Noren - D Models - Hydraulic Oil Coolers Brochure

 This document is subject to change without notice. Noren Products, Inc. Page 1 of 2 1010 O’Brien Drive Menlo Park, California 94025 CCS-PBD-7.2.2-883424-A (650) 322-9500 www.norenproducts.com HyTec Cooler D-Model: Elevator Hydraulic Fluid Cooling for Dry Type Reservoirs HyTec Elevator Hydraulic Fluid Coolers Reduce Fluid Temperatures STANDARD MODEL = 16,600 BTU/hr@40* ^t  HIGH POWER MODEL = 24,900 BTU/hr@40*^t The Noren HyTec Cooler D-Model provides very effective fluid cooling for elevator systems with typical dry type hydraulic reservoirs. D-Models utilize a barrier to divert all hot return fluid through the HyTec cores before it is drawn back into the pump. This barrier, a kind of ‘fence’ is constructed of rectangular tubing and angle material. The center section of the barrier (the section holding the HyTec cores) is the same size in all cases. The barrier ‘wings’ are adjustable to fit each application and designed to closely fit to the walls of the reservoir to maximize hot fluid flow through the HyTec cores. The fluid’s heat is absorbed by the HyTec Heat Pipe cores and quickly transferred up the cores, out of the reservoir, then dissipated by the fans into the room. This system provides an economical, efficient and low maintenance solution for hydraulic overheating issues. Custom units available- call to discuss Compact Cabinet Coolers ? Energy Efficient ? Low Maintenance ? Easy to Installing ? Seal the panel from outside contaminants Noren also offers:Heat exchangers for cooling sealed electrical control panels and enclosures. D-MODEL   STANDARD:   # D-112D  HIGH POWER:   # D-222D (2)  53" Cores   (4)  53” Cores (2)  Shroud with 2 fans    (2)  Shroud with 2 fans    (.23 amps per fan, 115VAC)    (.23 amps per fan, 115VAC) (1)  Barrier with adjustable ‘wings’  (1)  Barrier with adjustable ‘wings’ Figure 1 Figure 2  This document is subject to change without notice. Noren Products, Inc. Page 2 of 2 1010 O’Brien Drive Menlo Park, California 94025 CCS-PBD-7.2.2-883424-A (650) 322-9500 www.norenproducts.com HyTec Cooler D-Model: Elevator Hydraulic Fluid Cooling for Dry Type Reservoirs Installation of the HyTec Cooler D-Model for dry type reservoirs is fast and easy 1. Disconnect the hydraulic unit from the electrical supply. 2. Remove existing reservoir cover. 3. Install the HyTec barrier as shown in Figure 1. Position of the barrier may vary depending on the reservoir size and obstructions. 4. Install the HyTec core with the “top” end up, in the barrier as shown in Figure 1. 5. Slide the HyTec fan shroud assembly onto the core as shown in Figure 2. 6. Modify the reservoir cover to accommodate the HyTec Cooler unit(s). 7. Reconnect electrical service. 8. Plug the HyTec Cooler fan cords into 110VAC electrical outlets.