Energy Storage Modeling Articles & Analysis
4 articles found
By Jason Deign A Spanish team has uncovered a radical new encapsulated phase-change material (PCM) storage system after creating a novel modelling tool for CSP. The multi-layered solid-PCM (MLSPCM) system has a theoretical thermal capacity, measured as energy delivered over energy stored, of more than 74 %, while requiring only ...
This paper presents a novel and optimised switching strategy and control approach for a three-level two-quadrant chopper in a three-level neutral point clamped (NPC) voltage source inverter (VSI) superconducting magnetic energy storage (SMES). Using the proposed switching strategy, the voltage of the inverter capacitors in SMES can be independently controlled. Also, the minimum power and ...
Distributed Generation (DG) and its interconnection to the AC power grid is a relatively new concept. DG employs small generators, which are distributed throughout the power system. The electricity is usually generated by renewable energy sources such as wind, hydro and tidal, which are intermittent in nature. These generators connected to the AC grid may lead to severe power quality problems. ...
Parabolic trough power plants use concentrated direct insulation for steam generation in a Rankine cycle. The fundamentals for direct steam generation in parabolic troughs have been developed in recent years, the feasibility was successfully demonstrated at a solar powered test facility reaching steam temperatures of 400°C at a maximum pressure of 100 bar. Important components for the accelerated ...