Only show results available in Virginia? Ok

Biogas Regulations equipment for Bioenergy

  • Premium

    AERZEN - Model Series VMX - Oil-Injected Screw Compressor for Bio- and Processgas

    The biogas compressor series VMX is an oil-injected screw compressor in 5 sizes for volume flows up to 3080 m³/h and 13 bar overpressure. It  is suitable for boosting the intake pressure of treatment plants for biogas (BGTP) or as an essential part of biogas injection plants (BGIP) for the compression of biomethane to inject into gas grids. The ...

    By Aerzener Maschinenfabrik GmbH based in Aerzen, GERMANY. from AERZEN Screw Compressors Product line

  • Premium

    Model FA I - Manual / Automatic Open-Combustion Biogas Flare

    The FAI is an open-combustion flare, which can be configured in manual ignition as standard. Optionally, the FAI can be updated to Automatic mode, before or after* purchasing. That makes the New FAI the best and most cost-effective option for locations where no automatic flare is mandatory and open combustion is allowed!Available up to 500 Nm3/h, ...

    By Bilgeri EnvironTec GmbH based in Fussach, AUSTRIA. from Biogas Flares Product line

  • Premium

    DMT Sulfurex - Model CR - Chemical Gas Desulphurisation

    Standard system for removal of H₂S out of biogas. DMT has developed the DMT Sulfurex gas desulphurisation scrubber. The DMT-Sulfurex desulphurisation process has proven to be cost effective for smaller applications (see references) due to its low capital and running costs, whereas traditional gas desulphurisation systems are ...

    By DMT Environmental Technology BV based in Joure (NL), NETHERLANDS. from Biogas Desulphurisation Product line

  • Premium

    Model HT - High Temperature Gas Flare

    The HT series flares are designed to offer a combustion temperature above 1000 °C and residency time longer than 0,3 s. This is to comply with the widely-applied German norm TA-Luft, in those case in which the flare is not just an emergency element, as well as in case of landfills and other complex and special gases.The HT features heat-resistant ...

    By Bilgeri EnvironTec GmbH based in Fussach, AUSTRIA. from Biogas Flares Product line

  • Premium

    Model FA II - Closed-combustion Automatic Biogas Flare

    The FAII biogas flare is an automatic, enclosed gas flare for combustion of biogas and other combustible gases, fully complying with the widely applied German air pollution regulation TA Luft.+500 references in more than 50 countries witness the robustness of our FAII flares!Available in a rage of 20 - 3.000 Nm3/h, at various pressures.Highly ...

    By Bilgeri EnvironTec GmbH based in Fussach, AUSTRIA. from Biogas Flares Product line

  • Premium

    Shand & Jurs Biogas - Model 97200 - Flame Check

    The Shand & Jurs Biogas 97200 Flame Check provides an in-line barrier against flame flashback in small gas lines. They are typically installed in pilot lines supplying fuel burning devices used in flares and waste gas burners. They are also used in vent piping servicing manometer pressure taps and diaphragm regulators.

    By Shand & Jurs (L&J Technologies & L&J Engineering) based in Hillside, ILLINOIS (USA). from Waste Gas Burners and Flares Product line

  • Premium

    Model BDS - Biological Desulphurization System

    Biogas always contains hydrogen sulphide (H2S). Usually, it moves in the range of 1,000 to 6.000ppm, but it can also reach 2% by volume or more. Often this H2S must be removed from the gas, either because of environmental protection reasons or because corrosion danger. The EnvironTec's desulphurization process provides a cost- effective yet highly ...

    By Bilgeri EnvironTec GmbH based in Fussach, AUSTRIA. from Biogas Treatment / Biogas Conditioning Product line

  • Biogas Bags

    Biogas Bags are designed according to local requirements and the individual needs of our customers. Preferably, designs are cylindrical with spherical sections at both ends. The installation of this unpressurized system is always in a building, which can absorb the loads. Biogas bags can be fitted with a safety valve and a filling level ...

    By Tecon – textile constructions GmbH based in Ilz, AUSTRIA. from Gasholders Product line

  • Temperature Control Ground Flares

    Flare for a capacatiy from 50 Nm3/h to 2000 Nm3/h. Temperature controled combustion to fulfill the CDM requirements. Minimum methane concentration as low as 20%, also for landfill. Pilot gas on biogas. Low pressure, flow direct from reactor, no blower needed. Weather proof ignition system. 10 years waranty on body. 2 years on electronics and ...

    By DWS bvba based in Wijnegem, BELGIUM. from Biogas Flares Product line

  • Elevated Biogas Flares

    Flare for a capacatiy from 50 Nm3/h to 6.000 Nm3/h. Minimum methane concentration as low as 45% without pilot gas. No pilot gas needed.Low pressure, flow direct from reactor, no blower needed. Weather proof ignition system. 10 years waranty on body. 2 years on electronics and ignition system at normal use.

    By DWS bvba based in Wijnegem, BELGIUM. from Biogas Flares Product line

  • TECON - Standard Biogas Storage Systems

    The TECON Standard Biogas Storage System is installed on a concrete foundation and consists of an outer, an inner, and a bottom membrane. The actual biogas storage volume is in between the inner and the bottom membrane. The air blower provides the air pressure in between the inner and the outer membrane. The air and operating pressure is kept ...

    By Tecon – textile constructions GmbH based in Ilz, AUSTRIA. from Gasholders Product line

  • CALORIX - Biogas Reuse For Wastewater Heating

    GWE’s direct fire wastewater heater unit, CALORIX, is a new development for efficient wastewater heating without the use of heat exchangers.

    By Global Water Engineering (GWE) based in Bangkok, THAILAND. from Biogas Production & Reuse, Green Power Product line

  • Biogas Mounting

    After ascertaining the optimum location for your biogas plant regarding grid connection and in consideration of the economic use of the local resources, the building phase can be started once the energy provider has consented to our assessment of the best feed-in point to the grid.

    By M. Münch Elektrotechnik GmbH & Co. KG based in Weißenbrunn, GERMANY.

  • Biogas Cooling- Drying Plants

    Various sizes, able to get integrated in all systems, low operating costs (Because of integrated reheating), suited for outdoor installation, insulated standard, various sizes ( 25-2000m³/h ), integratable into all systems, quick change system incl. Non-Stop-Operation, low operating costs through maximum, utilization of activated carbon, ...

    By BioBG GmbH based in Westerstede, GERMANY. from Biogas Upgrading Product line

  • Model HT-S - Enclosed Ground Flare

    HT-S Type are high-performance enclosed ground flare stacks where biogas combustion temperature, flame retention time and destruction efficiency are the results to be achieved. Combustion occurs inside the base refractory combustion chamber and is completed in the upper cylindrical chamber lined with fiberceramic, under a controlled environment. ...

    By Progeco srl based in Brescia (BS), ITALY. from Biogas Flare Stacks Product line

  • Biogas Collection Covers

    IEC provides a complete line of gas collection covers for both ponds and tanks. Each cover system is designed with a gas-tight perimeter anchoring design, whereas gases are continuously removed and channeled to perimeter piping where it exits the basin to be flared or used as fuel. Rainwater trenches are created by strategically placing ballast ...

    By Industrial & Environmental Concepts, Inc. (IEC) based in Lakeville, MINNESOTA (USA). from Other Products Product line

  • Conveco - Static Biogas Flare Combustion

    Static biogas flare combustion is indicated when reclaiming old landfills or to ensure the safety of new landfill where biogas production capacity is limited because of low waste disposal levels of and where electricity is not for to drive various items of equipment.

    By Conveco S.r.l. based in Brescia, ITALY.

  • Model 5000 - Membrane Gas Holder

    Raw material from the international standard verified factories. We have experienced workers and whole membrane machining lines and strict product quality control process. Single holder Size can be customized from 2m³to 10000m³. Type can be semi-ball or cubic. We provide whole accessories from flange, gas pressure controller system, ...

    By Boselan Tanks Co., Ltd (BSL) based in Shijiazhuang, CHINA. from Biogas Holder Product line

  • Model UTB - Scrubber Units

    Scrubber units UTB are the basic option for removal of biogas typical contaminants like hydrogen sulphyde (H2S) and are characterized by simple design and operation. Biogas is washed with a water-NaOH solution. In order to achieve a high purification efficiency, the washing solution and biogas are kept mixed as long as possible: in the first stage ...

    By Progeco srl based in Brescia (BS), ITALY. from Biogas Desulphurization Product line

  • Model 675 Series - Turbo Gas Booster

    This range of quiet running Turbo gas boosters are available in 1, 2, 3, 4 and 5 stage forms and have been developed to run continuously under full load conditions delivering a wide variety of gases at reasonably high pressures. The shaft is sealed to isolate the bearings when boosting landfill or biogas. Standard machines have aluminium housing, ...

    By Utile Engineering Co. Ltd. based in Northants, UNITED KINGDOM. from Gas Burners Product line

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you