Only show results in Massachusetts? Ok

Steam Turbines equipment for Energy Management

  • Premium

    CECO Aarding - Gas Turbine Bypass Exhaust Systems

    To achieve higher efficiency levels, gas turbine waste heat is used to generate process steam or steam turbine operation. Our Peerless-Aarding brand Gas Turbine Bypass Exhaust Duct allows flexible operation of the power island as well as the capability of starting the gas turbine in rapid starting mode and allowing the heat recovery ...

    By CECO Environmental based in Dallas, TEXAS (USA). from CECO Aarding - Gas Turbine Exhaust Systems Product line

  • Premium

    CECO Aarding - Gas Turbine Exhaust Systems - Heat Recovery Steam Generator (HRSG) Baffles

    Baffles are vanes or panels utilized to direct the flow of exhaust gas, typically through the heated surfaces of a Heat Recovery Steam Generator (HRSG) / boiler (harps or modules). Our Peerless-Aarding brand baffles are designed to minimize gas bypassing the harps or modules, and they maximize the exchange of heat in the harps or modules where ...

    By CECO Environmental based in Dallas, TEXAS (USA). from CECO Aarding - Gas Turbine Exhaust Systems Product line

  • Premium

    ACME - Model ABS-CEJS-24SC-01 - Auxiliary Boiler Systems

    For the past 45 years ACME-AEP has manufactured the key components of auxiliary boiler systems, namely boilers, superheaters, secondary pressure vessels and associated control systems. Power generation projects require an auxiliary boiler system to provide steam on start-up, during maintenance shut-downs, for steam turbine gland systems, ...

    By Acme Engineering Prod. Ltd. based in Montreal, QUEBEC (CANADA). from Boilers Product line

  • Premium

    ACME - Model ES Series - Large Electric Steam Superheaters

    Acme Electric Steam Superheaters are available for use with steam boilers as an auxiliary piece of equipment. Our superheaters are all custom made and built to meet the specific design requirements of each application. A superheater increases the temperature of the steam but does not increase the latent heat of evaporation. This means that heating ...

    By Acme Engineering Prod. Ltd. based in Montreal, QUEBEC (CANADA). from Boilers Product line

  • Premium

    CECO Peerless - Nuclear Moisture Separator Reheater (MSR) Vessels

    Nuclear Moisture Separator Reheater Vessels (MSR) are installed between the high pressure and the low pressure steam turbines at a nuclear power plant. This technology is utilized to remove water condensed from the process steam to maximize thermal efficiency of the low pressure turbine and minimizes erosion/corrosion of steam loop piping.

    By CECO Environmental based in Dallas, TEXAS (USA). from CECO Peerless - Nuclear Power Separators Product line

  • Premium

    CECO Peerless - Secondary Separators within Nuclear Reactor Vessels (Boiling Water Reactor Plants)

    A boiling water reactor, or BWR, is a nuclear reactor used to produce electrical power. Its reactor core heats the water, which then turns to steam to power a steam turbine. The Peerless brand Secondary Separator within Nuclear Reactor Vessels (Boiling Water Reactor Plants), or “steam dryer”, is used as the final stage of water ...

    By CECO Environmental based in Dallas, TEXAS (USA). from CECO Peerless - Nuclear Power Separators Product line

  • Premium

    CECO Peerless - Secondary Separators within Nuclear Steam Generator Vessels (Pressurized Water Reactor Plants)

    In a steam generator vessel or pressurized water reactor (PWR) plant, the reactor core heats water without boiling, and exchanges heat with a lower pressure water system, which will then turn to stream to power the turbine. The Peerless brand Secondary Separator within Nuclear Steam Generator Vessels (Pressurized Water Reactor Plants) or ...

    By CECO Environmental based in Dallas, TEXAS (USA). from CECO Peerless - Nuclear Power Separators Product line

  • Premium

    Model ORC - Organic Ranking Cycle Engine

    ORC technology is based on the widely known and proven Rankine Cycle principle. It was named after William John Macquorn Rankine, a Scottish polymath and Glasgow University professor. The Rankine cycle is a cycle that converts heat into energy. The heat is supplied externally to a closed loop.

    By Inciner8 Limited based in Southport, UNITED KINGDOM. from Waste to Energy Product line

  • Model S2E - Waste Steam Utilizaton

    Energy efficiency, energy optimization is a daily challenge in all industries. For the sectors, where steam is used we have a unique solution, the S2E Steam Microturbine family.

    By BioDiesel Technologies GmbH based in Vienna, AUSTRIA.

  • Ware - Turbines

    With a rich heritage in steam that goes back to 1952, WARE represents single-stage, steam turbines of proven design for mechanical drive and electric power generation for petrochemical, marine and other industrial services. Over 20,000 turbines have been installed providing many years of operating experience driving pumps, fans, blowers, ...

    By Ware, Inc. based in Louisville, KENTUCKY (USA).

  • Sentinel - Steam Turbine Floating Brush Seals

    The Inpro/Seal Sentinel FBS extends maintenance intervals to 3-4 years over conventional carbon rings which normally last 6-12 months. Designed as a drop-in replacement for existing carbon rings, the Sentinel FBS eliminates costly casing modifications and rotor removal for seal installation. The Sentinel FBS is comprised of densely packed and ...

    By INPRO-SEAL based in Rock Island, ILLINOIS (USA).

  • Steam Turbines

    A steam turbine is a device that converts the heat energy in captured, pressurized steam, and converts it to mechanical energy. A steam turbine generator works by heating water to extremely high temperatures until it is converted into steam, then the steam energy is used to rotate the blades of a turbine to create mechanical or rotational energy. ...

    By Tuba Turbine GmbH based in Frankfurt am Main, GERMANY.

  • Boiler and Steam Turbine Technology

    Biomass Engineering are working with leading Technology Suppliers and Engineering Procurement & Construction (EPC) contractors to provide Technical Solutions for the Biomass CHP market. The projects already in construction use the Combustion Grate, Steam Boiler, Steam Turbine and Generator to convert the energy in the fuel into both power and ...

    By Biomass Engineering Limited based in Newton-le-Willows, UNITED KINGDOM.

  • CAMMIS - Model 650 KVA - Gas-Turbine Once Through Steam Generator

    Generator CAMMIS  Newage 650 KVA  V=400  A= 976 RPM 1500.

    By Montalbetti S.p.A. based in Cairate, ITALY.

  • IRSC - Concentrated Solar Power Plants

    IRSC Concentrated Solar Power plants produce electric power by converting the sun>s energy into high-temperature heat using various mirror configurations. The heat is then channeled through a conventional generator. The plants consist of two parts: one collects solar energy and converts it to heat, and the other converts heat energy to ...

    By IRSC based in Mokattam, EGYPT.

  • SolarReserve - Molten Salt Energy Storage Unit

    As renewable energy penetration grows, the need for utility-scale renewable generation with storage technology is increasingly important to mitigate intermittency problems, deliver power into peak demand periods, and support transmission system reliability.

    By SolarReserve, LLC. based in Santa Monica, CALIFORNIA (USA).

  • Vapor - Bubbling Fluidised Bed Boilers (BFB)

    The utilisation of renewable resources becomes all the more important when rising to the challenge of sustainable development. The use of fuels that have a neutral CO2 balance helps slow down climate change and brings greater financial advantages.

    By Vapor Boilers Oy based in Nivala, FINLAND.

  • Combined Heat and Power Plant (CHP)

    Our combustion system is optimized in a CHP plant. A high pressure boiler is attached to our furnace and can, depending on the steam need, produce steam up to 25 tonnes / h and 480 ° C in one or two stages.

    By Jernforsen Energi System AB based in Halmstad, SWEDEN.

  • Model SRCF 30 MW - 150 MW - Steam Turbines

    Single flow, HP section flow in opposite direction to IP and LP (reverse) flow, single cylinder. This turbine standard has been developed to answer to needs of our customers both in the industrial and utility sector. Full arch, fully reaction HP section version is available as the control stage version, to fit any operational configuration. ...

    By Franco Tosi Meccanica SpA based in Legnano, ITALY. from Steam Turbines Product line

  • Combined Cycle Power Plant

    Resource conditions and project economics may allow a plant configuration that combines single-flash and binary technologies. In this arrangement, two-phase flow from the resource is directed to a separator in the same manner assingle-flash, but rather than injecting the separated brine, the brine is directed to binary equipment. There may also be ...

    By Geothermal Development Associates (GDA) based in Sparks, NEVADA (USA). from Power Product line

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you