Northern Arizona Wind & Sun products

Rugged 1 watt solar module comes complete with a built-in blocking diode and a ten foot 2-wire UV resistant output cable. This panel is ideal for trickle charging smaller batteries or battery banks up to around 200 amp-hour (up to 600 amp-hour for AGM type batteries) to keep them fully charged while not in use. No charge controller needed. The anodized aluminum frame provides for easy mounting offers full protection for years of continued charging.

The BSP2-12 comes complete with a built-in blocking diode and a 10` 18/2 UV resistant output cable. This panel is ideal for trickle charging smaller batteries or battery banks to keep them fully charged while not in use. No charge controller is needed.

Patented Maximum Power Point Tracking (MPPT) technology allows Solar Boost 2000E to increase charge current up to 30% more compared to conventional charge controllers (average yearly gain will be around 10-15%). ** Note: Max input voltage (Voc) on this controller is 30 volts DC, so it cannot be used with the higher voltage solar panels, such as the Kyocera KD210. For those panels we suggest using one of the Morningstar MPPT charge controllers.

Note: The 7ft. and 6 ft. XRS rails can ship UPS. All longer XRS rail lengths must ship freight. The XRS rail is our popular, best performing rail. Spanning over 12 feet under most load conditions, the XRS rail has slots for both top and bottom mounting. The XRS rail is manufactured using extruded 6105-T5 aluminum and is available in a clear anodized finish.

Besides off-grid systems, the MS2012 inverter is very popular for RV`s and marine use. Pure sine wave and a built in 100 amp battery charger makes it ideal for new installations, or replacement or upgrade for older modified sine wave inverters. In RV`s this will replace both the inverter and the converter. The built in battery charger will run from standard AC and nearly all generators of 2000 watts or more. Pure sine wave power for your stereo, plasma screens, and other sensitive electronics. The MS Series is designed for both mobile and off-grid applications. Competitively priced, the MS-Series is available in 2000, 2800 and 4000 watt models. Install the MS Series in four easy steps: simply connect the inverter`s output to your AC distribution circuits or electrical panel, connect your shore power cable (AC) to the inverter`s easy-to-reach terminal block, connect the batteries, and switch on the power.