burner equipment Articles

  • Biomass Burner Refractory Solutions

    Thermal Spalling of Refractory Material in Biomass Burner NW Ohio Biomass Burner Case Study Industry: Food Industry Description of Equipment: Biomass Burner Problem: General:Inside the Biomass burner there is.... ...

  • Are GAS-FIRED Burner Technologies Really The Best Choice for ISTR Cleanups?

    Its an exciting time. In-Situ Thermal Remediation (ISTR) shows great promise and has proven to be an extremely effective method for cleaning a wide range of Contaminants of Concern (COC’s) at contaminated sites. Most recently, gas-fired soil heating technologies are entering the market with promises of much cheaper natural gas heating, faster setup and heating times, less heaters required ...


    By Soil-Therm Equipment, Inc.

  • 1:60 Control Range with Flare

    Type     HOFGAS®- LPM 3000/2500  Performance     2,500 Nm³/h, 12,500 kW Location     Central England (GB) Initial Situation The landfill site is situated in the middle of the Sheffield region. Over time, the city limits and the landfill site have grown together. Therefore, the operator is particularly ...


    By Hofstetter BV

  • The Nitrogen Experts - success factors

    Employees Highly experienced: our employees average 14 years of nitrogen pumping services Equipment Incorporates the latest technology available Meets high standards of quality, maintained in-house Offers both heat recovery and burner units Management Committed to providing the ...


    By CETCO Energy Services

  • Gas Fired Oven

      INDUSTRIAL GAS FIRED OVEN   CONSTRUCTION An industrial Gas Fired Oven is typically of steel construction, comprised of inner and outer shells of sheet steel panels, separated by 4” thick, 6 lb/ft3 density mineral wool insulation.  The panels are constructed as to minimize metal-to-metal contact between inner and outer shells and reduce heat flow from ...


    By Epcon Industrial Systems, LP

  • Saving waste in the boiler house

    Burner technology has improved greatly in recent years. Older Burners had a series of cams and levers that were calibrated to provide specific amounts of air for a particular rate of firing. Being mechanical items, these wore and sometimes required calibration. They, therefore, had to be regularly serviced and calibrated. Generally, new burners use frequency controlled motors and cams to open air ...


    By EBE Engineering Ltd.

  • Vaporiser - Shandong LNG Terminal - Case Study

    Project Details Customer Name: Shandong LNG Terminal The Brief: Provide heat for regasification of LNG Location of Installation: Shandong, China Products supplied: 4 off Submerged Combustion Vaporisers (SCV) ...


    By Process Combustion Ltd

  • APPLICATION OF H-VARB TECHNOLOGY TO IMPROVE COAL FLOW BALANCE AT NANTICOKE GENERATING STATION

    ABSTRACT The power generation industry is constantly challenged with the need to improve the emissions and heat rate performance of their assets. In the case of pulverized coal fired units, poor fuel balance at the burners is a relatively common issue that impedes efforts for combustion optimisation. The problem of fuel imbalance is particularly acute on units that employ splitting devices ...


  • Tuning Your Boiler for Fuel Savings – Out with the Old in with the New Technology

    The USA has about 811,000 MW of installed generation and over 52% of our Electric power is produced by aging coal fired power plants. The average utility boiler furnace was designed about 30-40 years ago. According to DOE records, the average boiler in 1974 was fired with 80% bituminous coal. Now, western PRB coal is much more prevalent and represents about 50% of total coal ...

  • Ethanol Plant Modifications Result in Capacity Increase

    Operating Issue When the production capacity of a Midwest ethanol plant was limited to 80% by their existing air pollution control equipment, Pollution System Solutions was sought to utilize their industry knowledge and resources to identify the underlying issue and resolve it. Project Solution After carefully considering the Thermal Recuperative ...


    By Pollution Systems

  • Maxsys Fuel System generates 6% savings on Gas Fired Steam Raising Boilers at Mondi Packaging

    Mondi is one of the world’s leading international paper and packaging groups with a substantial global presence, employing 34,000 people at 112 sites across 34 different countries. The company is continually striving for a consistent high level of improvement in environmental performance in all its operations, making efficient use of raw materials and energy, while focusing on innovation ...


    By Maxsys Fuel Systems Ltd

  • Forces attracted to fuel savings

    Magnatech Fuel Conditioning Limited have recently completed a contract to install their very powerful magnetic fuel conditioning units to all structural gas and oil burning equipment across five MOD bases in England. This was after research concluded that Magnatech was the most cost effective provider of this type of application.The MOD have used this technology previously, when a number of bases ...

  • Vattenfall`s Cogeneration Power Plant Reuter West - Case Study

    The cogeneration power plant “Reuter West” was erected as a base load power plant in the vicinity of the existing “Reuter” plant. The two hard coal fired 300 MW units D and E were commissioned in 1987 and 1989. Today the cogeneration units supplying electricity and thermal energy are operated by Vattenfall Europe GmbH. The heart of each power plant is the boiler where the ...

  • Tips for turning a coal fired boiler to gas fired boilers

    Smog has been a heated topic among the word. Therefore , gas fired boiler substitute for coal fired boiler become a trend to protect the environment.Since the boiler is a large thermal equipment ,it is requires attention to security incidents in the transformation .Here are some tip from ZG about turning a coal fired boiler to gas fired boiler. First , when turning a coal fired boiler to gas ...

  • Case study - Maximizing heat recovery from your oxidizer and reducing operating costs

    More and more, companies operating air pollution control equipment today realize that the initial capital cost of an oxidizer system can be rapidly eclipsed by continued operating expenses if careful attention is not periodically given to the system. Below are ten tips to ensure your oxidizer is operating at peak performance. The first five tips focus on parameters end-users should know about ...

  • Luminant Oak Grove Power Station - Case Study

    Powering Texas Luminant, a subsidiary of Energy Future Holdings Corp. (EFH) -which owns competitive and regulated energy subsidiaries in Texas -is the largest electricity generator in Texas. Unit two of the Oak Grove Power plant near Franklin in Robertson County, TX went online in the middle of 2010. Fluor, the project’s EPC company, completed the plant in 35 months and used ...

  • Rectify dry cycling of gas boilers and reduce energy costs by 25%

    Building engineers, energy and facilities managers tend to overlook that many gas boilers waste energy through dry cycling when they are not actively contributing to the building heating and hot water demand. It is often thought that existing building management systems (BMS) and building energy management systems (BEMS) are optimising the boilers to remove dry cycling. However, the BMS is ...


    By Vital Efficienci Ltd.

  • Energy efficiency: The unsung hero of our times

    As our economy continues to sputter, one little-noticed industry has been booming for a while now: energy efficiency. The sector is hiring like crazy -- a fact that speaks volumes about the close relationship between clean energy and the economic recovery that we're all waiting for. Energy efficiency could save us all. My firm works with utilities, government agencies, housing authorities, and ...

  • Business seeks viable alternatives to price cutting

    The UK manufacturing industry is undergoing a severe recession. Any business involved in production is facing serious competition from countries that can produce goods at much lower prices due to cheaper equipment, labour and general costs. Globalisation has meant that companies have had to expand their focus to include new and expanding markets. Assessing where manufacturing functions are best ...


    By Maxsys Fuel Systems Ltd

  • Waste to Energy Analysis

    The manufacturing of SRF in a single pass is not a new concept. However, with the environmental efficacy of alternative fuel production under seemingly increasing scrutiny, a one-step process is of growing importance, believes Peter Streinik, Head of Business Unit Waste at UNTHA. There can be no disputing that alternative fuel production is being increasingly acknowledged as a valuable part of ...


    By UNTHA Shredding Technology

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you