recovery boiler Articles

  • Saving waste in the boiler house

    Burner technology has improved greatly in recent years. Older Burners had a series of cams and levers that were calibrated to provide specific amounts of air for a particular rate of firing. Being mechanical items, these wore and sometimes required calibration. They, therefore, had to be regularly serviced and calibrated. Generally, new burners use frequency controlled motors and cams to open air ...


    By EBE Engineering Ltd.

  • What is energy recovery?

    Processes like incineration and anaerobic digestion not only provide sources of energy, but they also reduce waste volume The term “energy recovery” often is applied only to a narrow number of methods for converting wastes into energy, when in fact it applies to a broad range of technologies used to create heat, electricity, or fuel. Energy recovery gives ...


    By Fluence Corporation

  • Frequency Converter energy savings on Boilers

    Boilers and heaters account for a significant share of a plant's purchased fuel cost. Combustion air fans are necessary to provide enough combustion air to the boiler or heater's burner system. Louvers, inlet guide vanes or frequency converters control the amount of air allowed into a boiler. Configuring a combustion air fan to allow the proper amount of air into the burner can improve boiler ...


  • Heat Recovery for Reuse in Proofing Ovens: Buttercup Bakeries

     By collaborating with a major tertiary research institution, RMIT University, Buttercup Bakeries has been able to apply new heat recovery technology suitable for bakery and other industrial applications. The initiative has resulted not only in cost and energy savings but more efficient oven heating boiler operations. Background Buttercup Bakeries is part of the ...


  • Nottingham - Condensing Combi-Boiler case study

    Customer: Mr Tony Goodyear, Heating Engineer Location: Nottingham Heating System: Gas Condensing Combi Boiler installed: 08/07 Problems: New condensing boiler fitted within the past 12 months had failed to rectify noise from pump and problems with air present in ...


    By Vortex Energy Saver

  • Pakistan SZS Gas Fired Steam Boiler

    Heavy Oil, Light Oil, Residual Oil, Natural Gas, City Gas, and Blast Furnace Gas can be used as Fuel. The boilers can also be applied to generate electricity at some districts where electricity power is in short. So are a variety of industrial productions, living and remote areas, and oil field. Even they can be used as a power plant boiler startup. SZS series oil & gas boilers are ...


  • Case study - Oxidizer energy recovery options

    Overview The mainstream media today is full of allusions to energy awareness and conservation. Just as visible these days are media references to astronomical dollar figures that can boggle the mind. This article does not seek to break out of that mold, but rather to conform to it – as Oxidizer Stack Heat Recovery offers a tremendous opportunity for both energy conservation and ...

  • Heat recovery and energy efficiency, improves profitability and reduces CO footprint

    Using latest technology in combustion of oil and gas can provide significant savings in overall energy consumption. Modern oxygen control that compensates changes in ambient temperature and fuel qualities can increase energy efficiency up to 3%. By adding the usage of hot combustion air another 2-3% can be saved. Modern burner technology without mechanical linkage, operating with accurate ...


    By Oilon Oy

  • CDQ waste heat boiler for iron and steel industry manufacturer

    Energy use is additionally a major supply of emissions from the iron and steel industry, making energy efficiency improvements a lovely chance to reduce both emissions of pollutants and greenhouse gases. The global steel industry has recently taken the lead on developing future low-carbon iron and steelmaking technologies. Waste heat boiler ...


  • Assessing Feasibility of Direct Drive Technology for Energy Recovery from Digester Biogas

    ABSTRACTThe Regional Municipality of Waterloo completed a study, with support from Environment Canada, to evaluate the feasibility of using direct drive technology to recover energy from digester biogas. The study identified that a 150 HP engine, operating at 54 % load, could be supported by the estimated gas production of 1560 m3/d with 63 % methane by volume. ...

  • Case study - Waste heat generates steam and savings

    OVERVIEW A coil coating facility purchased a new a 15,000 SCFM Regenerative Thermal Oxidizer (RTO) which had a nominal heat transfer efficiency rate of 90% thermal energy recovery. It was designed with supplemental fuel injection (SFI) which is used during low VOC loading conditions, to help save fuel cost.  The facility was looking for additional ways to decrease their exhaust ...

  • Ottawa Hospital, Ottawa Heart Institute, Ottawa, Ontario, Canada

    Boiler Plant Application Objective The turnkey FLU-ACE waste heat recovery system was installed by Thermal Energy on four boiler exhausts from a power plant which produced a peak (winter) steam rate of 70,000 lbs/h. The system was designed to recover 10 mmBTU/h of otherwise wasted energy. The recovered heat is used to heat the the world-famous University of Ottawa Heart Institute ...

  • Saint-Vincent Hospital, Ottawa, Ontario, Canada

    Boiler/Cogen Heat/Energy Recovery Application Thermal Energy installed designed and implemented an integrated FLU-ACE heat recovery system with cogeneration unit for efficient electrical power generation and an overall reduction in energy consumption. The installation consists of a natural gas fueled engine with a 425 kW generator, waste heat boiler, and FLU-ACE system processing combined flue ...

  • First industrial application of an open absorption cycle for heat transformation in a district-heating network

    The first plant for high temperature utilisation of higher heating value was realised under industrial conditions in a combined heat and power plant. The technology results in an increased heat recovery temperature and a stronger dehumidification of the flue gas. Beyond that, the use of large solution flow within an adiabatic absorber enables to combine gas scrubbing and dehumidifying. Economic ...


    By Inderscience Publishers

  • Thermal Energy International Raises The Bar On Thermal Efficiency At Stand H41 At Energy Solutions Expo

    Thermal Energy International Inc. (TEI) will be exhibiting its range of awarding winning energy efficiency products at stand H41 at the Energy Solutions Expo at Olympia, London on the 11th and 12th October.  TEI’s products include its GEM venturi orifice steam traps and its flue gas condensing heat recovery ...

  • Efficient steam production in paper mills

    The paper and pulp industry is an energy and emission intensive industry. Steam is an essential part of the paper making process with steam boilers, steam distribution systems and other processes accounting for a large percentage of a paper mill’s energy costs. Useful energy is often lost from boilers and process equipment such as heat exchangers, dryers, evaporators etc, as well as from ...

  • Case study - Mission Linen Supply, Santa Barbara, California, USA

    “A number of years ago Sid Abma of Sidel Systems USA Inc. approached us with his Sidel SRU flue gas heat recovery unit. I think that we, like most companies, considered it; but we took no action for some time. Finally a situation developed that made it beneficial for us to try this unit. We purchased a unit and had it installed in July of 2006. A second unit is in the process of being ...


    By Sidel Systems USA Inc.

  • Cogeneration Renovation of Cofely`s Saint Quentin Installation - Case Study

    In 2012, Cofely’s Picardie branch, the site’s exploiter, entrusted the renovation of a cogeneration installation in Saint Quentin, in the Aisne province, to Clarke Energy. Initially, this “boiler room” consisted of a turbine installed in a soundproof enclosure. Cofely could either renovate ...


    By Clarke Energy

  • Eco House, Lanarkshire

    A Gaia-Wind turbine is the principal wind energy source in this eco house in Scotland. The house is all electric, consuming 50% of produced energy, and offsets 16 tonnes of CO2 annually. Average annual energy production: 28,000 kWh Background Mr Taylor is an architect by profession. He designed his own eco house incorporating a Gaia-Wind turbine as the principal wind ...


    By Gaia-Wind Ltd.

  • National brewery benefits from biogas

    Anheuser-Busch has installed anaerobic digestion systems at 10 of its 12 large breweries in the U.S., with an 11th system in design. Primary drivers are cost-avoidance for wastewater treatment fees and fossil fuel purchases. ANHEUSER-BUSCH, owner of 12 large breweries in the U.S., has committed to reduce its greenhouse gas emissions 5 percent from 2005 levels by 2010. The company is well ...


    By BioCycle Magazine

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you