Chatron - Model SVP 2 - Industrial Air / Air Solar Panels - Brochure

Factory: Travessa da Zona Industrial - 1, nº 95 Rossio, 3730-601 Vila Cova do Perrinho, Vale de Cambra.Tel. (+351) 256 472 888Fax: (+351) 256 425 794Email: comercial@chatron.ptUrl: www.chatron.ptSolar Tube HybridAs customer needsNew2013Residential and Industrial ApplicationIt will be another version of the standard solar tube associ-ated with a PV kit and a kit of ECO lamps that will enable low-power lighting in daytime or night periods with reduced natural light. This is a very compact solution without the need for special wiring since the entire kit will already be assembled and ready to operate. In addition to the photo-voltaic panel, charge regulator and battery, the kit features inside an electronic board with a microprocessor developed by Chatron wich will read, process and quantify the amount of light reaching the summit at every moment, giving different orders for loading / unloading of the battery. Will switch to the grid when the batteries are low, allowing to open and close the register of solar tube closure (if it ex-ists in the accessory installation).In short, this is a mini-home automation system applied to lighting and can also be interconnected to the central home automation system (if any).The lamps can be handled manually by push switch, and follow the program they are turned off for example if there is enough natural light, avoiding unnecessarily discharging the batteries.Daytime use Night useFábrica: Travessa da Zona Industrial - 1, nº 95 Rossio, 3730-601 Vila Cova do Perrinho, Vale de Cambra.Tel. (+351) 256 472 888Fax: (+351) 256 425 794Email: comercial@chatron.ptUrl: www.chatron.ptConstitution Tube Solar HybridTechnical featuresPhotovoltaic Kit Photovoltaic Module Load Regulator Electronics Board BatteryKF1 10WP Yes Yes 7,2A - 12VKF2 40WP Yes Yes 12A - 12VKF3 80WP Yes Yes 2x12A - 12VModel Diameter (mm) Light area (m2)TS 250 H 250 10TS 300 H 300 18TS 530 H 530 40 The hybrid solar tube acts as a stan-dard solar tube during the day, obtainingand focusing the sunlight into the interior of the building. A significant difference concerning this is the operation overnight.When it gets dark, the photovoltaic panel fails to charge the battery and then (with an adjus-table light level through the circuit board as we shall see ahead) you can now light the LED bulb to illuminate inside. This LED light bulb can only light up when the electronic board allows it, avoiding the lamp through forgetfulness or otherwise stay lit during the day, unnecessarily consu-ming battery power. In the early morning hours, when it is day and there is natural light, the electronic board cuts also allowed to use the lamp (for the same reason).Other features include:On / Off switch to turn the lamp during • the nightControl register for any closing or opening • of the solar tube (if present)Other calibration functions, and diagnostic • test.The protector normally provided with the hy-brid solar tube has a flat base which includes the solar diffuser and two or more LED lamps 12 VDC, and still the electronic board of com-mand and control according to the scheme above.Electronic cardDomeBasePhotovoltaic PanelBatteryInterior Diffuser