Turbine Generation Capacity Articles & Analysis
8 articles found
Quick Facts LOCATION: Macon, Missouri ETHANOL CAPACITY: 50 million gallons per year PROCESS STEAM REQUIRED: 85,000 lb/hr at 125 PSI PRIME MOVER: Solar MarsTM Natural Gas Turbine GENERATING CAPACITY: 10 MW HEAT RECOVERY EQUIPMENT: Deltak Heat Recovery Steam Generator CHP MAXIMUM THERMAL OUTPUT: 51,000 lb/hr ...
Quick Facts LOCATION: Lena, Illinois MARKET SECTOR: Ethanol Plant PRIME MOVER: (1) Solar Gas Turbine FUEL: Natural Gas GENERATING CAPACITY: 5.0 MW HEAT RECOVERY EQUIPMENT: (1) Victory Heat Recovery Steam Generator with thermal capacity of 25,700 lbs/hr at 125 PSI HEAT RECOVERY APPLICATION: Building ...
A$850M: Project Cost 1,510,000MWh: Expected low Emission Contribution 123: Turbines installed 453MW: Generation capacity Coopers Gap Wind Farm is a 453MW wind energy project to be located at Cooranga North, approximately 180kms north-west of Brisbane, Queensland. ...
n operation since 1923, the Medway Hydroelectric Project is a run-of-river generating facility located on the Penobscot River in Medway, Maine. The plant was restored by Black Bear Hydro Partners LLC in 2011/2012 under the Penobscot River Restoration Agreement. CHC provided two 2500 mm replacement Francis runners to fit to the existing draft tubes. The new ...
The powerhouse was built in 1900 and houses a total of five turbines, with a combined generating capacity of 1.14 MW. Back in 2006, CHC refurbished two of the existing units and provided two new main turbine shafts. In 2008, CHC replaced another of the existing units with a new 800 mm axial flow Kaplan turbine, ...
Costs are being driven down by technological advancements, including the production and installation of turbines with greater generating capacity, an increase in turbine hub height up to 272 feet (83 meters) and an increase in average rotor diameter. ...
ByEnsia
The power factor at the interface with the grid is controlled by the MC to ensure purely active power injection into the grid for optimal utilisation of the installed wind turbine capacity. The generation system has fuzzy logic control with vector control in the inner loops. ...
Nearly 700 cities in China with an urban population of more than 100,000 all need high levels of basic infrastructure investment, including electricity, housing, transportation, water and wastewater. At the start of 2000, hydro generation capacity in China stood at 73,000 megawatts (MW). By 2005 the total was 95,300 MW, and this capacity is ...