- Home
- Equipment
- germany
- power distribution
- power transformers
Show results for
Refine by
Power Distribution Equipment Supplied In Germany
84 equipment items found
Premium
Manufactured by:DILO Armaturen und Anlagen GmbH based inBabenhausen/Schwaben, GERMANY
For reliable continuous cooling. The essential advantage of our refrigeration units is that the cooling is carried out by means of water outside the transformer. This is to prevent the transformer from being damaged if leaks occur. The cooling systems can be connected to the gas insulated transformer directly and are optimally suited for continuous ...
Manufactured by:GlobeCore based inOldenburg-Eversten, GERMANY
This CMM 4/7 mobile oil processing unit is designed for degassing, removal of solids and heating of oil for power transformers with voltage up to 1,150 ...
Manufactured by:ARADEX AG based inLorch, GERMANY
High-speed 388 kVA mobile inverter for various drive applications with integrated SafeTorqueOff function according to DIN EN 61800-5-2. Supports PM, PM-reluctance and AC-induction motors. For special applications, a version without integrated Y-capacitors is ...
Manufactured by:Nordex SE based inHamburg, GERMANY
The N117/2400 has been specially developed for low-wind sites. Thanks to a rotor diameter of 117 meters and a rotor sweep of 10,715 square meters, the N117/2400 is the highest-yielding IEC 3 turbine in its class. In typical low-wind regions, it will achieve a capacity of over 3,500 full-load hours, thus exceeding other turbines in this category by 20 percent. This translates into a capacity ...
Manufactured by:Nordex SE based inHamburg, GERMANY
The Nordex N100/2500 kW is a 2.5 MW wind turbine specially configured for moderate and low wind conditions. The N100/2500 is one of the largest turbines in the Nordex product line and its yield rates among the highest in its power class. With a rotor sweep of 7,854 square metres, this IEC-2 certified turbine operates particularly profitably in medium and low wind ...
Manufactured by:BLOCK Transformatoren-Elektronik GmbH based inVerden, GERMANY
General Data: Power 15 - 3,000 VA. Efficiency up to 98 %. Maximum ambient temperature 104 °F / 40 °C. Insulation class B. Degree of protection IP 00. Rated output voltage 2 x 6 - 2 x 115 Vac. Rated input voltage 2 x 115 ...
Manufactured by:Solfas Technologie GmbH based inBerlin, GERMANY
The GHV2000 is a high-voltage safety tester designed for precise dielectric testing of electronic devices such as transformers, chokes, and coils. This tester features a 6kV AC output with adjustable voltage regulation and overcurrent protection up to 100mA, ensuring accurate and safe testing processes. It supports both AC and optional DC high-voltage testing, as well as insulation resistance and ...
Manufactured by:Mak Plus Power Systems based inKöln (Cologne), GERMANY
Shore to ship power supply is used to change of main power’s frequency value, to supply 440volt, 460Volt, 480Volt, 575Volt, 600Volt or 690Volt 60Hz or 50Hz energy to supply energy to the systems and vessels at the harbors. That’s why, power supply production sector has to find a solution for this kind problem. It can be said that frequency converters are the machines to pretend these ...
Manufactured by:Mak Plus Power Systems based inKöln (Cologne), GERMANY
Mak Plus Power Systems produces conv-mak series frequency converter 3 phase 800 kW or 720kW / 800 kVA 50hz to 60hz or 60hz to 50hz in Germany or Europe. The 800 kVA 3 phase frequency converter 60hz to 50hz solutions are IGBT used, transformerless or with additional isolation transformer and high-tech and advanced designed converters can be used in military services, refineries, navigation ...
Manufactured by:FAIST Anlagenbau GmbH based inKrumbach (Schwaben), GERMANY
Transformers in the substations of power grid operators generate an especially low frequency soundscape with many tones heard over longer distances. Effective transformer sound insulation is thus essential if there are residential areas in the vicinity of the substations. FAIST noise barriers have – as an alternative to the relatively complex and costly enclosure of individual transformers ...
Manufactured by:SGB-SMIT Group based in, GERMANY
At higher voltages, large auto-transformers are used to interconnect the 400kV-500kV systems with either the 230kV-275kV systems or 120kV-145kV systems (the exact values depend on the country being considered). The HV and MV windings in an auto-transformer are connected together unlike in other transformers. The result is that the MV winding (common winding) is shared between the MV and HV ...
Manufactured by:SGB-SMIT Group based in, GERMANY
Grid transformers are used in similar situations to autotransformers but are used where the neutral point of both HV and LV system are required to be kept separately. They are physically larger than a correspondingly rated autotransformer as the windings are fully ...
Manufactured by:SGB-SMIT Group based in, GERMANY
A typical application of Shunt reactors is power factor compensation of a circuit, for example to compensate for the capacitance of long overhead transmission line or for much shorter lengths of HV cable. At low loads, the remote end of these lines may rise in voltage (the so called “Ferranti Effect”). This is especially prevalent in developing countries where the system may be only ...
Manufactured by:Janitza Electronics GmbH based inLahnau, GERMANY
Moulded case current transformers are used if high currents are to be recorded and further processed. The line to be measured (conductor rail or wire) is fed through the window opening and forms the primary circuit for the plug-on current transformer. Moulded case current transformers are predominantly used for mounting on conductor rails. Through additional potting it is possible to achieve ...
Manufactured by:Janitza Electronics GmbH based inLahnau, GERMANY
Moulded case current transformer for billing purposes. The applicable regulations for kWh measurement devices can be fulfi lled with these tariff current transformers. All tariff current transformers are equipped with an integrated lockable terminal cover, produced from polycarbonate. The current transformers are supplied with a fastening tool, for mounting on rails or cables. The transformers ...
Manufactured by:Schäfer Elektronik GmbH based inAchern, GERMANY
The IV Series of DC/AC inverters. The design of the IV Series synchronizes three individual switch mode inverters and three output transformers, for a symmetrical 3-phase output. The transformers provide input/output isolation, while transforming the voltages to user required ...
Manufactured by:MBS AG based inSulzbach-Laufen, GERMANY
Unlike conventional current transformers with a 1 or 5 A secondary output signal, current sensors output a voltage ...
Manufactured by:SGB-SMIT Group based in, GERMANY
More than 70 years of know-how and experience is reflected in the oil distribution transformers made by SGB-SMIT Group. Our production (in Germany and Malaysia) is based on high-quality production materials, and we place the highest emphasis on first-class workmanship. The result: oil distribution transformers of maximum ...
Manufactured by:GlobeCore PC based inOldenburg-Eversten, UKRAINE
GlobeCore regeneration units now offer two (2) revolutionary features: Energized transformer oil processing; and Automatic Sorbent Reactivation. The GlobeCore Process is performed continuously on most energized transformers without the need to remove, replace, and dispose of contaminated Fuller’s Earth sorbent material. No hazardous waste and one man crew equals lower costs and efficient ...
Manufactured by:Crestchic Ltd. based inBurton-on-Trent, UNITED KINGDOM
To complement our range of load banks and also serve the international temporary power generation sector, Crestchic manufacturers a range of containerised step-up/step-down transformers. The multi-tap transformers range from 2000kVA to 8000kVA, with voltage up from 600v to 34.6kV. ...