allows comprehensive analysis of alternative systems for management of biomass waste and bioenergy production in regional areas. Different possible options for processing a range of biomass waste streams can ...


    By Inderscience Publishers

  • The technoeconomic assessment of the hydrogen fuel chain

    Options for hydrogen fuel chain are compared with the existing petroleum-based fuel chain for transportation. The criteria used are the life cycle cost (Rs/km), Greenhouse Gas (GHG) emissions (g/km) and Nonrenewable Energy (NRE) consumption (MJ/km). Four hydrogen production methods, one hydrogen transport method, three hydrogen storage methods and two on-board energy conversion methods are ...


    By Inderscience Publishers

  • Sources and technology for hydrogen production: a review

    A comprehensive review of various processes and possible sources of hydrogen production are discussed in this paper. The various process for hydrogen production reviewed includes industrial process i.e. steam reforming, thermal cracking, partial oxidation of fossil fuels, coal gasification, electrolysis, thermochemical etc. and new emerging processes like photolysis, photo-voltaic electrolysis, ...


    By Inderscience Publishers

  • Green Energy Applications Guide to Flow Measurement

    Provides technical discussion and illustrations for nine (9) different green energy and green-house gas flow measurement applications.  Includes landfill gas, biomass fermentation, wastewater digesters, on-farm biogas recovery, ethanol production/refining, coal mine and coal bed methane (CMM, CBM), biomass gasification, flare gas and flue gas.  Discussion includes overview of each ...

  • Co-Fire Naturally

    PRM Energy System’s Naturally Gas Cofiring Machine Your PRME Naturally produced biogas will come from biomass – not fossil fuels. Technically speaking, you will be “co-firing” gas produced by the thermal gasification of biomass. PRME’s Naturally Gas Co-firing process design is not experimental or “under development”, but has been commercially firing ...


    By PRM Energy Systems, Inc.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you