Eltwin Hyper - SureStart Single Phase Soft Starter - Flyer

Benefits• Able to get compressors started under far worse conditions and with far lower starting currents than ever before; typically 30% of starting amps. Conditions that other soft starters cannot come close to.• Automatic adjustment of the compressor starting current to the available supply voltage —maintaining constant starting torque and current.• Prevents pipe fracturing and shock to motor support base.• Prevents the motor from running backwards caused by switching or momentary power loss.• Reduces the supply line voltage drop experienced during startups.• Protects the compressor from potentially damaging low voltage sags to increase motor protection.• Monitors supply voltage while compressor is running to prevent motor stalling, causing excessive currents, under low voltage conditions. • Provides a quieter unit with significantly diminished startup noise.Electrical Features• A compact, fully self-contained, lightweight unit (5.25 x 2.8 x 2.2 in. and weighing less than 1.1 lb.) aimed at the single-phase compressor market, and is suited to both split systems and room models• Housed in a flame retardant ABS plastic enclosure• Much lower start current, which prevents light flickering —reductions approaching 6:1 can now be achieved (over normal LRA)• Supply line impedance monitoring and compensation• Automatic compensation for residual back pressure in the system• Contactor protected from arcing damage• Motor reversal protection during power loss prevents damage• Easy installation in the field with full, detailed instructions supplied• Proven performance in the field• ETL, CE, and RoHs compliant020406080100Time x 10 (ms)Current (A)LRASure-Start6Sure-Start6 vs. Locked Rotor Amperage0 150 300 450 600Sure-Start6 is a single phase soft starter which reduces the normal start current (Locked Rotor Amperage - LRA) up to 70%. This allows compressors to more easily go “off-grid.” Using Sure-Start6 will also provide a substantial reduction in light flicker, reduce startup noise, and improve the compressor’s run life. Sure-Start6 is available for any field retrofit by your local contractor.Over 250,000 Sure-Starts in use worldwideRUN WINDINGRUN CAPACITORACTIVE (T2)START WINDINGNOT USEDCOMPRESSORCOMMONR SCRUNCAPT2L2T1L1COMPCONTCOMPCONTSure-Start6Single Phase Soft StartersCS5600MH 07/13Locked Rotor Amperage and Sure-Start6 Comparison© 2013 Hyper Engineering, Pty. Ltd., 9000 Conservation Way, Fort Wayne, IN 46809-9794. Hyper Engineering has a policy of continual product research and development and reserves the right to change design and specifications without notice. These oscilloscope graphics show the starting current waveforms. After the device is cycled a few times, the amount of current is dramatically reduced to optimize startup current.BeforeLocked Rotor Amperage (LRA)AfterUsing Sure-Start6 Soft StarterM Pos: 150.0ms CH1CouplingBW Limit20MHzVolts/DivProbe100XVoltageInvertDCOnCoarseOffM 50.0msCH4 50.0ABWCH4 / 24.0A<10HzAcq Complete?4TekM Pos: 150.0ms CH1CouplingBW Limit20MHzVolts/DivProbe100XVoltageInvertDCOnCoarseOffM 50.0msCH4 50.0ABWCH4 / 24.0A<10HzAcq Complete?4Tek M Pos: 150.0ms CH1CouplingBW Limit20MHzVolts/DivProbe100XVoltageInvertDCOnCoarseOffM 50.0msCH4 50.0ABWCH4 / 24.0A<10HzAcq Complete?4TekM Pos: 150.0ms CH1CouplingBW Limit20MHzVolts/DivProbe100XVoltageInvertDCOnCoarseOffM 50.0msCH4 50.0ABWCH4 / 24.0A<10HzAcq Complete?4TekTypical Amp Reduction with Sure-Start6Nominal Tons RefrigerationMotor SizeBefore Sure-Start6AfterSure-Start67 Btu 7 hp 183A 55A6 Btu 6 hp 150A 40A5 Btu 5 hp 130A 36A4 Btu 4 hp 100A 29A3 Btu 3 hp 75A 23A2 Btu 2 hp 50A 15AModelsSingle Phase Sure-Start6 Soft Starters* 60/50Hz, 220-240 Volts AC• Part# SS6S0.5-1.75-USL-115V (covers all)• Part# SS6S2-3.5-USL-230V (1.5 to 3 hp)• Part# SS6S3.5-7-USL-230V (3.5 to 7 hp)Single Phase Sure-Start6 Soft Starters* 50Hz, 230 Volts AC• Part#: SS6M2-4 (2 to 4 hp - Primary, replaces contactor)• Part#: SS6M2.5-6 (2.5 to 6 hp - Primary, replaces contactor)• Part#: SS6S2-4 (2 to 4 hp - Secondary, requires contactor)• Part#: SS6S2.5-6 (2.5 to 6 hp - Secondary, requires contactor)* Several custom models are available to suit specific brands, contact the Australian office to check availability.Applications - HVAC/R• Compressors• Rooftop Fans - Marine - Irrigation Pumps - Backup Generators - Solar Power - RV/TruckContact InformationUnited States of America Australia9000 Conservation Way 4/14 Ralph Black DriveFort Wayne, IN 46809 North Wollongong 2500USA NSW AustraliaPhone: (877) 304-0724 Phone: +61 2 4229 2069www.hypereng.com • sales@hypereng.comOver 250,000 Sure-Starts in use worldwide