Biogas Combustion Equipment For Bioenergy In Europe
-
PremiumManufactured by HRS Heat Exchangers Ltd.based in UNITED KINGDOM
The HRS Biogas Dehumidification System (BDS) removes water from biogas, protecting combined heat and power (CHP) engines from corrosion and cavitation. It can be supplied with a heat recovery section, increasing the overall efficiency of anaerobic digestion (AD) ...
-
Manufactured by Zorg Biogas GmbHbased in GERMANY
Single stage biogas compressor with single impeller and a maximum capacity 782 m³/h. It is used to transport biogas and other gases from tanks, gasholders to biogas burners and cogeneration units (CHP). The 15 kW electric motor is connected via a flexible coupling. Horizontal ...
-
Manufactured by PBS Power Equipment, s.r.o.based in CZECH REPUBLIC
The PBS POWER EQUIPMENT, s.r.o. manufactures, installs and services atmospheric NTF type Flares used for combustion of residual biogas (resp. other combustible gas) mainly in cases of emergency stops of main consumers (cogeneration ...
-
Manufactured by Hydrotech a.sbased in SLOVAKIA
The by-product of anaerobic treatment is a high-energy biogas which can be combusted in its own boiler room or possibly fed to the central boiler in the ...
-
Manufactured by SUEZ Water Technologies and Solutionsbased in USA
Designed to recycle biosolids into methane and valuable byproducts, SUEZ’s advanced anaerobic digestion technologies use bacteria in the absence of oxygen to break down matter to create biogas. The biogas can be combusted or oxidized and used for heating or with a CHP engine to produce electricity and heat; it can also be compressed and used as fuel for vehicles with the cake produced, used ...
-
Manufactured by Conveco Srlbased in ITALY
The T flare is a self-supported elevated flare (open type) complete with a safety ladder and an upper platform that allow access to the nozzle and ignition and flame control equipment. The flame shield is designed to prevent accidental flame extinguishing and provides a chamber lined with fiberceramic for more complete biogas combustion. The flare stack is designed as package unit and is ...
-
based in THAILAND
Biogas can be used as fuel in electrical power generators (gensets), consisting of a standard diesel engine modified for biogas use, and an alternator. Such electrical power generators are on the market in various capacities from small units of less then 100 kW all the way up to 1700 ...
-
Manufactured by Conveco S.r.l.based in ITALY
This is the simplest and most economical solution for burning landfill biogas safely and when gas combustion emissions are not subject to specific regulations. It is connected to the delivery network for biogas from capture wells and is also fitted with an inlet condensate separator-discharge ...
-
Manufactured by Microgen Engine Corporation Groupbased in NETHERLANDS
This burner takes into account the specifics of burning biogas or woodgas. In combination with a biofuel heat acceptor it can comfortably handle the specifics of varying calorific values, burning of particles etc. It is used more frequently in remote areas where there is no electricity and where available local fuel can be ...
-
Manufactured by Aktek Technology Engineering Co. Ltdbased in TURKEY
The AKTEK Model 8391B Waste Gas Burner includes an ignition system with all of the best features available in a waste gas burner. The burner wind shield contains the unique 'downdraft prevention' with a bevel design which virtually eliminates the possibility of the flame being blown out. The design also provides the proper air/fuel mixture to ensure an efficient burn. The wind shield will control ...
-
Manufactured by Conveco S.r.l.based in ITALY
High efficiency, compact biogas suction and combustion unit mounted on a frame. Compact design and easy installation allow use in emergency situations, for temporary installations or to check the production capacity of the ...
-
Manufactured by Bilgeri EnvironTec GmbHbased in AUSTRIA
The FAII biogas flare is an automatic, enclosed gas flare for combustion of biogas and other combustible gases, fully complying with the widely applied German air pollution regulation TA Luft. +500 references in more than 50 countries witness the robustness of our FAII flares! Available in a rage of 20 - 3.000 Nm3/h, at various pressures. Highly customizable for very particular project ...
-
based in THAILAND
Based on more than 30 years of practical experience with biogas use as fuel, GWE can offer burners and boiler modifications to utilize the produced biogas in single and multiple fuel arrangements. GWE has supplied and commissioned biogas utilization systems in steam boilers, water heaters, thermal oil boilers, and direct-fired driers, and in combination with a very large variety of other fuels ...
-
Manufactured by Bilgeri EnvironTec GmbHbased in AUSTRIA
The FAI is an open-combustion flare, which can be configured in manual ignition as standard. Optionally, the FAI can be updated to Automatic mode, before or after* purchasing. That makes the New FAI the best and most cost-effective option for locations where no automatic flare is mandatory and open combustion is allowed! Available up to 500 Nm3/h, from 2,5 to 20 ...
-
Manufactured by Innovaterm S.r.l.based in ITALY
The activities of cogeneration obtained by biogas combustion (from landfill or from farm)produces tons of exhaust gas with residues that have to be treated ...
-
Manufactured by Hydroflux Pty Ltdbased in AUSTRALIA
FlareWell® waste gas burners form part the anaerobic digestion process. FlareWell is designed to burn gas from the digestion process in excess of the gas necessary for the sludge heating system. The burner is automatic in operation and uses digester gas and/or LPG for pilot ...
-
Manufactured by Gastreatment Services (GTS)based in NETHERLANDS
Most often they try to utilize biogas in various applications such as (bio) gas engines for the production of electricity and heat (CHP), hot water / steam boilers for supplying heat to business processes, biogas processing plants that process the biogas into green gas that is suitable for injection into the natural gas network or for upgrading to liquid biogas (LBG), as a fuel for buses and ...
-
based in THAILAND
Biogas is coming out of the anaerobic digesters saturated with water vapor. At the usual digester temperature of mesophilic anaerobic digesters of around 30°C, this means that the biogas contains about 5% water, or about 50 g/Nm³ biogas. If the temperature of the biogas subsequently drops, some of that water will condense into a ...
-
Manufactured by Biogas Systems ABbased in SWEDEN
The compressed intake air and biogas are ignited in the combustion chamber. The gases then pass through the turbine at high pressure and drive the generator. A turbine installation consists of a complete turbine assembly with gas compressor and monitoring equipment, with or without a heat exchanger for producing hot water. Biogas Systems AB supplies gas turbines with a generation capacity of 100 ...
-
Manufactured by Conveco S.r.l.based in ITALY
Biogas analysis is an extremely useful process control and helps optimize digester operation and maximize methane production. Moreover, during plant start-up stages it can be used to verify the attainment of expected performances. CONVECO supplies include portable instruments and automatic continuous sampling and analysis panels calculating percentages of methane (CH4), oxygen (O2), carbon ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you