OTT HydroMet - Model ADCON Vento1 - Wind Speed and Direction Sensors
From ADCON - Sensors
The ADCON Wind Sensor Set Vento 1 is tailor made for meteorological applications that require a maximum of accuracy over an extended measurement range, integrated into a very robust, yet low-maintenance body made of seawater resistant aluminum.
-
Most popular related searches
Product Details
Wind Speed Sensor
The Wind Speed Sensor has a very low starting threshold of less than 0.4m/s, thanks to its low-friction bearings and its generously dimensioned aluminum cups. The rotating 3-cup unit can be replaced in the field. The sensor will measure speeds of up to 200 km/h.
Wind Direction Sensor
The Wind Vane employs an accurate hall sensor. The vane is also made of aluminum and, like the wind cups, is easily field replaceable.
Both sensors require very little maintenance and will remain within their specifications for many years.
To properly mount the sensors according to WMO requirements the set comprises of an 80cm wide mast mounting arm, complete with mounting brackets. Each cable comes with its own Binder cable plus a separate Y-cable. This allows individual replacement of sensors in case of maintenance or repair, but still occupies only one connector on your ADCON RTU.
Both sensors are also available as individual units. If ordered separately they will be delivered with individual mounting arms and a 2m Binder cable.
Applications Areas
- Professional meteorological stations
- Agricultural and hydrographical weather stations
- Wind Power Stations
Technical Specifications
Wind Speed:
- Measuring principle: magnetic
- Measuring element: 3-arm cup anemometer, aluminum
- Measuring range: <0.4 ... 55,56m/s (1.44 ... 200km/h)
- Accuracy: < ± 0.3m/s
- Resolution: ± 0.1m/s
- Starting value: < 0.4m/s (1.44 km/h)
- Output signal 0 ... 2.5V DC
- Case: sea water resistant aluminum
- Temperature range: -40°C ... +70°C (non-icing)
- Mounting: Bores with diameter of 30mm at max. 10mm wall strength
- Weight: approx. 500g.
- Standards: VDI 3786, sheet 2 / WMO No.8
- Cable: Binder Germany, 1m, shielded, PUR
- Connector: Binder M9 male 7-pin
Wind Direction:
- Measuring principle: magnetic
- Measuring element: aluminum wind vane
- Measuring range: 0° - 360°
- Accuracy: < ± 2°
- Resolution: ± 1°
- Starting value: < 0.4m/s (1.44 km/h)
- Output signal 0 ... 2.5V DC
- Dead angle: 4° ± 1°
- Switching point: North
- Case: sea water resistant aluminum
- Temperature range: -40°C ... +70°C (non-icing)
- Mounting: Bores with diameter of 30mm at max. 10mm wall strength
- Weight: approx. 500g.
- Standards: VDI 3786, sheet 2 / WMO No.8
- Cable: Binder Germany, 1m, shielded, PUR
- Connector: Binder M9 male 7-pin
Customer reviews
No reviews were found for OTT HydroMet - Model ADCON Vento1 - Wind Speed and Direction Sensors. Be the first to review!