Only show results in Virginia? Ok

Fuel Transfer equipment for Fossil Energy

  • Spin On Type Fuel Filters

    Micronic fuel filters clean petrol and diesel fuel before it reaches the combustion chamber. It provides maximum protection for injection systems, motors and valves. Innovative filter material of fuel filters are especially effective in protectioning the diesel engine injection systemssuch as Common Rail (CRI) and Pump-Nozzle System. Various types ...

    By Micronic Filter based in Etimesgut, TURKEY. from Spin On Type Fuel Filters Product line

  • Separ Fuel Filter / Water Separator

    Separ 2000 Series water separator / fuel filter remove water and suspended particulate from fuels and oil. Five separate stages of filtration ensure 99.9% water separation at max flow rate. The Series 2000 is designed to reduce wear on fuel pumps and ensure full RPM‚s for the most modern diesel engines. The unique back flushing capability ...

    By AXI International based in Fort Myers, FLORIDA (USA). from Separ Fuel Filter / Water Separator Product line

  • Redundant Primary Filtration SWK2000/40

    The Algae-X SWK-2000 Dual Water Separator/Fuel Filter removes water and suspended particulate from fuels and oil. Five separate stages of filtration ensure 99.9% water separation. The SWK-2000 is designed to reduce wear on fuel pumps and ensure full RPM’s for the most modern diesel engines. The unique back flushing capability significantly extends ...

    By AXI International based in Fort Myers, FLORIDA (USA). from Redundant Primary Filtration SWK2000/40 Product line

  • Tuthill Mobile Re-Fueling Pump

    Explosion-proof drum or tank-mounted pump fits 2'' NPS opening, has built-in check valve and strainer. 1/4 hp permanent magnet ball-bearing motor draws 18 – 20 amps, heavy-duty switch, thermal overload protection. Suction pipe telescopes from 22'' to 40''. Supplied with 12´ nitrile hose with static grounding wire, manual nozzle and nozzle boot. ...

    By BASCO, Inc based in University Park, ILLINOIS (USA).

  • Model FID - Combustion Improvement Systems

    Combustion Improvement Systems homogenize heavy fuel oil after passing through heaters and pumps in the high pressure side of fuel injection system, supplying fine filters and injectors with fuel droplets of 3 micron or smaller. The improved atomization and more intensive contact of fuel with oxygen will significantly enhance combustion, reducing ...

    By IPCO Power B.V. based in Dordrecht, NETHERLANDS. from Combustion Improvement Systems Product line

  • Cube - Model 56 - Diesel Pump

    CUBE pumps have been developed for the distribution of Diesel fuel in non-commercial uses. With CUBE fuel pumps, vehicles can be refuelled quickly and safely, with various options for measuring and recording the quantities dispensed. The flow-meters mounted on CUBE pumps have sturdy mechanical readout systems whose reliability and easiness to use ...

    By Gulersan Lubrication Equipment Co Ltd. based in Ümraniye / Istanbul, TURKEY. from Diesel Pump Product line

  • Model 1344P - Sliding Vane Pump

    1344P (Vane Type) pump is a high pressurized, has a 3' diameter of inlet/outlet dimensions and 180° inlet and outlet connections. Inner mechanism consist of cast iron, aluminium and injection parts. All the dynamic seals/gaskets are used to materials made of FKM in order to give reliable performance in the high petroleum products.

    By Gulersan Lubrication Equipment Co Ltd. based in Ümraniye / Istanbul, TURKEY. from Sliding Vane Pump Product line

  • Model 41-01 - Cartridge Type Filter

    Product Properties: Inlet & Outlet: 2½'. Temperature: -20°C/°C. Operating pressure: 12 bar (max). Mesh: 60-80.

    By Gulersan Lubrication Equipment Co Ltd. based in Ümraniye / Istanbul, TURKEY. from Cartridge Type Filter Product line

  • Model MT-6 Series - Fuel Dispenser

    MT-6 serie pump has been developed for the distribution of Diesel fuel in non-commercial uses.With MT-6 fuel pumps, vehicles can be refuelled quickly and safely, with various options for measuring and recording the quantities dispensed. The flow-meters mounted on MT-6 pumps have sturdy mechanical readout systems whose reliability and easiness to ...

    By Gulersan Lubrication Equipment Co Ltd. based in Ümraniye / Istanbul, TURKEY. from Fuel Dispenser Product line

  • Model HK and HKB Types - Oil Fuel Pumps

    Oil fuel pumps HK and HKB centrifugal type are manufactured according to ТУ.У 29.1-01883088-001:2005 and can be used for transferring and piping oil, oil products, dry hydrocarbon gases and other liquids which have similar physicochemical features and the same corrosive impact to the pump component material.

    By Kharkovmash based in Kharkov, UKRAINE. from Oil Fuel Pumps Product line

  • Poly Cube - Model 950 UN - Polyethene Tank

    This UN approved 950 litre Poly cube is secure, lightweight and as it is made from Polyethene, it will result in rust free fuel. It Is avalilabe with a single diaphragm hand pump or a 12v electric pump. It has two sets of generator feeds to run two units at the same time while the lid is locked. The tank comes complete with a contents guage. ...

    By Trailer Engineering Ltd based in Cradley Heath, UNITED KINGDOM. from Polyethene Tank Product line

  • Model 20 GPM - Fuel Transfer Pump

    Piusi proudly presents their latest addition to the EX-line of explosion proof, UL-listed fuel transfer pumps: The EX75. Now capable of a 20 GPM flow rate at the nozzle thanks to its ¼ horsepower motor. These fuel transfer pumps satisfy the strict ATEX/IECEx directive concerning the use of materials in potentially explosive atmospheres. ...

    By Piusi USA, Inc. based in Fort Lauderdale, FLORIDA (USA). from Fuel Transfer Pump Product line

  • Model BRK1926 - Fuel Boost Pump

    The Fuel Boost Pump was designed so it can be installed between your fuel tank and primary filter, or between the primary filter and the engine lift pump.

    By KTI Systems Inc based in Southwick, MASSACHUSETTS (USA). from Fuel Boost Pump Product line

  • Industrial Steam - Oil Pumping Skids

    Oil Pumping Skids: available to meet the demands of your application and facility. Oil Pumping Skids can range from very simple systems typically found on boiler loop applications to multi-generator systems involving backup features. Custom designed pump skids for heavier oils or other application requirements are available.

    By Industrial Steam based in Atlantic, IOWA (USA). from Oil Pumping Skids Product line

  • Fuel Points/Stations

    Aliedad Company has the capability to design, supply & install & commission fuel points / fuel transfer points of different capacities. The equipments are strictly according to the international safety standards & codes e.g. NFPA. These systems include overhead storage or insulated / isolated storage tanks (underground or under sheds ...

    By Aliedad General Construction based in Amman, JORDAN.

  • Tuffa - Model 1400 VBFS - Bunded Fuel Stations

    Complete with: 2' BSP fill connection c/w cap and chain, Vent, Clock gauge, Gas strut assisted lid for ease when opening the lid of the tank, A submersible pump * 240 volt, A digital flowmeter, 4 metres of delivery hose and automatic shut off nozzle, 10 micron filtration, Nozzle holsterOptional Extras: Fire protection, 12 volt / 24 volt external ...

    By Tuffa UK Limited based in Uttoxeter, UNITED KINGDOM. from Bunded Fuel Stations Product line

  • Speed - Model LD-1200 - Field Recorder

    The LD-1200 Field Recorder collects data at the breaker panel location and is designed to be used in situations where installation at the meter base is either not possible or not permitted. Periodically this data is uploaded for processing using Enetics' SPEED algorithm, which produces energy consumption interval data for each major appliance in ...

    By Enetics, Inc. based in Victor, NEW YORK (USA). from Field Recorder Product line

  • Fuel Saver

    Chou Magnetics Co., Ltd is an expert on many kinds of magnetic devices. We can supply a kind of product named fuel magnets. When fuel is flowing to this fuel magnets (fuel saver), it magnetizes fuel molecule and makes the molecule temporarily into cathode. Fuel burning will be more efficient in engine while reducing carbon. The unit can improve ...

    By Chou Magnetics Co,Ltd based in Ningbo, CHINA.

  • Smart FPS DX and DX-D

    Smart FPS SX systems are equipped with a three or optionally four-stage water removal and particulate filtration. They reverse fuel deterioration, polymerization to submicron levels, decontaminating, cleaning and stabilizing your fuel providing Clear & Bright Fuel for Peak Engine Performance and Reliability at all times. Smart FPS systems are ...

    By AXI International based in Fort Myers, FLORIDA (USA). from Smart FPS DX and DX-D Product line

  • Rotary Arm System

    This system uses a fixed rotating arm with flexible steel arms that sweep the biomass into a central screw auger where it is then transferred to the boiler. The design can be used with both woodchip and wood pellets and is ideal for installations below 500kW. Typically, the rotary arm is placed either flat or on a slight incline at the bottom of a ...

    By Imperative Energy Ltd (IEL) based in Naas, IRELAND. from Rotary Arm System Product line

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you