Steam Turbine Generator Articles & Analysis
11 articles found
It will use 67,000 green tonnes/year of locally-sourced class A – C wood waste diverted from landfills to produce steam that will be converted into electricity through a steam turbine and generator system. ...
The Once Through Steam Generator installed at the Toronto Pearson Airport to make the airport self sustainable. This unit produces 75 MW of power, while the total airport consumption is 38 MW. CPF’s scope of supply included the filter house, silencer and baffles, project management and detail drawings. ...
One old boiler was upgraded, a new boiler was purchased and a CHP project with a heat recovery steam generator (HRSG) was installed within the old power station footprint. ...
Student population over 3,300 Campus Loads: 42,000 MWh per yr 7.5 MW peak demand 70,000 lbs per hr steam Prime Movers: Solar Taurus 60 combustion turbine 70k lb/hr HRSG with redundancy Murray KG4 steam turbine Annual Energy Savings: $1.25 MM between 2003 and 2006 Installed System Cost: $12 MM Began Operation: June 1998 Reasons ...
A frequent scenario for a Romtec Utilities pump station is pumping for a heat recovery steam generator (HRSG) or blowdown process in cogeneration/combined-cycle power plants. ...
It included the development of a two dimensional model of the rotor, thermal zones and corresponding thermal boundary conditions (heat transfer coefficients and steam temperatures) calculation during turbine start-up and shut down operation. ...
A CSP project proposal has won first place in the 2014 Land Art Generator Initiative (LAGI) competition, but can the design make it beyond paper? ...
Using the temperature differential between warm ocean surface water and cold deep water to generate clean baseload (24/7) renewable energy, in a closed cycle OTEC system, the heat from the surface water is used to boil a working fluid with a low boiling point (such as ammonia), creating steam which turns a turbine generator to ...
Their main focus is on how the wood is processed. Generating energy from sander dust and woodchips Konold Härtsfelder Holzindustrie GmbH produces around 10,000 doors and blanks each month, along with 7,000 door frames. ...
This paper appraises the current development status of the 700?C steam power plant under consideration of process optimisation as well as design aspects of the steam turbine and steam generator. The results for a compact arrangement of the steam turbine and steam ...
Combining a gasification process with power generation is called “Integrated Gasification Combined Cycle” or IGCC. As shown in Figure 4, a typical IGCC facility combines the gasification process with a Brayton cycle (gas turbine/generator) and a Rankine cycle (steam turbine/generator). ...