Bryan - Model Free Flex (FF) Series -Ultra-High Efficiency Condensing Boiler

Uncommon & Serviceability Access
Maintenance accessibility is as critical part of the overall boiler design, and the Free Flex does not disappoint. Front, left-hand side, the jacket and flue collector doors are easily removed for full access to service and clean the heat exchanger and burner/blower/gas train assembly. Liberal heating surface throughout the pressure vessel evenly distributes heat transfer promoting longer product lifecycle. Tubes can be removed or replaced with simple hand tools in minutes. Commercial-grade controls used in the construction of the boiler can be purchased locally for fast repair.

Variable Primary or Primary/Secondary Piping
Not only are ourtubes flexible, but so are the different ways to pipe Free-Flex. With low water pressure drops, the Free-Flex is able to operate in low flow designs, Variable-Primary, and traditional primary/secondary designs.

Knockdown Capability
Knockdown and condensing were never mentioned before in the same sentence.. .until now! The Free Flex is available in various knockdown configurations best suited to gain access into a building that other packaged boilers will not. Individual components will easily fit through a standard door opening and can be reassembled without requiring the services of an ASME welder. Depending on the needs, the Free Flex can be partially assembled or completely disassembled.

Reverse Construction
Reverse (mirror) construction is available when two boilers are needed for side-by-side installation. This allows full access to the heat exchanger, burner/blower/ gas train assembly on the right-hand side instead of the standard left-hand side, keeping the footprint as small as possible in tight mechanical rooms.

Competitive Footprint
The Free Flex offers a competitive Installed footprint. Connections are located at the top of the unit freeing the sides of cluttered piping that often get in the way of servicing the boiler. The jacket encompasses the flue outlet assembly that permits minimum clearances to the rear where other models must accomodate for venting in floor print.