Low Nox Articles & Analysis: Older
18 articles found
DESCRIPTION Ener-Core simulated a low energy gas (50-70 Btu/scf) produced during a proprietary drilling process at the request of a large oil and gas customer. ...
The turbines combust exclusively pipeline natural gas and utilize a dry low-NOx combustor to minimize NOx emissions. The turbines drive a 170 MW generator for production of electrical power. ...
The turbines are in the process of being retrofitted to utilize a state-of-the-art dry-low-NOx combustor design that achieves minimal NOx emission ...
The ETF group has been working on the design and numerical testing of highly innovative low-emission burners by using CFD as a design tool rather than a merely investigation tool. The first milestone of the working plan consisted in the definition of a three-flux low-NOx 35MW clean coal burner. The design process started with the definition of ...
Quick Facts LOCATION: Amherst, Massachusetts FUEL: Natural Gas and Oil MAX CAPACITY: 16 MW POLLUTION CONTROL: Selective Catalytic Reduction (SCR) ENVIRONMENTAL BENEFITS: 99.3% SOx Reduction, 93% NOx Reduction, 96% CO Reduction AVERAGE CAPACITY FACTOR: ~ 75% ENERGY OUTPUT: 100,000 MWh per year IN OPERATION SINCE: April 2009 EQUIPMENT: 10 MW Solar Gas Turbine; 4 MW and 2 MW Steam ...
CHP met their requirements as the university ultimately constructed a new energy center adjacent to the old central steam plant, containing two Cleaver-Brooks 45,000 lbs/hour natural gas-fired water-tube boilers with low-NOx burners; a single 25,000 lbs/hour fire-tube boiler; and a 5.7 MW gas turbine with a heat recovery steam generator (HRSG) capable of ...
Quick Facts LOCATION: Marietta, Ohio MARKET SECTOR: Chemical CHP GENERATING CAPACITY: 8 MW PRIME MOVER: Solar Taurus 70 gas turbine FUEL: Natural Gas HEAT RECOVERY EQUIPMENT: 150,000 lb/hr HRSG with fresh air firing capability Two 80,000 lb/hr package boilers HEAT RECOVERY RATE: Up to 150,000 lb/hr of 300 psig process steam USE OF THERMAL ENERGY: Process heating ENVIRONMENTAL CONTROLS: ...
Burners –Most modern incinerators are fitted with low NOx or modulated gas flow burners. Fuel Tanks– Fuel tanks should be bunded to ensure safe strange of fuel The Incineration Process0 Incineration of waste materials converts the waste into ash, flue gas, and heat. ...
- Proven 2- and 3 bed Regenerative Thermal Oxidizer Design - 99% plus VOC Destruction Efficiency - Up to 97% Thermal Efficiency - Up to 30% fuel savings with proven natural gas injection - Low NOx burner operation - In-house design, programming and manufacturing, no outsourcing - All RTOs completely factoty pre-assembled and tested - Top quality ...
Thermal and catalytic oxidizers are routinely used to destroy VOC emissions from a variety of industrial sources. NOx and CO are common byproducts created in the burning of natural gas. ...
The aim of these different air flows is the complete and environmental friendly combustion which will cause high efficiency and low NOx emissions. Thus air staging must be precisely measured and controlled. ...
Job report / Elbisgraben (Bale / Switzerland) The summer of 1992 had finally arrived. The 5MW low emission furnace in the district heating station Liestal was ignited, supplied with landfill gas from Elbisgraben landfill. Since then the plant has been running continuously and the comprehensive measurements taken, verify that all targets aimed at have been achieved: plant ...
In Russia, China, South Africa, the U.S. and many other countries existing precipitators are going to be upgraded or replaced to meet limits as low as 5 mg/Nm3. Options include: New larger precipitator Hybrid with one field replaced with bags Complete retrofit of precipitator shell with bags New fabric filter for 350oF New 850oF ceramic fabric filter with more efficient ...
Mawera FSR and FSB Boiler range mawera-biomass-boiler-bemodern2Mawera’s flat moving grate combustion (type FSR and FSB ) enables the use of different fuels enabling a low particulate content in the flue gas, due to the static fuel bed. Low NOx reduction technology can be employed to best effect in Mawera flat moving grate combustion ...
ByMawera
In the following applications, it may sometimes be desirable to run sub-stoichiometrically and to have some way of knowing at all times how oxidizing or reducing the process is: Heat treatment of metals Wire manufacturing Heat treatment of ceramics and porcelains Primary stage of a thermal oxidizer (incinerator) Manufacture of specialty glass, e.g. colored glass Primary stage of a ...
SOIL-THERM’s patented Jet-THERM direct fire Thermal and Catalytic Oxidizer technology provides many benefits to our customers not found anywhere else: (1) Lower NOx emissions, (2) Very energy efficient and lower fuel usage with or without H.E. ...
In some non-corn-belt areas of the country where ethanol plants are now being proposed, such as those in ozone non-attainment areas or transport regions, major source thresholds are as low as 50 or even 25 tpy of VOCs to trigger non-attainment New Source Review (NNSR) permitting. ...
Reburning is an in-furnace combustion modification technology for the reduction of NOx. By staging the introduction of the fuel, an environment is created where NOx generated by the combustion of the main fuel supply is subsequently consumed by the hydrocarbon radicals arising from the reburn fuel under reducing conditions. ENEL has retrofitted unit No. 4 of Vado ...