Only show results available in Connecticut? Ok

Geothermal Power Plants equipment for Geothermal

  • Steam Turbine Components

    We supply parts for customers throughout Europe with a focus on meeting high quality requests with highest quality request. Our parts are primarily used in HYDRO power, THERMAL power, NUCLEAR power, STEAM turbine components, INSIDE / GEOTHERMAL power plants, CRITICAL applications and WIND and TIDAL power.

    By KRÁLOVOPOLSKÁ KOVÁRNA s.r.o. based in Královo Pole, CZECH REPUBLIC.

  • Carbon Dioxide Gas Extinguishing Systems

    Carbon dioxide is a colorless, scentless and non conductive gas that can effect quickly and efficiently into the protected area. Its density is about 50% higher than . the air density.During extinguishing, it is seen as a white mist. It does not make residue on the materials or affect adversely the materials. Reduces the concentration of ...

  • AltaRock - Enhanced Geothermal Systems (EGS)

    Geothermal power is a reliable, clean source of power that provides baseload electricity 24/7 rain or shine. Geothermal power plants have the least down-time of any source of power including coal, gas, oil, hydro, solar, wind, or nuclear. Geothermal plants emit only a tiny fraction of the emissions that fossil fuel powered plants do, and there is ...

    By AltaRock Energy, Inc. based in Seattle, WASHINGTON (USA).

  • Single Flash Non-Condensing Geothermal Power Plant

    This is a great starter plant due to low initial cost and the high potential for modular construction. A modular plant is much more portable, allowing for early wellhead power generation while the balance of the wellfield is developed for a large project. In this type of plant, steam is expanded through the turbine and then released to atmosphere ...

    By Geothermal Development Associates (GDA) based in Sparks, NEVADA (USA). from Modeling Product line

  • Geothermal Power Plants

    Geothermal power plants can be built anywhere in the world, but the economic conditions vary across the world. The largest cost is the bore holes, the deeper the hole is, the more expensive it is. It is preferable to find areas where there is a good supply of hot water at a fairly shallow depth. Energeotek can build geothermal power plants all ...

    By Energeotek AB based in Karlskoga, SWEDEN.

  • Binary - Geothermal Power Plant

    Ormat plant configurations are designed to take maximum advantage of the available geothermal energy resources at each site, and provide various binary plants implementations for:

    By Ormat Technologies, Inc. based in Reno, NEVADA (USA). from Geothermal Power Product line

  • Model HIC / DL - ML 100 MW - 500 MW - Steam Turbines

    This type of machine is made by a HP/IP combined cylinder plus a double flow LP turbine (HIC-DL). The same concept is applied with two LP turbines when larger exhaust areas are needed. State of the art technology allows to reach the highest possible efficiency rate when a compact configuration is requested. Fossil power plants and combined cycles ...

    By Franco Tosi Meccanica SpA based in Legnano, ITALY. from Steam Turbines Product line

  • Model DHI / DL - ML 300 MW - 850 MW - Steam Turbines

    Machines to be applied in large, typically coal-fired power plants. Leading edge technology, both in mechanical and aerodynamic design ensures the best efficiency and reliability either in USC or SC configurations. Full arch admission and full reaction blading.

    By Franco Tosi Meccanica SpA based in Legnano, ITALY. from Steam Turbines Product line

  • Versapipe - Model HD80 GEO - High-Density Polyethylen Geothermal Pipe

    Proven reliability. Geothermal pipe certified to NSF 358, ANSI/CSA C448, CSA B137.1 and ASTM D3035, made with PE3608 high-density polyethylene. With its flexibility and great durability, this HDPE pipe has a proven track record in the geothermal pump industry. Available in a variety of lengths, diameters and other options. Easy to install and work ...

    By Versaprofiles based in Saint-Lazare de Bellechasse, QUEBEC (CANADA). from Geothermal Product line

  • Versapipe - Model HD100 GEO - High-Density Polyethylen Geothermal Pipe

    Long-term reliability. Geothermal pipe certified to NSF 358, CSA C448, CSA B137.1 and ASTM D3035, manufactured with PE4710 high-density polyethylene. Due to its flexibility and increased long-term crack resistance, this second generation high-density polyethylene pipe can withstand higher pressures. Available in a variety of lengths, diameters and ...

    By Versaprofiles based in Saint-Lazare de Bellechasse, QUEBEC (CANADA). from Geothermal Product line

  • Model SCF 10 MW - 100 MW - Steam Turbines

    Single flow, same flow direction for the entire bladed path. Full arch admission with reaction blades as well as control stage version are available. Very simple mechanical scheme to meet the highest performance and reliability standards of a wide and diversified market, from industrial applications to geothermal needs. High speed and direct ...

    By Franco Tosi Meccanica SpA based in Legnano, ITALY. from Steam Turbines Product line

  • Alterra - Reykjanes - Geothermal Power Plant

    Location: east of Reno, Nevada. Total Capacity: 23 MW, currently powered to 15 MW gross. Projected Annual Production: 84,000 MWh. Power Purchase Agreement: through 2021 with NV Energy. Ownership: 100% Alterra.

    By Alterra Power Corporation based in Vancouver, BRITISH COLUMBIA (CANADA). from Power Plants Product line

  • Model SRCF 30 MW - 150 MW - Steam Turbines

    Single flow, HP section flow in opposite direction to IP and LP (reverse) flow, single cylinder. This turbine standard has been developed to answer to needs of our customers both in the industrial and utility sector. Full arch, fully reaction HP section version is available as the control stage version, to fit any operational configuration. ...

    By Franco Tosi Meccanica SpA based in Legnano, ITALY. from Steam Turbines Product line

  • Air-Cooled Binary Geothermal Power Plant

    This process model is similar to the model above but uses a two-phase geothermal resource instead of pumped brine. In this model, the two phase flow is separated with the steam directed to the vaporizer and the separated bring to the preheater. The steam condensate from the vaporizer is also pumped to the preheater. The spent brine is then ...

    By Geothermal Development Associates (GDA) based in Sparks, NEVADA (USA). from Modeling Product line

  • Mitsubishi Hitachi Power Systems - Centrifugal Compressors (Blowers) and Expansion Turbines

    Since 1967 MHPS has provided more than 400 centrifugal compressors and more than 50 expansion turbines. They are operating as electric-generating expansion turbines, compressed air sources, etc. in geothermal power plants and nuclear power plants.

    By Mitsubishi Hitachi Power Systems, Ltd. (MHPS) based in Lake Mary, FLORIDA (USA).

  • Geoperformx - Model V2 - Geothermal Pipe Systems

    GEOPERFORMX V2 helps reduce the installation and operating costs of geothermal systems. Charged with highly conductive mineral nanoparticles, GEOPERFORMX V2 is the first pipe in the world specifically designed to enhance the efficiency and performance of geothermal systems in vertical closed-loop applications.  More conductive than ...

    By Versaprofiles based in Saint-Lazare de Bellechasse, QUEBEC (CANADA). from Geothermal Product line

  • EGP - Geothermal Power Plant Development Services

    Geothermal power provides an answer to the needs regarding environmental protection and sustainable development: it's a source that works constantly, harnessing the Earth's natural heat. Italy is the country where geothermal energy was first harnessed for industrial purposes and is still one of the main producers of geothermal electric energy in ...

    By Enel Green Power SpA based in Rome, ITALY.

  • Combined Cycle Units (GCCU)

    Ormat Geothermal Combined Cycle Units (GCCU) are designed to generate power from high-pressure geothermal steam resources. When there are non-condensable gases present in the geothermal steam, our GCCU technology provides higher efficiency, lower maintenance costs and higher electrical output in comparison to conventional condensing steam power ...

    By Ormat Technologies, Inc. based in Reno, NEVADA (USA). from Geothermal Power Product line

  • Water-Cooled Direct-Contact Condensing Geothermal Power Plant

    A condensing plant makes better use of the resource than a non-condensing plant. In this model, steam is expanded through the turbine down to a very low pressure. Hence, much more power can be generated from the same steam flow when compared with non-condensing plants. After leaving the turbine the steam encounters cooling water sprays in a direct ...

    By Geothermal Development Associates (GDA) based in Sparks, NEVADA (USA). from Modeling Product line

  • Simbol - Breakthrough Technology

    Simbol, Inc. has developed a transformative approach to materials production using hydrothermal brines, a by-product of geothermal power plants. Through years of ground-breaking research, the company has developed a proprietary technology that seamlessly bolts onto existing geothermal power plants.

    By Simbol Materials LLC based in Pleasanton, CALIFORNIA (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you