Only show results available in Michigan? Ok

Waste Heat Boiler equipment for Energy Management

  • Premium

    Anguil - Industrial Energy & Heat Recovery Solutions

    Every energy demand is unique, as is every energy-efficiency improvement opportunity. At Anguil, our track record includes an ability to blend time-tested, standard products with innovative, custom engineered solutions. We design, manufacture, and install energy recovery systems that decrease your energy consumption, reduce operating costs and ...

    By Anguil Environmental Systems, Inc. based in Milwaukee, WISCONSIN (USA). from Other Product line

  • Texas - Model LT-Series - Power Generation Modules

    Designed using cutting edge-technologies, the LT-Series ORC power generation modules by Texas Green Technologies are a compact and efficient solution for small-scale primary power generation. Available in a models ranging from 100 a 175 kWE, and able to work even under partial load (i.e. thermal input lower than nominal) LT systems use overheated ...

    By Texas Green Technologies LLC based in Richmond, TEXAS (USA).

  • Eralp - Model HRSG - Water Pipe Waste Heat Boilers

    Waste heat boilers produced from alloy, high alloy and stainless steel according to physical properties, content, flow and process conditions of gas are designed and produced to be Water Pipe Waste Heat Boilers and Flame Smoke Pipe Waste Heat Boilers. In the gas engines and in the gas turbine, the high-temperature waste gas resulting from the ...

    By Eralp Makina Kazan Kimya Ltd. Sti. based in Mustafakemalpaşa, TURKEY. from Waste Heat Recovery Boilers Product line

  • Fin Coil Recovery (FCR)

    Data without a Cain System: Combustion source:  500 HP Steam Boiler. Heat Sink: Process Water  . Waste Exhaust Temp:  400 °F. Water Temp Inlet: 120 °F. Btu/hr Burner Input: 20,922,000. Fuel Type: Natural Gas. O2 Content:  3%. Excess Air: 18%. Fuel Cost Per Therm:  $0.60. Annual Operating Hours: 6,000.

    By Cain Industries, Inc. based in Germantown, WISCONSIN (USA). from Waste Heat Recovery Systems Product line

  • Martin - Model HRSG - Heat Recovery Steam Generator

    A heat recovery steam generator (HRSG) is an energy recovery heat exchanger that recovers heat from a hot gas stream. It produces steam that can be used in a process (cogeneration) or used to drive a steam turbine (combined cycle).

    By Martin Energy Group Services LLC based in Latham, MISSOURI (USA). from Power Generation Product line

  • Waste Exhaust Heat Boilers

    Approximately 25% of the usable energy of the fuel gas is released in the exhaust of the gas engine. This can be captured for cogeneration in a combined heat and power plant. This heat exits the engine at ~450oC as ‘high grade heat’, contrasting to ‘low-grade heat’ available from the generator cooling circuits. ...

    By Clarke Energy based in Liverpool, UNITED KINGDOM. from Ancillary Equipment for Jenbacher Gas Engines - Waste Heat Recovery Product line

  • Cogeneration / Combined Heat & Power Systems (CHP)

    Cogeneration (cogen) through combined heat and power (CHP) is the simultaneous production of electricity with the recovery and utilisation heat. Cogeneration is a highly efficient form of energy conversion and it can achieve primary energy savings of approximately 40% by compared to the separate purchase of electricity from the national ...

    By Clarke Energy based in Liverpool, UNITED KINGDOM. from Power Product line

  • Horizon Series - Model HRSG - Waste Heat Boiler

    The Victory Energy watertube heat-recovery boiler (patented design) is one of the most flexible, cost effective and technologically advanced units on the market. Our proprietary fintube design allows us to manufacture our boilers with the smallest footprint in the industry which greatly reduces radiant heat loss to contain energy costs. Whether ...

    By Victory Energy Operations, LLC based in Collinsville, OKLAHOMA (USA).

  • Waste Heat Boilers

    BEI can engineer and manufacture both natural and forced circulation waste heat boilers. The watertube design allows for high performance compact heat exchangers often at low flue gas pressure drops, ease of installation, and often the ability to incorporate the HeatSponge replaceable tube for easy long term maintenance. The ideal design is based ...

    By Boilerroom Equipment, Inc (BEI) based in Export, PENNSYLVANIA (USA). from Engineered Systems Product line

  • Chanute - Watertube & Firetube Waste Heat Boilers

    Optimus optimizes the customers’ return on investment by studying critical operating parameters including space availability, operating temperatures, fuel consumption, system capacities and many other factors. Optimus unfired waste heat boilers recover valuable BTU’s from hot process gas or gas turbine exhaust. The boilers are designed ...

    By Chanute Mfg Company based in Chanute, KANSAS (USA). from Engineered Products - Heat Boilers Product line

  • Waste Heat Boilers

    VKK STANDARDKESSEL develops and supplies waste heat boilers for a wide range of thermal processes for generating steam or hot water with smoke-tube or water-tube boilers. Our expertise in the constructive design of the heating surfaces forms the basis for meeting the high thermal, chemical and mechanical demands even in difficult process ...

    By VKK Standardkessel Köthen GmbH based in Köthen, GERMANY. from Boiler Constructions Product line

  • Biomass CHP Plant

    The thermal energy created by combusting biomass can be turned into electricity via a biomass CHP plant. This works by using some of the heat created to drive a turbine and the excess thermal energy is then used to provide either process heat or district heating.

    By Imperative Energy Ltd (IEL) based in Naas, IRELAND. from Other Product line

  • Model DRY-REX - Low-Temperature Biomass Dryer

    DRY-REX low-temperature biomass dryer creates free energy from your existing processes and waste. Where biomass is already in use as a fuel source, DRY-REX can completely eliminate the need to use non-renewable fossil fuels.

    By Thermal Energy International Inc. based in Ottawa, ONTARIO (CANADA).

  • EIS - Energy Efficiency Systems

    The cost of energy contines to rise inexorably and this is unlikely to change in the coming years. EIS specialise in the design of systems that minimise the use of energy and many of our systems operate autothermally, in flameless mode, without the use of any support fuel. In some cases, when sufficient solvent is present, they can even become ...

    By Environmental Integrated Solutions (EIS) based in Halesowen, UNITED KINGDOM. from AIr pollution Control Technology Product line

  • TransPacific - Ocean Thermal Solar Energy Conversion System (OTEC)

    TPE uses the temperature differential between deep (40 F) and shallow waters (80 F) to drive its ORCs and produce power and, as a by-product, fresh water through desalination. Very few OTEC systems were developed as they had an overall efficiency of only 1 to 3%. TPE's system can offer you a maximum efficiency between 6 and 9% due to our unique ...

    By TransPacific Energy (TPE) based in Henderson, NEVADA (USA).

  • GCES - Waste Heat Recovery (WHR) System

    GCES maximizes every reasonable effort to provide beneficial use Waste Heat Recovery (WHR) equipment with the supply of a high temperature Air Pollution Control equipment device.

    By Gulf Coast Environmental Systems, LLC based in Conroe, TEXAS (USA). from Other Product line

  • EURO - Model CK-2 - Charcoal Kiln

    CK-2 “EURO”  - the main purpose is low-temperature pyrolysis of lumpy wood waste of lumbering and firewood of soft- and hardwood species, and also fuel briquettes (pini-key, nestro, ruff) for the purpose of high-grade charcoal or biochar production. The uniqueness of the kiln is following: we do not move raw material from chamber ...

    By GreenPower based in Kharkiv, UKRAINE. from Auxiliary Equipment Product line

  • Cellchem Sulfur Burners

    NORAM acquired the Cellchem sulfur burner technology from Akzo Nobel of Sweden in 2013. This industry-leading sulfur dioxide (SO2) production technology was developed in the 1960's to serve the Scandinavian pulp and paper industry. Since then the technology has been installed at over 180 sites worldwide at capacities typically ranging from 0.5 to ...

    By NORAM Engineering and Constructors Ltd. based in Vancouver, BRITISH COLUMBIA (CANADA). from Sulfuric Acid Group Product line

  • CPI QUADRANT - Model 6.60 - Floating Tube Heat Exchanger

    We have available one of our revolutionary FLOATING TUBE Heat Exchangers. This unit is capable of handling up to 6,000 scfm, and delivers a 60% thermal efficiency. It was designed to be mounted on top of one of our thermal oxidizers, but can be modified to fit a number of other configurations.

    By Catalytic Products International (CPI) based in Lake Zurich, ILLINOIS (USA). from Pre-Owned Equipment Product line

  • E-Tech - Firetube Waste Heat Boilers

    Custom solutions ranging from 100–1000 HP and up to 300 psi. Excellent for Petrochemical and Thermal Oxidizer Applications. Fire-tube boilers work by forcing exhaust gases through tubes immersed in water and represent the most economical means of generating steam from waste heat. E-Tech fire-tube boilers are generally used to generate steam ...

    By E-Tech, Inc. based in Broken Arrow, OKLAHOMA (USA). from Waste Heat Boilers Product line

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you