Heat and Power Applications
-
CHP Cogenerator Unit for Residential and Office Buildings
ENERGIN CHP cogenerators can provide heat and power to office buildings, residential buildings or hospitals. By achieving overall efficiencies of up to 92% they can save prime energy and thereby reduce CO2 emissions. Due to the compact, plug and play design of all ENERGIN products they can be installed easily by only taking limited space. Because of the low noise emissions, when equipped with sound enclosure, they dont disturb ...
By R Schmitt Enertec GmbH based in Mendig, GERMANY.
-
Compressors for Gas Turbine Power Plants
In gas-turbine power plants, flammable gases are used to drive turbines. These turbines are in turn connected to generators which actually produce the electricity. In gas and steam combination power plants, the heat generated by the gas turbines is also used to produce steam for the steam turbines. Small gas power plants (socalled combined heat and power plants) use an internal combustion engine instead of a turbine to drive the generator. These combined heat and power plants are frequently used in order to cover ...
By J.P. Sauer & Sohn Maschinenbau GmbH based in Kiel, GERMANY.
-
Biogas and Biomethane Plants
Biogas installations can make an important contribution to the reduction of climate-damaging greenhouse gas emissions – and while doing so a 2G combined heat and power system creates attractive business models and perspectives. ...
By 2G Energy AG based in Heek, GERMANY.
-
Organic Rankine Cycle (ORC) Systems for Waste Heat Recovery
Turboden ORC units can produce electricity by recovering heat from industrial processes and in combined cycles with reciprocating engines and gas turbines. The power of Turboden turbo generators in this application generally ranges up to 20 MW electric per single ...
By Turboden S.p.A based in Brescia, ITALY.
-
Spilling Equipment for Heat and Waste Power Industry
A typical application field for Spilling steam engines and steam turbines is the recycling of exhaust heat, waste and lean gases to generate mechanical and electrical ...
By Spilling Energie Systeme GmbH based in Hamburg, GERMANY.
-
Continuous Gas Analyzer for Combined Heat and Power Unit or Block-Type Thermal Power Station
The power units use the energy of fuel in two ways. The fuel which is burned in a motor, as the mechanical energy, is used to generate electricity. The heat is used for heating purposes. The result is high efficiency, 80-90% of the fuels primary energy are used. In cogeneration units the plug end of the fuel energy is used particularly efficiently. The fuel is burned in a motor, the mechanical energy is used to generate electricity. At the same time the by-product heat is also used for heating ...
By Agimas UG based in Frankfurt, GERMANY.
-
RDF
RDF (Refuse Derived Fuel) is made from domestic waste which includes biodegradable material as well as plastics, and has a lower calorific value than SRF (Solid Recovered Fuel). RDF (Refuse Derived Fuel) is used in combined heat and power facilities, many of them in Europe where they produce electricity and hot water for communal heating systems in the local area. Compared to landfilling, the lower carbon emissions resulting from RDF manufacture outweigh the emissions associated with transporting the ...
By M&K Group based in Galbally, IRELAND.
-
Butterfly Valve for District Heating
In thermal power plants, the combustion of fossil fuels or biomass water is converted into hot steam at up to ...
By Quadax Valves, Inc. - a Daughter Company of Müller Coax Ag based in Bristol, PENNSYLVANIA (USA).
-
Cocoa shells making steam for bean processing
Cocoa processing plants are often located in remote areas with little or no access to fossil fuels. The cocoa shells represent up to 10 % of the processing capacity of a typical plant, and often have no market value. VYNCKE offers combustion systems to convert the cocoa shells into a reliable supply of steam for the sterilization, roasting and grinding process. Our systems effectively address the challenges of cocoa shells as a boiler fuel, and even allow co-generation (combined heat and power ...
By VYNCKE based in Harelbeke, BELGIUM.
-
Industrial butterfly valve solutions for power generation sector
The power generation sector is an essential service industry that uses technologies ranging from the mature steam turbine to pioneering marine current turbines. Since privatisation in the UK in 1990, the main objective of the sector has been profitability for shareholders, although issues such as health, safety, sustainability and fuel poverty have also become increasingly important on the corporate agenda. ...
By Hobbs Valve based in Caerphilly, UNITED KINGDOM.
-
Spilling Equipment for Biomass Power Industry
Spilling steam engines and steam turbines have proven themselves as prime movers for smaller and medium-sized biomass power generation plants in industry and regional power supply. They are preferably operated as combined heat and power ...
By Spilling Energie Systeme GmbH based in Hamburg, GERMANY.
-
Organic Rankine Cycle (ORC) Systems for Geothermal
The ORC technology is particularly suitable for the exploitation of medium-to-low enthalpy sources. It is a cost-effective solution with power outputs reaching up to 40 MWe per single generator for sources with water temperature from 100°C to 200°C or ...
By Turboden S.p.A based in Brescia, ITALY.
-
Heat Recovery and Waste to Energy Solutions for Oil and Gas
Within the intricate network of oil and gas collection and distribution processes, waste heat is an inherent byproduct from compression/pumping stations to flares. Rather than letting this valuable energy escape into the environment, we specialize in identifying strategic points in your operations where we can turn this waste heat into a productive ...
By Clean Energy Technologies, Inc. based in Irvine, CALIFORNIA (USA).
-
Data Centers
The steady growth of the global data flow entails an increase in demands on servers and data centers. It is always the same magic formula: maximum performance at maximum reliability. Such a requirement profile is inevitably linked to a massive energy demand: Besides the electric energy that is required in different places to operate the servers, the constant cooling of the infrastructure has a severe impact. This impact is aggravated by the globally increasing energy prices. There is another factor: Our ...
By 2G Energy AG based in Heek, GERMANY.
-
Hydrogen for Industrial Use
Hydrogen is used in the industry sector as a feedstock, for off-grid power generation, and to provide intermediate to high-temperature heat for various processes. According to the Hydrogen Council*, more than 90% of the hydrogen currently produced globally is used as feedstocks in the oil industry and to produce ammonia and ...
By Norwegian Hydrogen AS based in Ålesund, NORWAY.
-
CHP Unit for Schools and Universities
Schools and universities are buildings with high energy consumption. For this reason, TEDOM CHP units can commonly be found in these types of facilities - the CHP units are used to supply power, heat and ...
By Tedom a.s. based in Výcapy, CZECH REPUBLIC.
-
Organic Rankine Cycle Systems (ORC) for Heating Plants
If you have an exisiting heating plant with a hot water or steam boiler we can upgrade your plant to a combined heat and power plant. With your own electricity production you reduce your energy bills and contribute to a greener and more weather-independent energy system. For examples of our installations, please see ...
By Againity AB based in Norrköping, SWEDEN.
-
Bioenergy and Renewable Natural Gas for Utilities
Everyone – from Governors to CEOs, ratepayers to shareholders – are demanding renewable energy solutions to curtail reliance on fossil fuels, reduce GHG emissions and insure local zero waste solutions. Throughout the United States, public power generators, governmental bodies, and energy cooperatives are being asked to supply their customers, communities and constituents with truly clean, truly sustainable and truly renewable natural gas. That’s why the use of anaerobic digestion is an answer ...
By Bioenergy Devco based in Annapolis, MARYLAND (USA).
-
Vacuum and heat transfer technology solutions for power & energy industry
Graham is a provider of products and services to the power generating industry including Steam Surface Condensers, Steam Jet Ejectors and Liquid Ring Pump Systems to support turbine generator operation for various applications. Waste to energy, including biomass, municipal solid waste, landfill methane and others sources are used to produce electric power. Operation of many cogeneration, nuclear, geothermal, combined heat and power and combined cycle power generating facilities run on Graham ...
By Graham Corporation based in Batavia, NEW YORK (USA).
-
Energy Solution for Solving Grid Constraints
Grid constraints are limitations placed on the national grid system, due to factors such as limited authorised transmission capacity, generation, transmission line outages, load variations coupled with insufficient resilience, market issues, environmental regulations or incorrect ...
By EMSc (UK) Ltd based in Sheffield, UNITED KINGDOM.
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you