Applications in South Korea

  • Premium

    Compressed air, gas and vacuum solutions for biogas/biomethane

    Customers benefit from the extensive know-how that AERZEN has gained from decades of experience in the chemical and petrochemical industry. The use of biogas as an energy source will considerably help achieve the environmental objectives set nationally and internationally; be that reducing reliance on nuclear energy or the reduction of CO2 emissions.

    By Aerzener Maschinenfabrik GmbH Office in Sejong, SOUTH KOREA.

  • Premium

    Monitoring solutions for the flue gas desulphurisation

    Most large coal fired plants have a flue gas desulphurisation (FGD) plant to lower SO2 levels to below emission limit levels. The CODEL GCEM 40 series is used to monitor SO2 levels after the FGD to ensure they are below required levels and to ensure that the process is not too efficient and using too much sorbent. In addition, many plants monitor pre and post the FGD to ascertain the efficiency of the plant.

    By Codel International Ltd Distributor in Pohang City, SOUTH KOREA.

  • Premium

    Technologies for bioethanol industry

    By Bioprocess Control AB Distributor in Goyang City, SOUTH KOREA.

  • Premium

    Technologies for biogas industry

    By Bioprocess Control AB Distributor in Goyang City, SOUTH KOREA.

  • Premium

    International testing for biofuels

    Sustainable use of biofuels requires reliable and precise analytical methods throughout – from the choice of raw materials through to process optimization and on to the compliant final product. As a leading manufacturer of instruments for chemical analysis, we are quite aware of these challenges.

    By Metrohm AG Distributor in Seoul, SOUTH KOREA.

  • Premium

    Several waste gas streams: Short, high concentration peaks and a constant |medium concentration

    Concentration peaks and liquid waste posed a tough challenge on the air pollution control system. With the CTP solution, this waste is not only disposed of but also reduces the burner energy considerably.

  • Premium

    Monitoring solutions for the flow combustion efficiency areas

    Combustion efficiency is of major importance on small boiler plants and the best way to monitor this is by monitoring CO2 emissions. CODEL offer the Model 1010 Cross-Duct CO monitor. Using Infra-red Gas Filter Correlation technology to filter out interferences such as dust and other gases. The Model 1010 has low maintenance requirements and meets the needs of most boiler applications. In addition to small boilers the Model 1010 is also used on Animal carcass incinerators and Crematoriums.

    By Codel International Ltd Distributor in Pohang City, SOUTH KOREA.

  • Premium

    pH value and conductivity measurement for power plants

    Growing populations – about 80 million every year – and industrializing countries create huge needs for electrical energy. According to the International Energy Agency (IEA) the global energy demand will increase by about 65% by 2035. A major fraction of the required energy will continue to be provided by thermal – mainly fossil fuel-fired and nuclear – power plants. "Renewable" energy sources such as photovoltaics (PV) will be another backbone of our energy supply. Putting renewable energy on the grid requires powerful energy storage and conversion devices, such as supercapacitors, batteries, or fuel cells.

    By Metrohm AG Distributor in Seoul, SOUTH KOREA.

  • Premium

    Technologies for biohydrogen industry

    By Bioprocess Control AB Distributor in Goyang City, SOUTH KOREA.

  • Premium

    Dosing pumps for anaerobic disgestion and biogas industry

    Biogas is a natural gas also known as biofuel or biomass and is produced by breaking down organic material such as household waste, manure and crops grown specifically for biofuel with temperature-sensitive microbes and capturing the by-products.

    By Verderflex Peristaltic Pumps - part of the Verder Group Office in Shinjung5 Dong, SOUTH KOREA.

  • Premium

    Research and commercial applications for the biogas industry

    Covering areas of substrate analysis, process simulation, gas flow measurement, as well as a series of bioreactors.

    By Bioprocess Control AB Distributor in Goyang City, SOUTH KOREA.

  • Premium

    Portable and fixed gas analysers for agricultural waste AD (large scale)

    Large agricultural processors install AD plant to generate revenue and dispose of biodegradable waste, which is usually a single type.

    By Geotechnical Instruments (UK) Ltd Distributor in Goyang-Si, SOUTH KOREA.

  • Premium

    Very large waste gas volumes with low contaminant concentration

    The CTP desorption allows for an especially high concentration factor which, in turn, reduces the cost of ownership and permits an auto-thermal operation (additional burner switched off) even when the contaminant concentration is low.

  • Premium

    Fast C1 to C5 - PetroAlert Series 9100

    The PetroAlert® Series 9100 combines the selectivity of gas chromatography with the sensitivity, broad dynamic range, and hydrocarbon selectivity of a flame ionization detector (FID) providing a 30 second analysis of C1-C5 hydrocarbons required in Mud Logging for Oil & Gas exploration, while maintaining C1-C2 separation at 200:1 concentration ratios.

    By AMETEK MOCON - Baseline Distributor in Seongnam, SOUTH KOREA.

  • Premium

    Flame ignition for flares

    By AEREON Distributor in Seoul, SOUTH KOREA.

  • Premium

    Hydropower monitoring

    By Stevens Water Monitoring Systems, Inc. Distributor in Seoul, SOUTH KOREA.

  • Premium

    Meteorological sensors for solar monitoring

    The most important measurement parameter is irradiation. Since PV systems are becoming ever larger, the accuracy of the irradiation measurement is increasingly important for the efficiency of the system. Wind cools the temperature of the module and must therefore be included in the efficiency calculation. Precipitation leads to contamination or covering (snow). With increasing temperature, the performance of the solar module decreases. Therefore, it is important to measure the temperature of the solar module in addition to the air temperature.

    By G. Lufft Mess- und Regeltechnik GmbH Distributor in Gyeonggi-do, SOUTH KOREA.

  • Premium

    Sensor for Biogas

    Anaerobic Digestion plants produce various gas components from a source material (or feedstock) that can be composed either solely or as a mixture of slurries, purpose-grown crops, food and organic waste material. The composition of the gas produced varies depending upon the feedstock and the Anaerobic digestion process itself. As a consequence, it is normal to measure various components of the resultant gas produced to evaluate the efficiency of the Anaerobic Digestion process. Furthermore, due to the flammable nature of Methane (CH4), and the risk of asphyxiation, most plants feature ambient air monitoring to protect personnel from any unplanned accumulation of leaked gas. CH4 is the gas component fuel, which is the intended end product of the anaerobic digestion process. In biogas plants, the concentration of CH4 in a working plant varies between 50%-75%, which is well above the Upper Explosive Limit (UEL).

    By Edinburgh Sensors Ltd Distributor in Anyang-si, SOUTH KOREA.

  • Premium

    Gas Sensing for Gasification

    Syngas (short for synthetic gas) can be burnt and used as a fuel source, the main constituents of syngas are Carbon Monoxide (CO) and Hydrogen (H), which amount for around 85% of Syngas, and it is produced by a process called Gasification. Gasification starts with a base material which can originate from a wide variety of materials for example wood chips and pellets, plastics, municipal solid waste, sewage, waste crops, and fossil fuels such as coal. During Gasification the base material is reacted at high temperature without combustion with controlled amounts of oxygen (O) or steam. The composition of the base material combined with the amount of oxygen and heat used in the process affects the composition of the resultant SynGas, in which the CO can vary between around 20 and 60%. In addition, large amounts of H and CO are also formed. The measurement of CO is therefore an important feature in the production of SynGas.

    By Edinburgh Sensors Ltd Distributor in Anyang-si, SOUTH KOREA.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you