Only show results available in Virginia? Ok

Small Hydropower equipment for Hydro Energy

  • Hydro Surge Control Valve

    When American Turbine Pump designed the Hydro Surge Control Valve, we did it for our customers. We kept seeing the same problems over and over throughout the industry: deep-set pumps would shut down and the backflow of fluid would often cause the non-reverse ratchet to fail. The rushing fluid resulted in broken ratchets, destroyed engines, ...

    By American Turbine based in Lubbock, TEXAS (USA).

  • Global Hydro - Model smarT - Small Compact Turbines

    smarT is a new economic design for small turbines in the range of 100kW to 500kW. Goal of the development was the reduction of the installation time on site. Attributable to the compact assembly of all necessary parts, the expense for installation is nearly reduced to zero. Another focus during the development was a robust, maintenance-friendly ...

    By Global Hydro Energy GmbH based in Niederranna, AUSTRIA.

  • Francis Turbines

    Either standardized units for small hydro or tailor-made solutions, VAPTECH is delivering high-quality Francis turbines. VAPTECH’s care for maximum efficiency and resistance to cavitation is guaranteed by flow dynamic analyses and tests from leading European research centers.

    By VAPTECH Ltd based in Sofia, BULGARIA. from Hydro Product line

  • Hydropower Screw

    Hydropower systems with a screw belong to small-scale hydropower plants. Don’t be deceived by the term “small”. This technology provides power to 13 million European households. This saves the environment 29 million tons of CO2.

    By REHART Group based in Ehingen, GERMANY.

  • Heidemann - Micro Hydro Stations For Remote Areas

    Building a hydropower plant, even small hydro plants, in almost all cases is a project which requires a larger investment. Again the omnipresent question of feasibility often rules out minor projects even if the realization would be a success for the area. Not the production of electricity only but as well operating pumping stations and water ...

    By Heidemann Wasserkraftanlagen based in Burladingen, GERMANY.

  • Heidemann - Refurbished Turbines

    After World War II when the energy demand in Germany rose constantly the nuclear-energy-focused policies of the larger energy concerns were concentrated on eliminating small and smallest competitors. In addition in the 1950s and 1960s many mills and factories that had operated own hydropower stations were closed down or did not carry on operation ...

    By Heidemann Wasserkraftanlagen based in Burladingen, GERMANY.

  • INSET - Units for Small Hydro Power Plants

    Hydro units with axial type turbines (GA-1, GA-8, GA-8M, GA-14, Pr15, Pr30) and output up to 1800 kW; Hydro units with Francis type turbines (GA-2, GA-4, GA-9, GA-11) and output up to 5600 kW; Hydro units with Pelton type turbines (GA-5, GA-10, GA-10M, 200K) and output up to 3 300 kW.

    By INSET Ltd. based in St Petersburg, RUSSIA.

  • Gamesa Electric - Electrical Generators

    The hydroelectric sector is characterised by a high level of customisation, as each power station must be optimised according to the hydroelectric resource available and the configuration of the installation.

    By Gamesa Electric based in Zamudio, SPAIN.

  • EGP - Hydroelectric Power Services

    The generation of hydroelectric energy occupies the first place at a global level. In Europe the hydroelectric potential is now being entirely utilised. This is why, Enel Green Power is now concentrating on run-of-river hydro power, a type of system that, despite having a limited unit power, can give a significant contribution to the demand of ...

    By Enel Green Power SpA based in Rome, ITALY.

  • Hydrake - Hydraulically Powered Grit Removal Classifiers

    The EMS Hydrake hydraulically powered rake classifier offers large capital savings compared to traditional mechanically driven rakes plus huge power savings through programmable operating cycles. EMS can manufacture any size of Hydrake to suit small, medium or large waste water treatment plants and can design them to fit into existing civil ...

    By EMS Industries Ltd based in Knypersley, UNITED KINGDOM.

  • Vertical and Horizontal Small Hydro Generators

    Small standard hydro generators are defined as three-phase synchronous electrical machines for coupling to hydroelectric turbines - either with direct coupling type or via speed-up gear box.

    By Alstom based in Saint-Ouen, FRANCE. from Hydro Generators Product line

  • Entec - Model DTC-Vario - Digital Control System

    The digital control system DTC-Vario is the most recent development of entec for controlling, supervision, protection, data acquisition and visualisation of small hydro power stations. Based on a hardware from SAIA, entec developed the appropriate software. Entec’s long term experience in the field of small hydro power stations is reflected ...

    By Entec AG Consulting & Engineering based in St Gallen, SWITZERLAND.

  • Etaeval - Thermodynamic Efficiency Measurements

    Thermodynamic efficiency measurements are performed to determine the absolute efficiency of hydraulic machines. The procedure for such a measurement is described in detail within the IEC (International Electrotechnical Commission) standard 60041 'field acceptance tests to determine the hydraulic performance of hydraulic turbines, storage pumps and ...

    By Etaeval GmbH based in Horw, SWITZERLAND. from Measurements Product line

  • SolarImmersion - PV Immersion Heater

    SolarImmersion uses a clip-on sensor on the incoming service grid lines. The clip-on sensor can be attached anywhere before the consumer unit.From the clip-on sensor, the intelligent SolarImmersion unit gets accurate information required to compute whether the power is imported or exported. Once the unit detects that the power is exported, it ...

    By SEMSI Ltd based in London, UNITED KINGDOM.

  • Hydro Turbines

    The Hydro Energia own hydroelectric Turbines technology is based on 25 years long experience in design and production of the main type of turbines such as: Kaplan, Francis and Pelton from 100 kW up to 40 MW, each ones with various setting according to the needs of our Costumers. In the last years almost 200 hydro units have been engineered, ...

    By ATB Riva Calzoni SpA based in RONCADELLE (Bs), ITALY. from Small Hydro Product line

  • TES - Synchronous Generators

    Synchronous generators are among theTEM division’s products in highest demand. They are suitable for all types of hydro turbines with outputs up to 20,000 kVA. In spite of the product’s common characteristics,it is a customized product manufactured according to requested parameters for each specific application. The machine design is ...

    By TES VSETIN s.r.o. based in Vsetín, CZECH REPUBLIC. from Electric Machine Product line

  • TES - Model GAK Series - Asynchronous Generators

    GAK series of asynchronous generators with a short-circuit armature is suitable for all types of hydro turbines with outputs up to 1.5 MW. This series meets the specific requirements for alternators intended for this application. The main features are robust construction and sufficiently dimensioned machine parts. The rotor is executed with regard ...

    By TES VSETIN s.r.o. based in Vsetín, CZECH REPUBLIC. from Electric Machine Product line

  • Rainpower - Control Systems for Small Hydro

    Rainpower AS, trough Hymatek Controls, is currently one of Scandinavia’s largest and most influential professional environments for turbine and voltage regulation. The company comprises experienced employees with solid professional expertise and experience, and young, highly trained and highly ambitious staff. Hymatek Controls delivers ...

    By Rainpower Norway as based in Kjeller, NORWAY.

  • Scott - Cross Flow Turbine/Generator Unit

    Unlike most water turbines, which have axial or radial flows, in a cross-flow turbine the water passes through the turbine transversely, or across the turbine blades. As with a water wheel, the water is admitted at the turbine's edge. After passing the runner, it leaves on the opposite side. Going through the runner twice provides additional ...

    By Scott Hydroelectric based in WASHINGTON (USA).

  • Electrical Power Engineering-Production

    Electric equipment manufactured by ZRE Gdansk is characterized by low failure rate, high quality and high reliability. The Company supplies serial products of its own production, distributes DEHN products and manufactures tailor-made products. ZRE Gdansk is an official distributor of renowned European company DEHN+SÖHNE safety equipment for ...

    By ZRE Gdansk S.A. based in Gdansk, POLAND.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you