Atmos - Model A25 - Conveyors for Pellet Burner
DA1500, DA2000, DA2500, DA3000, DA4000. Auger pellet conveyor DA1500 with lenght 1,5 m, Ø 75 mm (gearbox 25 W) code: H0151. This conveyor is specified only for boilers where the burner is on the sides - D14P, D21P, D25P, D15P, D20P, DCxxSP. This conveyor is not intended for boilers with modification for pellet burner.
Auger pellet conveyor DA2000 with lenght 2 m, Ø 75 mm (gearbox 25 W) code: H0207
This conveyor is specified for gasification boilers with burner in upper doors. - DCxxS(X), DCxxRS, DCxxSP, CxxS, ACxxS. You can use them allso for standart pellet boilers DxxP.
Auger pellet conveyor DA2500 with lenght 2,5 m, Ø 75 mm (gearbox 25 W) code: H0208
Auger pellet conveyor DA3000 with lenght 3 m, Ø 75 mm (gearbox 40 W) code: H0209
Auger pellet conveyor DA4000 with lenght 4 m, Ø 75 mm (gearbox 40W) code: H0212
This conveyor is specifed for all pellet boilers ATMOS, when the pellet silo is in bigger distance from the boiler.
The length of the conveyor must be chosen that the hose between the turner and conveyor is tightened and have lenght at least 20 cm (ideally 30 - 60 cm) for safety reasons. The maximum length of the hose should not exceed 1 m.
- with leg conveyor -Every conveyor is delivered with a support leg.The length of the leg should be set that the angle of the conveyor should be maximum 45° and the hose is tightened.
- hanging from the ceiling - In a limited space the support leg is recommended to be replaced by a chain, on which the conveyor is suspended from the ceiling. The length of the leg should be set that the angle of the conveyor should be maximum 45° and the hose is tightened.
CAUTION: The conveyor is available separately, but is an integral part of the pellet burner A25