Eltek Limited products

Need to know how electrical energy is being used? The GenII GD40A/AB transmitter and clip-on self powered CTs can provide the answer. The four GD40A/AB sensor inputs are designed for ND Meter SXD CTs. The transmitter is intended for use in situations where an averaged rather than instantaneous value at the time of transmission is required. Transmitters for accurate electricity usage monitoring using self powered clip-on CTs.

Need to know energy usage in, for instance, a domestic situation? Eltek GenII pulse transmitters and Rayleigh or Elster sub-meter systems provide a precise answer.

These specialist data loggers and accessories are tailored for the electricity energy sector and facilitate the metering and recording of AC voltage, current and temperature using a single comprehensive and accurate instrument.

These conventional precision current clamps available from Eltek are supplied complete with lead and DIN Plug. They are suitable for use with models 1010 and 1020 Energy Loggers. Normally the CT5 or CT75 is used to measure the secondary current in a permanently installed current transducer as part of a high voltage distribution installation. The Squirrel range, when used in this application, can be scaled to display the actual range of the primary current. Clamps for 5 and 7.5A maximum are normally held in stock, but other ratings are available - please contact Eltek for your requirements.

NDRail350: NDRail350 DIN rail mounting energy meter (1 x 3 phase load). NDRail310: NDRail310 DIN rail mounting energy meter (3 x 1 phase loads). DSP10-12: DIN rail mounting AC to 12VDC power supply from TDK.

The RX250AL Receiver logger is the heart of a GenII logging system. Because the RX250AL is responsible for receiving and storing the data, it is not necessary to have a PC permanently connected. The built-in battery means data logging is not interrupted even if there is a temporary AC mains failure. Multiple RX250ALs can be used for wide area coverage. Alarms (including SMS alarms) come as standard. (To use SMS alarms, a GSM modem is required).

The SC250 is the hub of the secure logging system, for use with Eltek`s Darca Secure software. It is not necessary to have a permanently connected PC and the built-in battery means data logging is not interrupted if there is a temporary AC supply failure. Alarms are included as standard (SMS and local) and include grouping so that alarms for individual departments can be configured.

Kipp and Zonen CMP3 sunshine pyranometer. A mounting bracket/base may be required. (e.g PyroBkt below). The CMP3 does not require power.

SKM221 levelling unit and SKM226 mounting bracket may be required (see image to the right). The SKS1110 does not require power.

This is a pole mount robust bracket pre-drilled for use with the Kipp and Zonen CMP3 and the SKS1110. The mounting bracket positions the centre of the CMP3 approximately 155mm from the mounting pole. A stainless steel U bracket with securing nuts is included.