7 products found
ENKO Electronic Control Systems San. Tic. Ltd. Şti. Products
-
Gen-Set- Automatic Mains Failure Units - AMF Series
AMF units continuously monitor the values measured on the Mains and when any values are outside the limits set by the user the AMF automatically starts the Generator, transfers the Load between the Mains and the Generator, checks the status of the engine and provides full protection. The more advanced models are capable of maintaining the engine by automatically executing scheduled test runs, can be remotely monitored / controlled and provide many other functions.
-
Enko - Model AMF 2.0 - Automatic Mains Failure Units
AMF2.0 is a full Automatic Mains Failure unit intended to be used for single Gen-Set applications. The controller can be used with single or three phase mains ...
-
Gen-Set- Manual Start Units - MSU Series
MSU units start the Generator when a remote start signal (from an ATS or other source) or manually started from the panel itself, continuously checks the status of the engine and provides full protection. The MSU units do NOT check the status of the Mains, hence they are used for stand-alone Generators or with an ATS unit if there is a Mains in the system. The more advanced models are capable of maintaining the engine by automatically executing scheduled test runs, can be remotely monitored / controlled and provide many other functions.
-
Enko - Model MSU 2.0 - Manual Start Unit
MSU 2.0 offers all necessary control functions for single Generator applications. MSU 2.0 is a full Manual Start Unit intended to be used for single Gen-Set applications. Full Generator control functions can be implemented through the unit program menu. The unit has a configuration parameter menu which can be accessed from the front panel. All engine parameters can be monitored and full engine protection is ...
-
Gen-Set- Battery Charger Units - EBC Series
In general battery chargers are used to charge batteries, however ENKO EBC series battery chargers can be used to charge any lead-acid or nikel-cadmium batteries or alternatively can be used as a DC power supply due to the low ripple on the output. In Gen-Set application battery chargers are used to charge the batteries so the engine has the required power to be cranked when needed. A dead battery means that the generator can NOT be cranked, which therefore means that there is no power. So a reliable battery charger and a battery system is crucial for a Generator. As a general rule of thumb the current rating of the battery charger should be about 10% of the A/Hr rating of the batteries to ensure the health of the system.
-
Enko - Model EBC 1205 - Battery Charger Unit
SMPS technology for maximum efficiency and reliablity with minimum heat dissipation. EBC 1205M can deliver continuous charging current of 5A into 12V battery system (voltage is set to 13.8Vdc, with an option of up to 14.7Vdc) These battery chargers are designed with performance in mind and special care is taken for protecting and extending the life-time of the ...
-
Enko - Model EBC 1210 - Battery Charger Unit
SMPS technology for maximum efficiency and reliablity with minimum heat dissipation. EBC 1210M can deliver continuous charging current of 10A into 12V battery system (voltage is set to 13.8Vdc, with an option of up to 14.7Vdc) These battery chargers are designed with performance in mind and special care is taken for protecting and extending the life-time of the ...
-
Air Compressor- Air Compressor Control Units - CCS Series
The Advanced Air Compressor Controller - CCS 4.1. The new unit in our CCS Series Air Compressor Controllers has been released. CCS 4.1 features the most advanced features which can satify even the most demanding applications. The unit has Inverter ...
-
Enko - Model CCS-L - Air Compressor Control Unit
Advanced Controller for Air Compressor ...
-
Enko - Model CCS-S - Air Compressor Control Unit
CCS S is an industrial control unit designed for the operation of screw and reciprocating air ...
-
Enko - Model CCS 3200 - Air Compressor Control Unit
CCS 3200 is an industrial control unit designed for the operation of screw and reciprocating air ...