Only show results in Virginia? Ok

Solar Photovoltaics equipment for Solar Energy

  • Premium

    Model MI-520 - PV Module Selector

    Long term stability of PV modules can be evaluated with the multi channel MP-160 system. I-V characteristics of multiple PV cells and modules can be measured individually. MI-520 module selector gives 12 channels to measure the PV modules sequentially. In total 4 units of the MI-520 can be connected to the MP-160.

    By EKO Instruments based in San Jose, CALIFORNIA (USA). from PV Module Selector Product line

  • Premium

    GPE - Model 31551 - Heavy Duty Edge Guide Sensor

    The Model 31551 Heavy Duty Edge Guide Sensor is specifically designed for heavy duty strip guiding applications, where maximum versatility is required. The sensor consists of two sturdy cast steel housings which are mounted separately, providing greater installation flexibility. One housing contains the photocell and is available in two options, ...

    By Shand & Jurs (L&J Technologies & L&J Engineering) based in Hillside, ILLINOIS (USA). from Heavy Duty Edge Guide Sensor Product line

  • Premium

    Model MP-165 - Electronic Load Method I-V Curve Tracer

    Electronic Load Method I-V Curve Tracer MP-165 is a next generation I-V curve tracer which is capable of measuring a wide range of PV device characteristics from small to big capacity. It is capable of taking samplings of voltage, current, and solar irradiance at the same time; also it is simple to take measurements with an artificial light source ...

    By EKO Instruments based in San Jose, CALIFORNIA (USA). from Electronic Load Method I-V Curve Tracer Product line

  • Premium

    Geonica - Model Series Si - Calibrated Solar Cell

    Si sensors use a high-quality monocrystalline solar cell connected to a high accuracy shunt. The low shunt resistance causes the cell to operate close to the short-circuit point. Si sensors can be provided with active temperature compensation to avoid any possible measurement shifts caused by the temperature. The compensation is realized by using ...

    By Geonica SA based in Madrid, SPAIN. from Calibrated Solar Cell Product line

  • Premium

    GPE - Model 31581 - Autowide Centerguide Sensor

    The Model 31581 Autowide Centerguide Sensor is designed specifically to provide continuous scanning of the entire span of strip width variations. This eliminates operator adjustments for strip width changes. The sensor consists of two light source housings and two solar cell housings. 250 watt lamps are used as the light source and the number of ...

    By Shand & Jurs (L&J Technologies & L&J Engineering) based in Hillside, ILLINOIS (USA). from Autowide Centerguide Sensor Product line

  • Premium

    Model MP-160-S1 - PV Evaluation System

    The 6 channel outdoor Photovoltaic (PV) module(s) evaluation system based on the MP-160 is designed to measure I-V curve and module back-side temperature, to evaluate the performance of each module under natural sun light and weather conditions. The main instrument in this system is the MP-160 I-V Tracer, with an additional 6 channel selector for ...

    By EKO Instruments based in San Jose, CALIFORNIA (USA). from PV Evaluation System Product line

  • Premium

    Model MP-160-S2 - PV Evaluation System

    The 12 channels outdoor Photovoltaic (PV) module(s) evaluation system based on the MP-160 is designed to measure I-V curve and module back-side temperature to evaluate the variance of the performance of each module under the natural sun light and weather condition. The main instrument is I-V curve tracer MP-160 with additional 12 channels PV ...

    By EKO Instruments based in San Jose, CALIFORNIA (USA). from PV Evaluation System Product line

  • Premium

    Model MP-303 - PV Load Selector

    To test the long-term stability of PV modules, particularly with EKO's MP-160 outdoor based test system, the I-V characteristics of multiple PV cells and modules can be measured. The MP-160 in combination with the MP-303 Load Selector provides 6 channels to measure IV curves of PV modules which can be kept at MPPT conditions with an optional load. ...

    By EKO Instruments based in San Jose, CALIFORNIA (USA). from PV Load Selector Product line

  • Premium

    Model MP-410 MPPT - Electronic Load

    The MP-410 electric load can be used for continuous module performance evaluation of single PV modules up to 300W. Based on the advanced MPP tracking function, the PV module power will be automatically regulated and can be monitored when exposed to solar irradiance or a sun simulator. Compared to regular I-V tracers, the MP-410 can provide ...

    By EKO Instruments based in San Jose, CALIFORNIA (USA). from Electronic Load Product line

  • Premium

    Model MI-510 - PV Module Selector

    Long term stability of PV modules can be evaluated with the multi channel MP-160 system. I-V characteristics of multiple PV cells and modules can be measured individually. MI-510 module selector provides 6 channels to measure the PV modules sequentially. In total 4 units of the MI-510 can be connected to the MP-160 and 4 units to the MP-180.

    By EKO Instruments based in San Jose, CALIFORNIA (USA). from PV Module Selector Product line

  • Premium

    Model MP-303S - PV Load Selector

    To test the long-term stability of PV modules, particularly with EKO's MP-165 based outdoors test system the I-V characteristics of multiple PV cells and modules can be measured. The MP-165 in combination with the MP-303S Load Selector provides 6 channels to measure IV curves of PV modules which can be kept at MPPT conditions with an optional ...

    By EKO Instruments based in San Jose, CALIFORNIA (USA). from PV Load Selector Product line

  • Premium

    Model MI-510S - PV Module Selector

    To test the long-term stability of PV modules, particularly with EKO's MP-165 based outdoors test system, the I-V characteristics of multiple PV cells and modules can be measured. MI-510S module selector gives 6 channels to measure the PV modules sequentially. In total 8 units of the MI-510S can be connected to the MP-165.

    By EKO Instruments based in San Jose, CALIFORNIA (USA). from PV Module Selector Product line

  • Module Laser Inspection Machine

    Inspection machine to detect cracks in photovoltaic modules by irradiating laser beam.Can detect inner cracks which cannot be detected visually.

    By NPC Incorporated based in Arakawa-ku, JAPAN.

  • Solar Laminates

    UNI-SOLAR® photovoltaic laminates (PVL) are flexible and lightweight laminates made exceptionally durable by encapsulation in UV stabilized polymers.  The polymer encapsulation is partially constructed of durable ETFE, (example, Tefzel®) a high-light-transmissive polymer. Power Ratings from 68W to 144W, Lightweight & Flexible Easy Peel ...

    By United Solar Ovonic based in Rochester Hills, MICHIGAN (USA).

  • JRT - Cell Test Line

    The JRT Cell Test Line sorts the solar cells according to efficiency and optical criteria. The results allow each cell to be assigned a specific performance level and quality category.

    By Jonas & Redmann Automationstechnik GmbH based in Malterdingen, GERMANY.

  • Model Sol 2x2m2 - Flashlight Simulator

    Measures IV characteristics of PV modules—maximum power, open circuit voltage, short circuit current—at standard test conditions (STC, IEC standard 60904-1). Simulated sunlight spectrally filtered to AM 1,5 global, using Xenon flashlamps, intensity adjustable. Suited for laboratory measurements and integration into production lines. ...

    By Optosolar GmbH based in Merdingen, GERMANY. from Flashlight Simulator Product line

  • Model Sol 6x12 - Flashlight Solar Simulator

    Measures IV characteristics of PV modules—maximum power, open circuit voltage, short circuit current—at standard test conditions (STC, IEC standard 60904-1). Simulated sunlight spectrally filtered to AM 1.5 global, using Xenon flashlamps, intensity. Suited for laboratory measurements and integration into production lines. Temporal ...

    By Optosolar GmbH based in Merdingen, GERMANY. from Flashlight Solar Simulator Product line

  • Model Black18 NS6CL NS6DL - Mono-Crystalline Silicon Solar Cell

    Dimension 156 mm x 156 mm ± 0.5 mm.Wafer ThicknessNS6CL : 200|jm ± 30pmNS6DL: 180um + 30|pm / -20pm.Front(-)Two 2.0mm wide bus bars (silver) with distance 75 mm,alkaline texturized surface with dark blue silicon nitride AR coating.Back(+)3.5 mm wide silver/aluminum soldering pads, aluminum back surface field.

    By Neo Solar Power Corp. based in Hsinchu, TAIWAN.

  • BixCure - Solar Encapsulants

    Tomark Industries, Inc. is proud to introduce BixCure, a new line of EVA encapsulant from BIxby International for use in the manufacture of PV modules. The introduction of the BixCure EVA encapsulant complements Tomark's current Photomark EPE and DuraShield backsheet product offerings, strengthening our commitment to serve the growing global PV ...

    By Tomark Industries, Inc. based in Glen Mills, PENNSYLVANIA (USA).

  • Calibrated Reference Photovoltaic Solar Cell

    To insure repeatable testing on any solar simulator, OAI offers 2cm x 2cm calibrated reference cells. Standard reference cell calibration cycles can be set up by OAI's calibration laboratory to insure that your reference cell maintains certification.

    By OAI based in San Jose, CALIFORNIA (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you