Only show results available in Virginia? Ok

Biogas Flares equipment for Bioenergy

  • Premium

    BIOPAQ - Biogas Flare

    The BIOPAQ Biogas Flare combines a sturdy quality with a unique compact design aimed at simplicity. This means that methane-rich biogas of a low pre-pressure can be discharged safely and reliably without involving failure-prone rotating equipment such as ventilators or control valves.

    By Paques B.V. based in EL Balk, NETHERLANDS.

  • Model FA II - Closed-combustion Automatic Biogas Flare

    The FAII biogas flare is an automatic, enclosed gas flare for combustion of biogas and other combustible gases, fully complying with the widely applied German air pollution regulation TA Luft.+500 references in more than 50 countries witness the robustness of our FAII flares!Available in a rage of 20 - 3.000 Nm3/h, at various pressures.Highly ...

    By Bilgeri EnvironTec GmbH based in Nüziders, AUSTRIA. from Biogas Flares Product line

  • ennox - Model ECO - Manual Gas Flare

    THE robust and maintenance free flare suitable for small biogas systems, special installations or when an automatic gas flare is not specified. The ECO flare is manufactured entirely from stainless steel and equipped with high quality components (i.e., ATEX certified flashback prevention, DVGW certified manual flap...).

    By ennox biogas technology GmbH based in Hard, AUSTRIA. from Gas Flare Product line

  • Biogas Flares / Sludge Gas Flares

    The LAMBDA biogas and sludge gas flare serves as an inspection and safety device at biogas and sludge gas plants for the thermal treatment of excess gas. Since the continuous process of gas production in these plants can only be influenced to a slight extent in the event of a failure of the utilisation plant, the LAMBDA flare safely disposes of ...

    By LAMBDA Gesellschaft für Gastechnik mbH based in Herten, GERMANY.

  • Elevated Biogas Flares

    Flare for a capacatiy from 50 Nm3/h to 6.000 Nm3/h. Minimum methane concentration as low as 45% without pilot gas. No pilot gas needed.Low pressure, flow direct from reactor, no blower needed. Weather proof ignition system. 10 years waranty on body. 2 years on electronics and ignition system at normal use.

    By DWS bvba based in Wijnegem, BELGIUM. from Biogas Flares Product line

  • Temperature Control Ground Flares

    Flare for a capacatiy from 50 Nm3/h to 2000 Nm3/h. Temperature controled combustion to fulfill the CDM requirements. Minimum methane concentration as low as 20%, also for landfill. Pilot gas on biogas. Low pressure, flow direct from reactor, no blower needed. Weather proof ignition system. 10 years waranty on body. 2 years on electronics and ...

    By DWS bvba based in Wijnegem, BELGIUM. from Biogas Flares Product line

  • Model HT - High Temperature Gas Flare

    The HT series flares are designed to offer a combustion temperature above 1000 °C and residency time longer than 0,3 s. This is to comply with the widely-applied German norm TA-Luft, in those case in which the flare is not just an emergency element, as well as in case of landfills and other complex and special gases.The HT features heat-resistant ...

    By Bilgeri EnvironTec GmbH based in Nüziders, AUSTRIA. from Biogas Flares Product line

  • Model FA I - Manual / Automatic Open-Combustion Biogas Flare

    The FAI is an open-combustion flare, which can be configured in manual ignition as standard. Optionally, the FAI can be updated to Automatic mode, before or after* purchasing. That makes the New FAI the best and most cost-effective option for locations where no automatic flare is mandatory and open combustion is allowed!Available up to 500 Nm3/h, ...

    By Bilgeri EnvironTec GmbH based in Nüziders, AUSTRIA. from Biogas Flares Product line

  • Biogasmart - Model ST - Elevated Biogas Flare Stack

    The T flare is a self-supported elevated flare (open type) complete with a safety ladder and an upper platform that allow access to the nozzle and ignition and flame control equipment. The flame shield is designed to prevent accidental flame extinguishing and provides a chamber lined with fiberceramic for more complete biogas combustion.

    By Biogasmart based in Gadesco Pieve Delmona, ITALY. from Combustion Product line

  • John Zink - Clean Flare Systems

    Solving complex problems for global industries is nothing new for John Zink. Over the years, we’ve led the advancement of flare design and clean flare technologies for upstream, downstream, and biogas flare industries, transforming yesterday’s fired equipment into sophisticated, low-emissions systems.

    By John Zink Company, LLC based in Tulsa, OKLAHOMA (USA). from Refining Product line

  • Conveco - Static Biogas Flare Combustion

    Static biogas flare combustion is indicated when reclaiming old landfills or to ensure the safety of new landfill where biogas production capacity is limited because of low waste disposal levels of and where electricity is not for to drive various items of equipment.

    By Conveco S.r.l. based in Brescia, ITALY.

  • Biogasmart - Model HE-Type - High Efficiency Biogas Flare Stack

    HE-Type is an enclosed ground flare; combustion takes place within a cylindrical chamber lined with fiberceramic and this causes a higher destruction efficiency of the biogas in comparison to open flares. Enclosed combustion also makes flame and noise less perceptible and for this reason these flares are normally selected for installation in ...

    By Biogasmart based in Gadesco Pieve Delmona, ITALY. from Combustion Product line

  • Biogas Flare

    If biogas can’t get stored or removed by CHP cause of maintenance or stoppages, it should get burnt for environ- mental reasons. This can be done by biogas flares. Manually steared flares has to be started and stopped by stuff and are often powered by a 12V lead-acid battery. Fully automatic flares are starting, if there is too much gas- ...

    By BioBG GmbH based in Westerstede, GERMANY. from Biogas Upgrading Product line

  • No Temperature Control Ground Biogas Flares

    Flare for a capacatiy from 50 Nm3/h to 2000 Nm3/h. Minimum methane concentration as low as 20%, also for landfill. Pilot gas on biogas. Low pressure, flow direct from reactor, no blower needed. Weather proof ignition system. 10 years waranty on body. 2 years on electronics and ignition system at normal use.

    By DWS bvba based in Wijnegem, BELGIUM. from Biogas Flares Product line

  • Gas Flare

    For the start-up operation and in the case of maintenance or fault-related shutdown of the combustion engine or other failures, the gas flare has to safely burn up all the produced gas. The gas flare is a safety-related component for the whole system. It is connected to the gas pipe and turns on automatically, if the permitted pressure or maximum ...

    By MWK-Biogasanlagen Rosenheim GmbH based in Rosenheim, FRANCE. from Technical Equipment Product line

  • PBS - Model APH-M Series - Residual Biogas Burner – FLARE

    Automatic gas burners of the series APH-M guarantee the burning, while burning low-pressure and medium-pressure propane, propane-butane, biogas, sewage and degasation gas. Burners comply with technical requirements ČSN EN 676, ČSN 07 5801; consequently, they can be used for broad spectrum of burning and technological equipment. ...

    By PBS POWER EQUIPMENT, s.r.o. based in Trebíc, CZECH REPUBLIC. from Other Products Product line

  • Flare Systems

    SOLVING COMPLEX PROBLEMS for global industries is nothing new for John Zink Hamworthy Combustion.  Over the years, we’ve led the advancement of flare design and clean flare technologies for upstream, downstream, and biogas flare industries, transforming yesterday’s fired equipment into sophisticated, low-emissions systems.

    By The John Zink Institute based in Tulsa, OKLAHOMA (USA).

  • Model EMR - Biogas Flare Stacks

    EMR flare is a simple safety device typically installed in biomass plants where there are no specific restrictions relevant to fumes exhaust height, minimum combustion temperature, and a partially visible flame is accepted. All the equipment is fitted on-board, contained in a stainless steel frame which simple design and small footprint allow for ...

    By Progeco srl based in Brescia (BS), ITALY. from Biogas Flare Stacks Product line

  • HOFGAS - Model IFL4c - Customised Biogas Gas Flaring System

    Customised HOFGAS-IFL4c biogas gas flaring system is deployed when express regulations on gas emission must be observed. Because of no visible flame, erection of the gas flare is most advantageous even near residential areas. The system is simple to operate and adjust, and starts reliably. The high temperature flare for biogas comes with the ...

    By Hofstetter BV based in Schiphol-Rijk, NETHERLANDS. from Biogas Product line

  • Model HE - Enclosed Ground Flare

    HE-Type is an enclosed ground flare; combustion takes place within a cylindrical chamber lined with fiberceramic and this causes a higher destruction efficiency of the biogas in comparison to open flares. Enclosed combustion also makes flame and noise less perceptible and for this reason these flares are normally selected for installation in ...

    By Progeco srl based in Brescia (BS), ITALY. from Biogas Flare Stacks Product line

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you