- Home
- Equipment
Refine by
Martin Energy Equipment & Supplies
14 equipment items found
Manufactured by:Martin GmbH für Umwelt- und Energietechnik based inMunich, GERMANY
The combustion of residual waste is a complex process since the composition, heating value and ash content of the fuel is very heterogeneous. As a result, operators of waste-to energy plants face an enormous challenge: Given a service life of more than 30 years, the technology must also be able to function efficiently with the changing waste composition in the ...
Manufactured by:SIMEC Atlantis Energy based inLondon, UNITED KINGDOM
The AR1500 is a Lockheed Martin designed, 1.5MW horizontal axis turbine complete with active pitch and yaw capability. The nacelle weighs approximately 150 tonnes in air and has a design life of 25 years. The rotor diameter is 18 meters and all key operational systems have triple redundancy built in to maximise reliability offshore. ...
Manufactured by:Martin GmbH für Umwelt- und Energietechnik based inMunich, GERMANY
The combustion system, consisting of the grate system and furnace, forms the technological focal point of waste-to-energy plants. Various combustion concepts are available to achieve the best possible burnout at low flue gas flows and the lowest emission levels in terms of the elements influenced by the combustion process (CO, CxHy, ...
Manufactured by:Martin Energy Group, LLC based inTipton, MISSOURI (USA)
Standby generators offer a steadfast solution to extended outages. Unlike portable generators, they’re installed permanently and will provide uninterrupted backup power. Blackouts are nothing new, but major storms over the past two years have hammered home the importance of electrical power. A standby generator can ensure your business remains energized for days. MEG can provide solutions ...
Manufactured by:Martin Energy Group, LLC based inTipton, MISSOURI (USA)
A Combined Heat and Power (CHP) system is typically connected to the utility grid and operates in parallel with it under normal conditions. However, when the utility grid fails or becomes “Unhealthy,” a Synchronous Cogeneration system seamlessly transitions into island mode. In island mode, the CHP system ensures continuity of power supply to the facility or ...
Manufactured by:Martin Energy Group, LLC based inTipton, MISSOURI (USA)
Martin Energy Group has an efficient, clean, and reliable solution to generating power and thermal energy from a single source of fuel. By integrating our state-of-the-art CHP system into your facility, you can meet your base loads of electricity and thermal demands efficiently while decreasing energy costs and reducing the emissions of greenhouse gases. The Modular approach allows you to easily ...
Manufactured by:Martin Energy Group, LLC based inTipton, MISSOURI (USA)
In a conventional system, approximately two thirds of the fuel burned to generate power is lost as heat. Our engineered Exhaust heat recovery systems allow you to capture thermal energy from your exhaust gases, engine jacket water, and oil cooling systems. This recovered heat can be utilized to produce hot process water or steam for a wide variety of useful applications such as heating and ...
Manufactured by:Martin Energy Group, LLC based inTipton, MISSOURI (USA)
A heat recovery steam generator (HRSG) is an energy recovery heat exchanger that recovers heat from a hot gas stream. It produces steam that can be used in a process (cogeneration) or used to drive a steam turbine (combined ...
Manufactured by:Bob Martin Company based inSouth El Monte, CALIFORNIA (USA)
Aluminum Wire used in aerospace, marine, construction, and automobile industries. It is a heat treatable wrought alloy with intermediate ...
Manufactured by:Martin GmbH für Umwelt- und Energietechnik based inMunich, GERMANY
For decades, the MARTIN discharger has proven to be a compact, reliable and cost-effective device. The hot, burnt-out bottom ash is transported from the grate end to the discharger's water bath where complete quenching occurs. The water consumption depends exclusively on the temperature of the bottom ash and its capacity to absorb water. Only sufficient water to quench the bottom ash is fed to ...
Manufactured by:Martin GmbH für Umwelt- und Energietechnik based inMunich, GERMANY
The limit values for emissions applicable to waste-to-energy plants are more stringent than those applying to any other type of industrial plant. Irrespective of this, the trend to further minimize pollutant emissions is continuing. At MARTIN GmbH, this led to the development of the SYNCOM process, which consists of the following ...
Manufactured by:Martin Energy Group, LLC based inTipton, MISSOURI (USA)
Bio-gas is the product of anaerobic decomposition by microbes in putrescible organic material. These microbes feed off carbohydrates and fats, producing methane and carbon dioxides as metabolic waste products. Bio-gas consists of primarily methane (the source of energy within the fuel) and carbon dioxide. Bio-gas may also contain small amounts of nitrogen or hydrogen. Contaminants in the bio-gas ...
Manufactured by:Martin Energy Group, LLC based inTipton, MISSOURI (USA)
Blending, Fuel Blending gas engine control system is designed for gas engines used in applications where the energy quality of the fuel supply is variable, but where the customer wants to be able to supplement “Fuel 1with Fuel 2”. The Fuel Blending system combines natural gas with other fuels, adjusting the fuel mix continuously during engine operation to achieve desired power outputs ...
Manufactured by:Martin Energy Group, LLC based inTipton, MISSOURI (USA)
Resilient. Flexible. Sustainable. Instant switchover in case of grid shutdown. Custom solutions for any industry and any size. Integrate with Martin gen-sets and own your microgrid. Local service and remote monitoring 24/7. ...