Eurosens - Model DDS -Remote Axle Load Control and Cargo Weight System

Eurosens DDS converts the angle of rotation of the sensor’s lever to  output signal. As the transducer is used magnetoresistive sensor.At the output of the sensor is formed stabilized analog voltage signal, which corresponds to the angular position of the pivot arm, changing depending on the load on the axle vehicle.Eurosens DDS 485 uses LLS/MODBUS protocol. Eurosens DDS CAN uses CAN bus J1939 protocol with configurable PGN. After installation and wiring Eurosens DDS you should perform a calibration in which you are mapping the output voltage to the load on the suspension of the vehicle.