waste heat turbine Articles

  • Thermodynamic analysis of a hybrid gas turbine/thermoacoustic heat pump/refrigeration engine

    Possible performance enhancement of small gas turbine power plants through the application of thermoacoustic systems is examined. The thermoacoustic subsystem is powered only by the waste heat of the gas turbine. Two different gas turbine configurations are considered: a Thermoacoustic refrigerator assisted gas turbine (TRG) and a Combined thermoacoustic heat pump and refrigeration assisted gas ...


    By Inderscience Publishers

  • Marketing Analysis of Low Temperature Waste Heat Boiler

    Environmental pollution brought by the burning of fossil fuels and improper energy use structure have became big problems of boiler manufacturer like ZG. To need the market demand for the development of new energy and renewab ...


  • Turbine condensers for propylene production

    Propylene is one of the most important compounds in the chemical industry. It's primarily used to make the plastic polypropylene, but also in many other processes. A propylene factory in Ningbo, China set Körting Hannover AG an exceptional process-engineering challenge. It appointed the company to design special turbine condensers to produce 600,000 tonnes of propylene per year. The ...


    By Körting Hannover AG

  • Enhancing the dynamic performance of electricity production in steam power plants by the integration of transient waste heat sources into the feed-water pre-heating system

    Since the deregulation of the energy market the enhancement of steam power plant's dynamic performance has become more and more important. Nowadays, peak load is a profitable product at the energy stock markets if it can be provided reliably. This is in contrast to many power plants running constantly at full load. A very promising technique to improve the peak load capability of such power ...


    By Inderscience Publishers

  • Combined Heat and Power (CHP) essentials

    'CHP essentials' introduces the concept of power and heat 'production possibility sets', starting at the cradle of CHP, i.e., the thermal power generation plant. The latter always occasions 'fatal' heat that is either recovered (the 'merit' of CHP) or wasted (condensing). This split paves the way to defining the production possibility sets of CHP plants, shown for steam turbines, internal ...


    By Inderscience Publishers

  • Using biogas for combined heat and power

    An integral part of the majority of anaerobic digestion facilities across the world is the CHP combined heat and power (CHP) engine. For the first time builder of a biogas plant, it is often neglected as the focus is on reducing the capital costs ...


    By Clarke Energy

  • Using biogas for combined heat and power

    An integral part of the majority of anaerobic digestion facilities across the world is the CHP combined heat and power (CHP) engine. For the first time builder of a biogas plant, it is often neglected as the focus is on reducing the capital costs ...


    By Clarke Energy

  • Case study - ElectraTherm commissions 10 green machines on district heating system in Europe

    ElectraTherm commissioned 10 Green Machine 4400s in Levice, Slovakia in June 2014. ElectraTherm’s Czech distributor, GB Consulting, facilitated the deployment of Organic Rankine Cycle (ORC) systems on a centralized district heating system in Slovakia as a means of increasing on-site efficiency and generating clean energy. ElectraTherm’s Green Machine generates fuel-free, ...


    By ElectraTherm

  • High-strength wastes boost biogas production

    Water and wastewater treatment plants (WWTP) are significant consumers of energy. The U.S. Environmental Protection Agency estimates the industry uses the equivalent of 56 billion kilowatt hours (kWh) of electricity, representing three percent of the nation’s energy consumption, and is responsible for creating 45 million tons of greenhouse gas emissions each year. Energy intensive processes, such ...


    By BioCycle Magazine

  • The effect of precooling inlet air on CHP efficiency in natural gas pressure reduction stations

    Almost all pressure reduction stations in Iran use expansion valves to reduce the natural gas pressure, which leads to wasting large amount of exergy. In this paper, a system is proposed which includes the modification of a conventional pressure reduction station with the addition of a turbo expander and a gas turbine for power recovery and generation. The next step is investigating the effect of ...


    By Inderscience Publishers

  • Exergy analysis of a syngas fuelled cogeneration cycle for combined production of power and refrigeration

    This communication presents a biomass fuelled cogeneration cycle for the combined production of power and refrigeration. The system is an integration of combined gas–steam cycle and absorption refrigeration cycle. A thermodynamic analysis through energy and exergy is employed, to investigate the effects of cycle pressure ratio, gas turbine inlet temperature and evaporator temperature on first–law ...


    By Inderscience Publishers

  • Performance enhancement of GT–ST power plant with inlet air cooling using lithium bromide/water vapour absorption refrigeration system

    Performance improvement techniques in power generation systems especially in gas turbine–steam turbine (GT–ST) combined cycle (CC) power plants by compressor inlet air cooling prove to be much improvising. In this work, the performance enhancement of CC power plant by inlet air cooling method using lithium bromide–water (LiBr/H2O) absorption refrigeration ...


    By Inderscience Publishers

  • Clean energy: How much hot air?

    NewScientist’s January 28 issue is likely to unsettle clean energy advocates – but it is worth the read. The cover article, “Power paradox: Clean might not be green forever,” posits that even renewable energy can warm the planet, and eventually change ...

  • Pushing the Limits of Reengineering

    Cutting-edge turbine technology enables more efficient and cleaner power generation. However, the service of advanced gas turbines is challenging—especially when parts need to be replaced. The example of a blade replacement project shows how Sulzer establishes innovative reengineering processes and contributes to a secure energy supply that causes less carbon emission. A Sulzer ...


    By Sulzer Management Ltd

  • Performance enhancement of GT-ST power plant with inlet air cooling using lithium bromide/water vapour absorption refrigeration system

    Performance improvement techniques in power generation systems especially in gas turbine-steam turbine (GT-ST) combined cycle (CC) power plants by compressor inlet air cooling prove to be much improvising. In this work, the performance enhancement of CC power plant by inlet air cooling method using lithium bromide-water (LiBr/H2O) absorption refrigeration system powered by waste heat from heat ...


    By Inderscience Publishers

  • Continuous biogas monitoring with AEMS in South Korea

    Application Biogas research projects Equipment AEMS biogas analyser Location South Korea Customer KEPCO Research Institute Requirement The customer ...

  • What is Cogeneration?

    Cogeneration is the process of generating both electrical and heat energy from a single fuel source.  Also known as Combined Heat & Power (CHP), cogeneration makes use of the commonly discarded thermal energy which is generated from the combustion of fuels such as diesel, natural gas, bi-fuel, and even  ...

  • Wood briquettes packed full of energy

    Konolt manages its energy output using RUF briquetting machinery Timber processors Konold are improving their energy balance with the help of their RUF briquetting machine. Wood waste is being pressed into briquettes to create a uniform combustible material. The heat they produce is then used for process heating and to heat their premises, with the residual heat being used to generate ...

  • Los Angeles County Sanitation Districts: Siloxane Removal

    Los Angeles County Sanitation Districts have long been involved with recovering landfill and digester gas for energy to power turbines and internal combustion engines. Their experience led them to identify performance issues associated with these gases. One particular challenge is siloxanes. Cyclic organic silicon monomers (siloxanes) used in the manufacture of personal hygiene, health care and ...


    By Pioneer Air Systems

  • What`s New? Biogas Power

    Technologies that connect the biogas line to the power line include cooling and clean up components, microturbines and reciprocating gas engines and control systems. TOP BILLING on the biogas to electricity stage typically goes to the microturbines and reciprocating gas engines. But in the theater of renewable energy from organics recycling, the show can’t go on without the supporting cast of gas ...


    By BioCycle Magazine

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you