Showing results for: Geothermal Power Equipment In USA
-
Manufactured by Ormat Technologies, Inc.based in USA
Ormat plant configurations are designed to take maximum advantage of the available geothermal energy resources at each site, and provide various binary plants implementations ...
-
Manufactured by Geothermal Development Associates (GDA)based in USA
Resource conditions may allow consideration of a dual-flash plant. Substantially similar to a single-flash plant, a dual-flash plant is capable of utilizing more of the total flow from the reservoir than a single-flash plant. This increase in resource utilization comes with a corresponding increase in plant complexity and ...
-
Manufactured by Geothermal Development Associates (GDA)based in USA
Resource conditions and project economics may allow a plant configuration that combines single-flash and binary technologies. In this arrangement, two-phase flow from the resource is directed to a separator in the same manner assingle-flash, but rather than injecting the separated brine, the brine is directed to binary equipment. There may also be other combined cycle arrangements, such as using ...
-
Manufactured by Geothermal Development Associates (GDA)based in USA
This process model is similar to the model above but uses a two-phase geothermal resource instead of pumped brine. In this model, the two phase flow is separated with the steam directed to the vaporizer and the separated bring to the preheater. The steam condensate from the vaporizer is also pumped to the preheater. The spent ...
-
Manufactured by Geothermal Development Associates (GDA)based in USA
This is a great starter plant due to low initial cost and the high potential for modular construction. A modular plant is much more portable, allowing for early wellhead power generation while the balance of the wellfield is developed for a large project. In this type of plant, steam is expanded through the turbine and then released to ...
-
Manufactured by Geothermal Development Associates (GDA)based in USA
A condensing plant makes better use of the resource than a non-condensing plant. In this model, steam is expanded through the turbine down to a very low pressure. Hence, much more power can be generated from the same steam flow when compared with non-condensing plants. After leaving the turbine the steam encounters cooling water sprays in a ...
-
Manufactured by Ormat Technologies, Inc.based in USA
Ormat Geothermal Combined Cycle Units (GCCU) are designed to generate power from high-pressure geothermal steam resources. When there are non-condensable gases present in the geothermal steam, our GCCU technology provides higher efficiency, lower maintenance costs and higher electrical output in comparison to conventional ...
-
based in USA
The direct application of the DeepPower Platform is considered to be an Enhanced Geothermal System (EGS). EGS is a next generation geothermal technique and does not require natural hot water reservoirs for the development of geothermal power plants. In EGS, the developer basically creates its own reservoir by drilling down into ...
-
Manufactured by Ansaldo Energia S.p.A.based in ITALY
Ansaldo Energia approached geothermal power plants nearly one hundred years ago, when the first turbine-generator units driven by geothermal steam went in operation in Larderello ...
-
Manufactured by AltaRock Energy, Inc.based in USA
Geothermal power is a reliable, clean source of power that provides baseload electricity 24/7 rain or shine. Geothermal power plants have the least down-time of any source of power including coal, gas, oil, hydro, solar, wind, or nuclear. Geothermal plants emit only a tiny ...
-
based in USA
Many technologies have been developed to take advantage of geothermal energy—the heat from the earth. There has been a major emphasis on creating more alternative sources of energy. Geothermal systems are one of the most efficient systems available for heating and cooling. Geothermal power is cost effective, reliable, ...
-
Manufactured by Energent Corporationbased in USA
The Variable Phase cycle is a patented power system that generates power from waste heat and geothermal resources. The Variable Phase Turbine enables an efficient system for waste heat recovery and geothermal power ...
-
Manufactured by Halliburtonbased in USA
Geothermal power is clean, continuous, and renewable, making it an attractive alternative to coal and natural gas as a base energy source. To generate geothermal energy, operators depend on electric submersible pumping systems that move superheated water from deep in the earth to surface facilities and back underground again. ...
-
based in USA
GenaSysTM technology accesses geologic formations – known as hot sedimentary basins – to harvest their geothermal energy. This resource is…Unlimited, Eternally renewable, Non-carbon emitting, Low-cost, ScaleableTiming is everything. As little as 10 years ago, the technologies needed to economically harvest geothermal power ...
-
Manufactured by Energent Corporationbased in USA
The Variable Phase Turbine is a patented, hermetic turbine generator that generates power from two-phase, transcritical, and single-phase expansions. It is the basis for the Variable Phase ...
-
Manufactured by Ansaldo Energia S.p.A.based in ITALY
cycle to provide the entire power island, to the complete turnkey ...
-
Manufactured by Tricor Metals Incbased in USA
Special Applications/Features; Mechanical (roller) expanded tube-to-tubesheet joints. Hydro-expanded tube-to-tubesheet joints. Seal-welded tube-to-tube sheet joints. Strength-welded tube-to-tube sheet joints. Thermal oxide coating designs for added erosion & corrosion resistance. Extended surface tubing available. Flush mount tube to tube sheet for full drain-ability. Polishing requirements ...
-
Manufactured by Tricor Metals Incbased in USA
Flush mount tube to tube sheet for full drainability, Polishing requirements up to 15 Ra, Double tube sheet design, Platinum spotting for tantalum units, Leak detection ports on loose lined tube sheets, Solid or explosive bonded design to fit your ...
-
Manufactured by Vacuum Process Engineering (VPE)based in USA
VPE Thermal LLC, a subsidiary of VPE, manufactures custom diffusion bonded microchannel heat exchangers (MCHEs), also known as printed circuit heat exchangers (PCHEs), for a diverse range of industries. Furthermore, these compact heat exchangers are ideally suited for high-pressure and high-temperature applications. ...
-
Manufactured by Pfister Energybased in USA
Geothermal heat pumps are among the most efficient and comfortable heating and cooling technologies, but instead of using heat found in outside air, they rely on the stable, even heat of the earth to provide heating, air conditioning and hot water. The heat pump equipment works like a reversible refrigerator by removing heat from one ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you