AEREON Energy Management Equipment In USA
-
Manufactured by AEREON, part of Cimarron groupbased in USA
The dynamic (velocity) seal is a simple innovation which ensures significant cost savings over time. The reverse conical baffle design reduces flow area in the flare tip while simultaneously increasing purge gas velocity. In combination with the dynamic seal, a constant flow of purge gas will maintain a seal in flare system, ensuring that air infiltration does not occur. A vortex effect is ...
-
Manufactured by AEREON, part of Cimarron groupbased in USA
AEREON's Inferno Series Gas-assisted flares are flares that use an additional source of high pressure gas at the flare tip to mix with the waste gas and create additional turbulence to ensure adequate mixing with air, which in turn provides for smokeless combustion. The waste gas is further distributed at the flare tip through AEREON's proprietary Starfire burner, optimizing gas and air mixing. ...
-
Manufactured by AEREON, part of Cimarron groupbased in USA
Whenever a process requires that entrained droplets be removed from a vapor stream, a knockout drum should be integrated into the system. Condensation can occur when hot process gases cool considerably in the flare gas header and riser, and some gases also go to dew point at ambient temperatures and pressures and can therefore generate liquids. These droplets must be removed in order to avoid the ...
-
Manufactured by AEREON, part of Cimarron groupbased in USA
Mach-1 sonic flares are used in both onshore and offshore applications to dispose of high pressure waste gas streams with high smokeless capacities. By efficiently inducing high volumes of ambient air for more complete, smokeless combustion at sonic velocities, this advanced flaring technology allows for reduced levels of radiation and can be placed at lower, less visible elevations, allowing for ...
-
Manufactured by AEREON, part of Cimarron groupbased in USA
Utility flares are one of the most common and basic flare systems. Utility flares are employed in applications which do not require smokeless burning or in applications where smokeless flaring can be achieved without the use of an additional assist medium. Utility flares therefore, do not require auxiliary gas streams such as steam or air; two fluids normally used to improve smokeless capacity. ...
-
Manufactured by AEREON, part of Cimarron groupbased in USA
Hydrogen sulfide or H2S is a lethal gas generated in refineries, petrochemical plants, and gas handling facilities. Sulfur recovery units produce tail gases that contain relatively substantial amounts of H2S. AEREON designs a special type of incinerator, designed to eliminate the H2S components, while inhibiting the creation of corrosive acid by-products. Systems of this nature typically include ...
-
Manufactured by AEREON, part of Cimarron groupbased in USA
AEREON's Momentum Series of non-assist flares provide smokeless performance without the need of additional air-blowers or assist gas for both high pressure and low pressure gas streams. Leveraging the increased momentum of gas that is passed through a simple nozzle or restricted opening, the waste gas intimately mixes with the ambient air and provides for smokeless operation while meeting all ...
-
Manufactured by AEREON, part of Cimarron groupbased in USA
Gas-assisted flares are comprised of two risers (waste gas and assist gas) and an assist gas distribution ring at the tip that provides turbulence with combustion air and waste gas at the flare tip. Upon mixing, the increased turbulence in the waste gas stream, improves combustion efficiency and smokeless performance. These flares generally dispose of heavier waste gases which have a greater ...
-
Manufactured by AEREON, part of Cimarron groupbased in USA
Hydrocarbon vapors may be destroyed in a flare, combustor or a thermal oxidizer. For many applications, a simple vapor combustor can be successfully used as a safe and economical method of controlling vapors from the handling, storage, or loading of volatile liquid hydrocarbons or other compounds when recovery of the vapors is not a viable ...
-
Manufactured by AEREON, part of Cimarron groupbased in USA
Flame front generators are effective, time proven ignition systems which have been widely used in flaring applications for decades. The inherent reliability, rugged construction, ease of operation, and its economic advantages have allowed the flame front generator (FFG) to remain one of the most popular forms of pilot ignition in the industry. The FFG is easily adaptable to any pilot system which ...
-
Manufactured by AEREON, part of Cimarron groupbased in USA
With the roll out of Quad O regulations in the USA, crude/condensate tank batteries and well pads are required to conform to reduced emission levels if they have the potential to emit over 6 tons of VOC per annum. One of the three emission control end-of-line devices can be used: Flares, Enclosed Combustors or ...
-
Manufactured by AEREON, part of Cimarron groupbased in USA
With the roll out of Quad O regulations in the USA, crude/condensate tank batteries and well pads are required to conform to reduced emission levels if they have the potential to emit over 6 tons of VOC per annum. One of the three emission control end-of-line devices can be used: Flares, Enclosed Combustors or VRUs. When enclosed flames and smokeless combustion are required for low pressure tank ...
-
Manufactured by AEREON, part of Cimarron groupbased in USA
AEREON's Cyclone Series Air-assisted flares are comprised of two risers (waste gas and air) and a blower system that provides supplemental combustion air. Air is fed by the blower into the air riser, to eventually combine with the process gas, which passes through its own secondary riser and is distributed at the flare tip through a proprietary AEREON Starfire burner tip. Upon mixing at the flare ...
-
Manufactured by AEREON, part of Cimarron groupbased in USA
Carbon dioxide is often used in fire extinguishers and snuffing systems with the intention of effectively extinguishing flames. When CO2 gas is a large percentage of a waste gas stream, at times it proves difficult to maintain a lit flare without the use of assist gas or a properly designed flame ring. Flare Industries’ industry-proven Flame Ring Flare Technology is recommended in low-BTU ...
-
Manufactured by AEREON, part of Cimarron groupbased in USA
When ample real estate is available, multi-point ground flare (MPGF) systems are an economical approach to enclosed (hidden) and smokeless combustion of large amounts of process gas. By inducing gas through a large array of high-pressure burning points/burners, smokeless combustion can be achieved with high turndown, while concealing all radiation within the walls reducing exposure to personnel. ...
-
Manufactured by AEREON, part of Cimarron groupbased in USA
Pit Flares are generally selected and designed in order to combust a mixture of vapor and liquid from a single source. While most often designed to operate non-smokelessly, through use of Flare Industries’ various Pit Flare technologies, smokeless operation can often be achieved. The flare pit (or “Burn Pit”) is usually constructed of an excavation, lined with a non-combustible ...
-
Manufactured by AEREON, part of Cimarron groupbased in USA
The Model 850 Pilot is a time-proven product that combines electric spark ignition with continuous spark monitoring, thermocouple monitoring, and retractability. The combination of these highly-demanded features has made the high-alloy, stainless steel Model 850 Pilot one of the most well-received ignition systems on the market. This electric pilot provides a rapid, direct spark every 10 to 20 ...
-
Manufactured by AEREON, part of Cimarron groupbased in USA
The Momentum Biogas series of elevated flares is our most economical line of combustion equipment for the biogas sector, offering a cost-effective solution with rapid delivery. Momentum flares utilize a specially designed “burner and shroud” system to manage the intricate mixing with ambient air to provide a high DRE (98%) and high turndown ratio in a simple, yet effective, product. ...
-
Manufactured by AEREON, part of Cimarron groupbased in USA
Utility flares are one of the most common and basic flare systems. Utility flares are employed in applications which do not require smokeless burning or in applications where smokeless flaring can be achieved without the use of an additional assist medium (I.e. For burning of lighter gases). Utility flares therefore, do not require auxiliary gas streams or assist air; two mediums normally used to ...
-
Manufactured by AEREON, part of Cimarron groupbased in USA
Triton sonic flare technology allows for safe, efficient and smokeless flaring at elevated oil and gas production rates by injecting sea water into the flame envelope. High pressure sea water injection reduces flare emissions, helps minimize overall radiation levels from the flame, abates combustion noise, and preserves flame characteristics during high wind events. The Triton sonic flare is ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you