Sine Wave Inverter

The Powerful DifferenceThe MS Series Pure Sine Wave Inverter/ChargerThe MS Series Inverter/Charger from Magnum Energy – a pure sine wave inverter designed specifically for the most demanding mobile and off grid applications. The MS Series is powerful, easy-to-use, and best of all, cost effective.Power Factor Corrected (PFC) Charger: Our PFC charger is built into all of our inverter chargers. It uses less energy from a generator than a standard charger – using 25-30% less AC current than standard chargers.Safe and reliable: The MS2000, MS2012, MS2812, and MS4024 are ETL Listed to the stringent requirements of UL/cUL 458 for mobile use and the MS2012, MS2812, and MS4024 are ETL Listed UL 1741 and CSA C22.2 #107.1-01 for renewable energy installations. All models also meet KKK-A-1822E standards for emergency vehicle use.Easy-to-install: Install the MS Series in four easy steps: simply connect the inverter’s output to your distribution circuits or electrical panel, connect your utility power cable to the inverter’s easy-to-reach terminal block, connect the batteries, and switch on the power.Features:Pure sine wave: Power your T.V.s, stereos, plasma screens, and other sensitive electronics without worry. The pure sine wave inverter and power factor corrected charger provide clean, reliable inverter power with low total harmonic distortion (THD) of less than 5%.Choices: The MS Series comes in 12 and 24 volt configurations, allowing you to choose the model that is right for you.Versatile mounting: Mount the MS Series on a shelf, bulkhead, or even upside down. Lightweight: The lightweight aluminum base and cover also provides noise reduction and corrosion resistance.MODEL NUMBERSMS2000 ?MS2000-20B ?MS2012 ?MS2012-20B ?MS2812 ?MS4024 (series stackable) ?AVAILABLE FORRenewable ?Energy Systems Off-grid Power Back-up PowerMarine Systems ?RV Systems ?AVAILABLE ACCESSORIESAGS ?Battery Monitor Kit ?Conduit Box ?DC Load Disconnect ?Fuse Blocks ?Remote - ME-RC ?Remote Switch Adapter ?Series Stacking Interface ?(MS4024 only)Multiple ports: The MS Series provides multiple ports, including an RS485 communication port for network expansion, and a remote port.Accessible design: The extra large AC access cover with terminal screw block and 360° DC connection terminals with covers make this inverter more accessible when it needs to be.Convenient switches: The MS Series comes with an on/off inverter-mounted switch with an easy-to-read LED indicator.Expanded transfer relay: 60 Amp transfer service is available on all models.Buy with ease: The MS Series is backed by a three-year (36-month) limited warranty.The MS Series Inverter/Charger is powerful, easy-to-use, and cost effective.The Powerful DifferenceAuthorized Magnum DealerPhone: 425-353-8833Fax: 425-353-8390Web: www.magnumenergy.comTesting for specifications at 25° CSpecifications subject to change without notice.January 2010, Rev G Part #64-0200Magnum Energy, Inc.2211 West Casino RoadEverett, Washington 98204 USAMS Series SpecificationsMS2000 MS2012 MS2812 MS4024Inverter SpecificationsInput battery voltage range 9 - 17 VDC 9 - 17 VDC 9 - 17 VDC 18 - 34 VDCNominal AC output voltage 120 VAC 120 VAC 120 VAC 120 VACOutput frequency and accuracy 60 Hz ± 0.1% 60 Hz ± 0.1% 60 Hz ± 0.1% 60 Hz ± 0.1%Total Harmonic Distortion (THD) < 5% < 5% < 5% < 5%1 msec surge current (amps AC) 50 50 70 120100 msec surge current (amps AC) 33 33 40 725 sec surge power (real watts) 3300 3300 3900 580030 sec surge power (real watts) 3100 3100 3800 54005 min surge power (real watts) 2800 2800 3200 490030 min surge power (real watts) 2200 2200 3000 4500Continuous power output at 25° C 2000 VA 2000 VA 2800 VA 4000 VAMaximum continuous input current 266 ADC 266 ADC 373 ADC 266 ADCInverter efficiency (peak) 89% 89% 88% 87%Transfer time 16 msecs 16 msecs 16 msecs 16 msecsSearch mode (typical) 5 watts 7 watts 7 watts 7 wattsNo load (120 VAC output, typical) 25 watts 25 watts 30 watts 25 wattsWaveform Pure Sine Wave Pure Sine Wave Pure Sine Wave Pure Sine WaveCharger SpecificationsContinuous output at 25° C 100 ADC 100 ADC 125 ADC 105 ADCCharger efficiency 85% 85% 85% 85%Power factor > .95 > .95 > .95 > .95Input current at rated output (AC amps) 15 15 18 29General Features and CapabilitiesTransfer relay capability MS2000: 30 A single inputMS2012, MS2812, MS4024: 2 legs at 30 A for 120 V/30 A or 240 V/60 A serviceFive stage charging capability Bulk, Absorb, Float, Equalize (requires remote), and Battery Saver™Battery temperature compensation Yes, 15 ft Battery Temp Sensor standardRemote available (optional) Yes, MM-RC or ME-RCInternal cooling 0 to 120 cfm variable speed drive using dual 92mm brushless DC fansOvercurrent protection Yes, with two overlapping circuitsOvertemperature protection Yes on transformer, MOSFETS, and batteryConformal coating on PCB’s for corrosion protection YesPowder coated chassis & top for corrosion protection YesStainless steel fasteners for corrosion protection YesDual AC branch rated output breakers Optional on the MS2000 and MS2012 - AC breakers in 15 or 20 amp ratingsListings ETL Listed to UL/cUL 458, UL 1741, CSA C22.2 #107.1-01, meets KKK-A-1822E standardWarranty Three yearsEnvironmental SpecificationsOperating temperature -20° C to +60° C (-4° F to 140° F)Nonoperating temperature -40° C to +70° C (-40° F to 158° F)Operating humidity 0 to 95% RH non condensingPhysical SpecificationsDimensions (l x w x h) 13.75” x 12.65” x 8.0” (34.9 cm x 32.1 cm x 20.3 cm)Mounting Shelf (top or bottom up) or bulkhead (vents up)Weight 40 lb (18.1 kg) 42 lb (19.1 kg) 55 lb (24.9 kg) 55 lb (24.9 kg)Shipping weight 45 lb (20.4 kg) 47 lb (21.3 kg) 60 lb (27.2 kg) 60 lb (27.2 kg)Max operating altitude 15,000’ (4570 m)