Earthcon Energy India Pvt Ltd products

Our non-assisted flares and utility flares are used in applications that don’t require smokeless operation, or where smokeless operation can be achieved without the assistance of external steam, air or pressure. When the gas has good composition such as many light hydrocarbon content and high LHV, the application for this flare type will be the main consideration after conducting the engineering simulation and calculation. It has lower investment cost and maintenance cost than other assisted-flare.

We offers several air-assisted flares using our advanced designs to promote complete, efficient combustion of heavier waste gases at sites where steam is not available or economical. Air-assisted flares use blowers to inject assist air directly into the waste gas stream as it exits the tip, resulting in smokeless burning and long flare tip life.

Our steam-assisted flares are used in applications where heavier waste gases need to be disposed and high-pressure steam is readily available on site. Our proprietary flare designs offer exceptional smokeless performance, lower radiation levels, and less noise than typical air-assisted flares.

We offers both single-point and multi-point gas-assisted flares for smokeless burning of low- pressure, heavy hydrocarbons. Our designs deliver stable burning, high-destruction efficiency and low radiation levels wherever steam or air is unavailable.

Some gases contains composition which has low lower heating value (LHV), affects the gas is difficult to be burnt as minimum lower heating value of gas should be 200 Btu/scf. To increase the LHV, a gas injection into the flame through manifold or jets sprayer is required. For high pressure gas, its kinetic energy can be used to entrain additional air by piping it separately to the flare tip.

In one compact design, two types of gases which are low pressure gas and high pressure gas are burnt in a single flare tip. Designed with integrated turbulence swirl plates, it improves the mixing between high pressure gas and low pressure gas with surrounding air to create a turbulence effect inside the flame. Final goal in this process is complete combustion with smokeless flame.

Enclosed ground flare hide its flame inside the enclosed wall which is lined with ceramic fibre refractory to greatly reduce the high temperature burning, noise and luminosity. Very suitable for facility near residential or local environmental regulations do not permit to have a visible flame or when there is no adequate space to install another type of flare.

Any type of elevated flare can be applicable for offshore facilities. It considers the material of flare tip from high resistant of sour condition (corrosivity) and weather condition.