heat recovery technology Articles

  • Heat recovery from wastewater

    Heat recovery from gray water is particularly important in water-intensive industries such as pulp and paper plants, dairies and breweries. Rather than flushing used water down the drain, consider whether a heat exchanging system can help you put that energy to work in your process again. Most plant operators arc aware of the need to save money and reduce the environmental impact of their plant ...


    By DDI Heat Exchangers Inc.

  • Heat Recovery for Reuse in Proofing Ovens: Buttercup Bakeries

     By collaborating with a major tertiary research institution, RMIT University, Buttercup Bakeries has been able to apply new heat recovery technology suitable for bakery and other industrial applications. The initiative has resulted not only in cost and energy savings but more efficient oven heating boiler operations. Background Buttercup Bakeries is part of the ...


  • Study of available exhaust gas heat recovery technologies for HD diesel engine applications

    Diesel engines reject a considerable amount of energy to the ambience through the exhaust gas. Significant reduction of engine brake-specific fuel consumption (bsfc) could be attained by recovering a significant part of exhaust gas heat. Various techniques have been proposed in the past to recover exhaust energy: mechanical, electrical turbocompounding and Rankine Bottoming Cycles. In the present ...


    By Inderscience Publishers

  • Heat recovery and energy efficiency, improves profitability and reduces CO footprint

    Using latest technology in combustion of oil and gas can provide significant savings in overall energy consumption. Modern oxygen control that compensates changes in ambient temperature and fuel qualities can increase energy efficiency up to 3%. By adding the usage of hot combustion air another 2-3% can be saved. Modern burner technology without mechanical linkage, operating with accurate ...


    By Oilon Oy

  • Maximum possible efficiency for energy recovery from low-grade heat sources

    Gas-to-gas heat exchangers are increasingly being used to recover low-grade heat (or cooling) to reduce energy requirements for space heating, drying and other applications. The efficiency of heat recovery is often limited by practical considerations which could – in principle – be reduced or eliminated by development of new materials and technology. However, this paper posits a fundamental ...


    By Inderscience Publishers

  • What is energy recovery?

    Processes like incineration and anaerobic digestion not only provide sources of energy, but they also reduce waste volume The term “energy recovery” often is applied only to a narrow number of methods for converting wastes into energy, when in fact it applies to a broad range of technologies used to create heat, electricity, or fuel. Energy recovery gives ...


    By Fluence Corporation

  • Assessing Feasibility of Direct Drive Technology for Energy Recovery from Digester Biogas

    ABSTRACTThe Regional Municipality of Waterloo completed a study, with support from Environment Canada, to evaluate the feasibility of using direct drive technology to recover energy from digester biogas. The study identified that a 150 HP engine, operating at 54 % load, could be supported by the estimated gas production of 1560 m3/d with 63 % methane by volume. ...

  • Energy conservation in aluminium foundries by waste heat recovery from solidifying molten metal

    This paper presents a unique attempt to preheat the raw materials by recovering the waste heat from solidifying molten metal in shape castings of aluminium using sand moulds. Finite element analysis of the problem using ANSYS has also been done, results of which show satisfactory agreement with the experimental results. By using this preheating method, it is proved that around 16% of heat ...


    By Inderscience Publishers

  • Case study - Maximizing heat recovery from your oxidizer and reducing operating costs

    More and more, companies operating air pollution control equipment today realize that the initial capital cost of an oxidizer system can be rapidly eclipsed by continued operating expenses if careful attention is not periodically given to the system. Below are ten tips to ensure your oxidizer is operating at peak performance. The first five tips focus on parameters end-users should know about ...

  • Case study - Oxidizer energy recovery options

    Overview The mainstream media today is full of allusions to energy awareness and conservation. Just as visible these days are media references to astronomical dollar figures that can boggle the mind. This article does not seek to break out of that mold, but rather to conform to it – as Oxidizer Stack Heat Recovery offers a tremendous opportunity for both energy conservation and ...

  • Basin Electric - wind and waste heat

    Location: Waste Heat Recovery projects in Culbertson, MT and Garvin, MN – Wind Projects Located in South Dakota and North Dakota Project Start Dates: 2009 – 2011 Element Markets is helping Chevrolet meet its CO2 reduction goal, and simultaneously helping a large Midwest power cooperative earn revenues needed to support its clean energy projects. This ...


    By Element Markets LLC

  • Combined Heat and Power (CHP) essentials

    'CHP essentials' introduces the concept of power and heat 'production possibility sets', starting at the cradle of CHP, i.e., the thermal power generation plant. The latter always occasions 'fatal' heat that is either recovered (the 'merit' of CHP) or wasted (condensing). This split paves the way to defining the production possibility sets of CHP plants, shown for steam turbines, internal ...


    By Inderscience Publishers

  • First industrial application of an open absorption cycle for heat transformation in a district-heating network

    The first plant for high temperature utilisation of higher heating value was realised under industrial conditions in a combined heat and power plant. The technology results in an increased heat recovery temperature and a stronger dehumidification of the flue gas. Beyond that, the use of large solution flow within an adiabatic absorber enables to combine gas scrubbing and dehumidifying. Economic ...


    By Inderscience Publishers

  • Opening markets for CSP – the industrial heat application

    Heavy industry can be a viable secondary market today for CSP producers, but questions remain on whether start-up costs are justifiable for industrial users, and how reliable CSP can be for processes that can't pace production by the sun. Solar thermal heat implies steam, and industries that need steam include refining, food processing, wood-working, desalination and chemicals, among others. ...


    By FCBI Energy

  • Case-study - Utilising waste heat for water production and climate control

    Water purification is needed to produce high quality water for consumption, agriculture and industrial needs. Conventional water treatment processes, like distillation and reverse osmosis, consume vast amounts of energy. However, there is a large potential for significant reductions in energy consumption and CO2 emissions in this sector. It can be achieved by the exploitation of waste heat for ...


    By Climate-KIC

  • CDQ waste heat boiler for iron and steel industry manufacturer

    Energy use is additionally a major supply of emissions from the iron and steel industry, making energy efficiency improvements a lovely chance to reduce both emissions of pollutants and greenhouse gases. The global steel industry has recently taken the lead on developing future low-carbon iron and steelmaking technologies. Waste heat boiler ...


  • Combined heat & power is a clean, efficient and economic energy solution

    The 21st century has highlighted a need for clean, efficient and economic energy, which has put Combined Heat & Power (CHP) into the limelight. By providing on-site power generation, waste heat recovery and system integration, CHP offers a realistic, near-term solution for exceptional energy efficiency and emission reduction. CHP systems can generate electricity locally while they recover ...


    By Shenton Group

  • Case study - ElectraTherm commissions 10 green machines on district heating system in Europe

    ElectraTherm commissioned 10 Green Machine 4400s in Levice, Slovakia in June 2014. ElectraTherm’s Czech distributor, GB Consulting, facilitated the deployment of Organic Rankine Cycle (ORC) systems on a centralized district heating system in Slovakia as a means of increasing on-site efficiency and generating clean energy. ElectraTherm’s Green Machine generates fuel-free, ...


    By ElectraTherm

  • Are GAS-FIRED Burner Technologies Really The Best Choice for ISTR Cleanups?

    Its an exciting time. In-Situ Thermal Remediation (ISTR) shows great promise and has proven to be an extremely effective method for cleaning a wide range of Contaminants of Concern (COC’s) at contaminated sites. Most recently, gas-fired soil heating technologies are entering the market with promises of much cheaper natural gas heating, faster setup and heating times, less heaters required ...


    By Soil-Therm Equipment, Inc.

  • Making pressurized water scrubbing the ultimate biogas upgrading technology with the DMT Carborex® PWS system.

    Abstract Biogas is one of the most promising energy sources for the future. Biogas is a “waste” product from e.g. landfill sites or digesters that can be applied as a green and renewable energy source with no global emissions on CO2 and hardly no local emissions on other pollutants. Currently most biogas is used at a CHP at which a large part of the energy ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you