Solar - Model RFI/EMI - Current Probes and Injection Probes
From Probes
Direct connection to the conductor carrying EMI current is not necessary, since the probe may be opened for insertion of the conductor into the window of the toroid and then closed again to form a toroidal transformer with the conductor acting as a one-turn primary.A correction factor graph is provided to convert measured µV to EMI µAs. When the EMI current is measured in dB above 1 µV as indicated on a conventional EMI meter,the correction factor will convert the measurement to dB above 1 µA.The correction factor is the inverse of the transfer impedance, Zt. Each probe is shipped with a graph of the correction factor versus frequency, keyed to the serial number on the probe.Under certain conditions, a current probe can be used to inject low level RF signals into individual wires or cable bundles. Ask our engineers for advice in the use of current probes for this purpose. Some current probes can be easily damaged or are otherwise unsuitable for this application.
-
Most popular related searches
Details:
CURRENT PROBES
Current probes required by various EMI specifications (such as MIL-STD-461/2) are toroidal transformers designed to measure RF currents on active power lines or other conductors.
APPLICATION
A current probe is used as a “pick-up” device for measuring RF current in single conductors or cable bundles when connected to the 50 Ω input of a radio frequency interference measuring receiver or spectrum analyzer.
INJECTION PROBES
Specifications require the injection of large high frequency currents into cable bundles and individual wires, using inserted secondary toroidal transformers placed around the conductors being tested.
APPLICATION
High power RF amplifiers with 50 Ω output impedance are used to deliver voltage to the injection probe. The wire or cable through the window of the probe acts as a secondary of the toroidal transformers. This test method is intended to be used instead of earlier methods, such as CS-01, CS-02, and RS-02 of MIL-STD-461.
DESCRIPTION
Bulk current injection probes are available in two styles:
- Fixed window style where the wire(s) under test must be passed through the window.
- A split toroidal design where the probe can be opened up and clamped over the wire(s) under test.
Each probe is calibrated for insertion loss and transfer impedance in a test fixture designed for the particular window size. This fixture provides a signal path with a low Voltage Standing Wave Ratio (VSWR). A typical fixture is Solar Type 9125-1, used for probes with 32 to 44 mm diameter windows. Ask for details on this and other test fixtures.
Injection probes currently available are described later in this section. Development of new styles is ongoing. If a probe meeting your requirements is not found on the list, send us details and we will provide a solution.
Customer reviews
No reviews were found for Solar - Model RFI/EMI - Current Probes and Injection Probes. Be the first to review!