boiler optimization Articles
-
BNP Paribas real estate case study
Following the installation of Sabien’s M2G boiler controls into 20 of one of its clients’ buildings, BNP Paribas Real Estate has appointed Sabien Technology as a preferred supplier of boiler efficiency units. As a result of this appointment, Sabien’s M2G intelligent boiler load optimisers will, where appropriate, be supplied to clients of BNP Paribas Real Estate to improve ...
-
Sabien takes pride in mod installation case study
As part of a major energy-saving programme, Sabien’s M2G boiler load optimisation controls have been installed at 28 Ministry of Defence sites across south-east England Sabien’s M2G units were selected by PriDE, the joint venture between Interserve Defence Ltd and SSE Contracting that manages the Defence Infrastructure Organisation’s South East Regional Prime Contract. ...
-
HMS Sultan case study
Sabien Technology has supplied 111 M2G intelligent boiler load optimisers to HMS Sultan, the home of the Defence School of Marine Engineering (DSMarE) and the Royal Naval Air Engineering and Survival School (RNAESS). CUSUM (cumulative sum) analysis of energy consumption data indicates a 12% energy saving, with a return on investment within 1.4 years. Installation of the M2G units was part of a ...
-
Tips for turning a coal fired boiler to gas fired boilers
Smog has been a heated topic among the word. Therefore , gas fired boiler substitute for coal fired boiler become a trend to protect the environment.Since the boiler is a large thermal equipment ,it is requires attention to security incidents in the transformation .Here are some tip from ZG about turning a coal fired boiler to gas fired boiler. First , when turning a coal fired boiler to gas ...
-
Focus Bioenergy No 3 2004: Forest industry - a major user and supplier of biofuels
Forest industry is a major user and supplier of biofuels. Sawmills use bark and shavings internally as fuel. The surplus goes to district heating plants, production of refined biofuels and the board industry. Other residual products from the sawmills are chipped. The bulk, the damp chips, is used for paper pulp in the pulp industry, whereas dry chips go to the fuel sector. The pulp industry uses ...
By Elmia AB
-
Improving energy use efficiency in Nigeria's industrial sector: a case study of a beverage plant
Industrial energy is a major component of the total energy use in a nation. However, energy is not without a cost in its production, availability, use and even its environmental impact on society. In addition, most of the energy resources are depletable, thereby necessitating their sustainable use through energy efficiency improvement programs. In this investigation, an attempt was made to study ...
-
Boiler Combustion Improvement and NOx Reduction Technology
Untitled Document Synterprise, LLC (based in Chattanooga, TN) and ECOMB AB (based in Sweden) offer the Ecotube System for NOx reduction and combustion improvement. ECOMB AB, an environmental equipment and research company in Sweden, has developed and patented a process called “The Ecotube System”, which reduces NOx emissions from boilers by 60% or more. The Ecotube ...
By Synterprise
-
Energy conservation studies on residential heating systems: an application for Izmir, Turkey
Energy conservation through improvement of the efficiencies of end use devices such as boilers and stoves used for space heating is one of the most effective ways to provide immediate relief for the energy problem in the residential sector of Turkey. For this reason, during the 1995-96 winter period, the campaign "Saving the Environment Begins at Home" was launched by the branch office of the ...
-
How To Prolong The Life Of Your Boiler
Regularly boiler maintenance will prolong the life of your boiler and improve efficiency, saving you money. Over the years sludge can build up within the system making it work harder, causing it to be inefficient and expensive to keep. A planned maintenance will flush the system, removing the sludge and other deposits, your gas engineer will also treat the boiler. Flushing a new system will also ...
-
A novel approach for modelling of NOx emission reduction in a tangentially fired coal boiler
In this research paper, predictive modelling of NOx emission of a 210 MW capacity pulverised coal–fired boiler and combustion parameter optimisation to reduce NOx emission in flue gas is proposed. The effects of oxygen concentration in flue gas, coal properties, coal flow, boiler load, air distribution scheme, flue gas outlet temperature and nozzle tilt were studied. The data collected from ...
-
VSEP improves industrial boiler performance and reduces blowdown frequency by a factor of ten
In the steam boiler industry, high purity feed water is required to ensure proper operation of steam generation systems. High purity feed water reduces the use of boiler chemicals due to less frequent blowdown requirements (reducing blowdown frequency by as much as a factor of 10). Lower blowdown frequency also results in lower fuel costs. Scale buildup is reduced due to a smaller concentration ...
-
Bubble, bubble … boiling on the double
Original story at MIT New analysis of textured surfaces could lead to more efficient, and less dangerous, power plants. The boiling of water is at the heart of many industrial processes, from the operation of electric power plants to chemical processing and desalination. But the details of what happens on a hot surface as water boils have been poorly understood, so unexpected hotspots can ...
-
Techno-economic evaluation of revamping of coal-fired power plants in India
A techno-economic feasibility study has been conducted to investigate the revamping of two 32 MWe Pulverised-Coal (PC) boilers with a number of firing options. The options investigated were: (1) conventional PC revamping, (2) replacement with a new PC boiler, (3) PC to Circulating Fluidised Bed (CFB) revamping, (4) replacement with a new CFB boiler, and (5) Bubbling Fluidised Bed (BFB) revamping. ...
-
Improve Boiler Efficiency
In many chemical plants, the electricity the plant uses is derived from a natural gas power plant or a co-generation plant burning waste gas streams. In large boilers (Figure 1), power plants bring together air and fuel (natural gas, waste gas, oil or coal) for combustion, which creates heat. The heat boils the water, creating steam. The steam runs through a turbine, which causes the turbine to ...
-
Gas boiler load optimisation controls can rectify dry cycling and reduce energy costs by 25%
Dry cycling of gas boilers can waste a great deal of energy, even when BMS optimisation is in use. Installing gas boiler load optimisation controls can reduce this waste and help boilers run more efficientlyBuilding engineers, energy and facilities managers tend to overlook that many gas boilers waste energy through dry cycling when they are not actively contributing to the building heating and ...
By Vital Energi
-
Energy efficiency and emission reduction of TPM, PM2.5, and SO2 from natural gas and fuel oil fired boiler exhausts
Fully 8% of all of Canada’s energy consumption occurs in gas and fuel oil fired boilers in commercial and institutional facilities1, with proportional amounts of greenhouse gases, particulate matter, and other pollutants. Recently particulate matter, and in particular that smaller than 2.5 microns (PM2.5) has garnered specific attention due to attributed health effects as demonstrated by ...
-
Rectify dry cycling of gas boilers and reduce energy costs by 25%
Building engineers, energy and facilities managers tend to overlook that many gas boilers waste energy through dry cycling when they are not actively contributing to the building heating and hot water demand. It is often thought that existing building management systems (BMS) and building energy management systems (BEMS) are optimising the boilers to remove dry cycling. However, the BMS is ...
By Vital Energi
-
Kinetics of forming the nitrogen oxides and other harmful substances in catalytic power plants
In the following paper, the kinetics of forming nitrogen oxides and other harmful substances in catalytic power plants are described. First of all, the equilibrium NOx concentrations are considered. The discrepancy between equilibrium concentrations and real results on NOx in the case of flame combustion are explained by a short duration of fuel-air mixture stay in furnace space. The positive ...
-
Catalytic boilers with catalytic fluidised bed
In this paper, conditions of work, special features and problems of boilers with catalytic fluidised bed are described. The specific conditions, when the catalyst layer remains stationary and granular or becomes spouting, are also considered. There are some main zones in the catalytic boilers with fluidised bed, which characterise such boilers and which must exist in them under normal working ...
-
Project Kaunas Combined Heat and Power Plant - Case Study
26 MWh Kaunas, Lithuania 2018 March 24 Main equipment Fuel supply system - overground warehouse with moving platforms Fuel combustion system - Saxlund combustion grate with water-tube steam boiler Additional heat generation equipment - flue gas condensing economizer (FGCE) Flue gas cleaning system - multicyclones Purpose of this power plant – provision of heating to ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you