heat pump technology Articles

  • Heat Pumps – FAQs

    1. What is a Heat Pump? To put it simply; ground source heat pumps and geothermal heat pumps produce high grade heat from low grade heat which is found in the earth and our atmosphere.2. How does a Heat Pump Work?Heat pumps work in exactly the same way as air conditioners or refrigerators, but in reverse! Heat pumps capture latent energy which is stored in sources such as air, water and earth. ...


  • Geothermal Heat Pump (GHP) - Case Studies

    Case Study: “GHP schools used approximately 26% less source energy per square foot of floor area,” according to an evaluation of Lincoln, Nebraska schools by the Department of Energy. The report concludes that the schools using GHP technology “outperform others in the school district.” Case Study: Annual electrical consumption in Fort Polk ...

  • Heat recovery from wastewater

    Heat recovery from gray water is particularly important in water-intensive industries such as pulp and paper plants, dairies and breweries. Rather than flushing used water down the drain, consider whether a heat exchanging system can help you put that energy to work in your process again. Most plant operators arc aware of the need to save money and reduce the environmental impact of their plant ...


    By DDI Heat Exchangers Inc.

  • Combined Heat and Power – Questions and Answers

     1. What are the benefits of CHP for business?   combined heat and power (CHP) is a well-proven technology, recognised worldwide as a cleaner alternative to traditional centralised generation. Its long-term future in the global energy markets is secured by CHP's ability to provide a multitude of financial, ...


    By ENER-G

  • Geothermal Energy Technologies

    Technology Overview   Nowhere is the raw power of geothermal resources more evident than at the Old Faithful geyser at Yellowstone National Park. (Joel Renner)  Geothermal energy is natural heat from the Earth's interior where temperatures reach greater than 7000°F. The heat is brought to the surface as steam or hot water—created when water flows through heated, permeable ...


  • Introduction to pinch technology

    This material aims to give an overview of the fundaments of Pinch Technology. You will learn: • How to obtain energy targets by the construction of composite curves.• The three rules of the pinch principle by which energy efficient heat exchanger network designs must abide.• About capital-energy trade off for new and retrofit designs.• The best way to make energy saving process ...

  • First industrial application of an open absorption cycle for heat transformation in a district-heating network

    The first plant for high temperature utilisation of higher heating value was realised under industrial conditions in a combined heat and power plant. The technology results in an increased heat recovery temperature and a stronger dehumidification of the flue gas. Beyond that, the use of large solution flow within an adiabatic absorber enables to combine gas scrubbing and dehumidifying. Economic ...


    By Inderscience Publishers

  • Opening markets for CSP – the industrial heat application

    Heavy industry can be a viable secondary market today for CSP producers, but questions remain on whether start-up costs are justifiable for industrial users, and how reliable CSP can be for processes that can't pace production by the sun. Solar thermal heat implies steam, and industries that need steam include refining, food processing, wood-working, desalination and chemicals, among others. ...


    By FCBI Energy

  • Heat recovery and energy efficiency, improves profitability and reduces CO footprint

    Using latest technology in combustion of oil and gas can provide significant savings in overall energy consumption. Modern oxygen control that compensates changes in ambient temperature and fuel qualities can increase energy efficiency up to 3%. By adding the usage of hot combustion air another 2-3% can be saved. Modern burner technology without mechanical linkage, operating with accurate ...


    By Oilon Oy

  • Case-study - Utilising waste heat for water production and climate control

    Water purification is needed to produce high quality water for consumption, agriculture and industrial needs. Conventional water treatment processes, like distillation and reverse osmosis, consume vast amounts of energy. However, there is a large potential for significant reductions in energy consumption and CO2 emissions in this sector. It can be achieved by the exploitation of waste heat for ...


    By Climate-KIC

  • AD and Biogas Technology Developments in UK

    The anaerobic Digestion and Biogas Association’s fourth annual trade show and conference — UK AD & Biogas 2013 — attracted a busy stream of visitors to Birmingham, England in early July, demonstrating a growing interest in this vibrant industry sector. The event included facility tours, conference sessions, workshops, free one-on-one consultations with industry experts, ...


    By BioCycle Magazine

  • Carbon Reduction Versus Affordable Warmth - the district heating challenge

    Government and European Legislation, Building Regulations and planning requirements are driving the residential new build sector to consider and adopt technologies such as bio-diesel boilers, biomass boilers and heat pumps to support the delivery of low carbon developments. However, some of these more ‘exotic’ solutions have high fuel costs, compared to traditional technologies or ...


    By ENER-G

  • Green Academy Installs ENER-G Sustainable Technologies

    Kent’s Longfield Academy will harness the natural power of the sun and earth to give the academy full marks for renewable energy performance. The new academy building for 1150 students, due to open in June 2011, is combining ground source heat pumps, which harness solar energy absorbed by the earth, with solar thermal technology to maximise renewable energy efficiency.   By working in ...


    By ENER-G

  • Case study - Green Machine generates power from waste heat at biogas facility in the Czech Republic

    Biogas/Heat-to-Power Application on Two MWM Internal Combustion Engines Site: Brno, Czech Rep. Engine Max Power: 980kWe (currently limited to 900 kWe) Green Machine Gross Power Output Avg:  32-39 kWe Thermal Input to the Green Machine: 375-500kWt Hot Water Input Range: 86 - 92°C Hot Water Flow: 35 m3/hour Ambient Temperature: 0-25°C Date Commissioned: Q2 ...


    By ElectraTherm

  • Green machine generates power from waste heat at biogas facility in the Czech Republic

    Biogas/Heat-to-Power Application on Two MWM Internal Combustion Engines Site: Brno, Czech Rep. Engine Max Power: 980kWe (currently limited to 900 kWe) Green Machine Gross Power Output Avg:  32-39 kWe Thermal Input to the Green Machine: 375-500kWt Hot Water Input Range: 86 - 92°C Hot Water Flow: 35 m3/hour Ambient Temperature: 0-25°C ElectraTherm’s ...


    By ElectraTherm

  • Allweiler Peristaltic Pumps: an ingenious solution for biogas plants

    Installations and plants used to process biomass for the production of biofuels must be capable of handling difficult conditions. For example, intermediate products in the production of biodiesel exhibit a high level of chemical aggressiveness. Accordingly, pumps, pipe connections, and fittings must be capable of resisting these demanding conditions. In addition, waste products usually contain a ...


    By ALLWEILER GmbH

  • Assessing Feasibility of Direct Drive Technology for Energy Recovery from Digester Biogas

    ABSTRACTThe Regional Municipality of Waterloo completed a study, with support from Environment Canada, to evaluate the feasibility of using direct drive technology to recover energy from digester biogas. The study identified that a 150 HP engine, operating at 54 % load, could be supported by the estimated gas production of 1560 m3/d with 63 % methane by volume. ...

  • Energy efficiency: la Compagnie des Fromages counts on innovation with Emerson technologies

    The subsidiary of the Bongrain Group is pursuing a policy to reduce its energy usage and CO2 emissions by investing in a facility designed by Cofely Axima, a leader in industrial refrigeration and a subsidiary of GDF Suez. This solution stands out for its use of a process that heats and cools within a single cycle and its use of key components supplied by the Emerson Group – a Vilter ...

  • Solar-powered Stirling engines: a low-cost possibility for village power, pumping and cooling

    Stirling engines are heat engines that operate on a closed thermodynamic regenerative cycle and are used as power systems, refrigerators or heat pumps. Recent developments in Stirling technology allow the use of low temperature heat sources including flat plate solar collectors. New concepts for low-cost, low ΔT Stirling engines that may be made by village craftsmen using locally available ...


    By Inderscience Publishers

  • Sherwood Energy Village - case study

    Local community project harnesses heat pump technology to build a sustainable future. Sherwood Energy Village (SEV) is a former colliery site in the East Midlands. In 1994 following the colliery’s closure the local community tasked itself with bringing sustainable development into the mainstream. ENER-G’s low cost sustainable heat pump technologies provided the SEV with a local ...


    By ENER-G

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you