SolarGuard - Model WMPVC100 -Solar Panel Bird & Pest Excluders

Bird Screen Solar Panel Barrier will allow the maximum amount of air flow into and out of the area under the solar arrays. Along with birds & squirrels, it keeps out debris that could get stuck under the solar array and create a fire hazard.

NOTE: We offer both 6" and 8" wide rolls of wire mesh so it is very imortant to measure the gap under your solar panel before placing your order.

Black 1/2" Mesh and Solar Panel Clips are sold separately.

Item #:Description

• WMPVC100:  SolarGuard Black 1/2” mesh, 6”x100’ roll
• WMPVC8X100    SolarGuard Black 1/2” mesh, 8”x100’ roll

SolarGuard Bird Screen Solar Panel Exclusion Quick Specs:

• Clips come in poly/plastic or stainless steel versions
• Clips slip over the lip of the solar panel framework - NO drilling
• Install clips every 18" around the perimeter of the solar arrays
• Cut the mesh to fit around objects or roof tile shapes
• Clips are available in 10 or 100 count bags
• PVC coated Wire Mesh is 19 gauge
• Available in 6" and 8" wide rolls

Steps to install the SolarGuard Bird Screen Solar Panel Exclusion system:

1. Put the clip end of the fastener onto the panel edge underneath the panel. Use a clip every 18" or less. Slide as far outward as possible so the clip is seated against the lip of the panel.
2. Set the wire mesh screen in place. Make sure the fastener rod comes through the screen at an upward angle to keep pressure of the screen on the rooftop.
3. Slide the speed washer onto the shaft of the clip assembly until snug. Make adjustments to the screen as needed. Tighten the speed washer to the panel edge.
4. Cut off any excess mesh screen sticking over the top edge of the solar panel array. Cut off the clip assembly rod flush with the exterior of the speed washer.
5. Where the corners come together use two pieces of mesh screen. DO NOT try to bend the screen to go around the corner. Attach the corners together using thin bailing wire or UV rated zip ties.