Banke - Model TM43 -On-Board Hydraulic System

Preliminary specifications are subject to change without further notice – 7 June 2021

• Note: Indicated weight is for double chamber fixed displacement pump. Additional weight is 20 kg for the Loadsense variable pump.
• Power Levels E-motor and installed capacity: 0-30 kW, operational, peak power 45 kW, HLR Version: continuous power 20 kW 43 kWh (new and excluding aging)
• Battery Technology: LiFePO4
• Battery Lifetime: 2000 full cycles
• Battery Heating: Electric 400W forced air, to enable full charging capacity – even at low temperatures
• Battery Voltage: 80-115V
• Battery Cell Protection: Balancing and active protection on all cells
• Battery Pack Protection: Fully protected against overcurrent, over-, and under-voltage, excessive temperature use and charging
• Motor Technology: AC motor with variable closed loop RPM control
• Control Interface: Either CAN, analogue, PWM, or I/O
• Charging: On-board 3,3 kW Connector on drivers side (Left)
• Charging Time: 12 -13 hours (single charger)
• AC Installation Requirements: 3x400V AC 50 Hz, standard 5 pole 16A CEEplug and 16 Amp Group with RCD
• 24V Supply from ignition key: 16-32 VDC max 5A. Protection requirement, 10A fuse
• Hydraulic Interface: Single or Dual chamber fixed displacement pump or single chamber LS variable displacement pump
• Temperature Range: -20˚C to +45˚C (above 35˚C power derating possible)
• Cooling: Forced air
• IP-grade: IP65, allowing high-pressure wash down. Note: high-pressure wash down not allowed directly in charging connector, IP44
• Dimensions (L,W,H): 400mm, 1590 mm, 1552 mm Note: Excl. hydraulic connections & cable entries & Bolt heads
• Weight (see note): 600 kg
• Options: Charge current reduction. Charging by chassis alternator via inverter Double charger to reduce charging time