power measurement system Articles

  • DNV GL: A Cleaner, More Electrified World Is Within Reach by 2050

    Earlier this month (9/5), DNV GL published its first Energy Transition Outlook (ETO): Renewables, Power and Energy Use. The industry implication report is part of DNV GL’s new suite of Energy Transition Outlook publications. The report reviews global energy demand and energy supply and summarizes the implications for the power and ...


    By DNV GL

  • Power curve measured and verified – Case Study

    In 2010 RSE SpA (Energy System Research Inc.) within a Program Agreement with the Italian Ministry of Economic Development started a measurement campaign on a Libellula wind plant installed in Tuscany. The campaign lasted 1 ½ years and during this time RSE measured the turbine’s power curve following the requirements of the relevant IEC Standard ...


    By Aria s.r.l

  • Modelling and measuring the operability of interdependent systems and systems of systems: advances in methods and applications

    Interdependency is an important consideration in managing systems and systems of systems. Included in this consideration is identifying, representing, and measuring the ripple effects of dependencies between systems and consumers who rely on their products and services. Anticipating these effects enables planners to minimise dependency risks that, if realised, can have cascading impacts on the ...


    By Inderscience Publishers

  • Regulations and standards for the measurement of performance and management of ageing of I&C systems of nuclear power plants

    Instrumentation and Control (I&C) equipment is vital to the safety and viability of nuclear power plants. This equipment must provide accurate and timely measurements of plant control and safety systems to ensure efficient operation and guard against mishaps. Given this, numerous regulations, standards and guidelines have been devised to formulate requirements and establish maintenance methods to ...


    By Inderscience Publishers

  • A new way to measure emissions from China’s Coal-Fired Power Plants

    To prevent the most severe impacts of climate change, it is essential to limit fossil fuel use—particularly coal use in power production. The share of coal in global energy consumption is increasing, with ...

  • Soil CO2 Flux Measurements -- Powering the LI-8100/8150 in a Remote Location: Power Requirements and Solar Panel Solution

    INTRODUCTION Long-term automated simultaneous measurements at multiple locations within the same study site are often required to adequately characterize high spatial and temporal variability of the soil CO2 fluxes. The multiplexed LI-8100/8150 is a fully automated system ...


    By LI-COR

  • Measuring Offshore Wind Resources

    To select the right offshore wind site, estimate the future energy output of a wind farm, and determine the best layout for the turbines, project developers must conduct wind resource assessment (WRA) campaigns on site. This is a critical phase of the successful development of wind farms. WRA campaigns on terrestrial sites have traditionally been performed using meteorological towers equipped ...


    By NRG Systems

  • Design of an autonomous renewable hybrid power system

    This paper presents the development of an optimisation model for the design of an autonomous solar-wind hybrid system in combination with battery bank and diesel generator. The performance of solar and wind system is evaluated using new practical mathematical models, in combination with hourly measured meteorological data. Loss of power supply probability technique is used as a key system ...


    By Inderscience Publishers

  • Software-based Neutron Flux Measurement Channel (NFMC)

    For research nuclear reactors such as the TRIGA type, the design of Neutron Flux Measurement Channels (NFMC) has been based, mainly, on discrete digital electronic technology. The work presented here consists of the development of a new version of an NFMC whose aim is to measure the reactor power through six decades using the correlated signal of a wide range fission chamber. The correlation ...


    By Inderscience Publishers

  • Solar power generation by photovoltaic technology

    The various forms of solar energy, solar heat, solar photovoltaic, solar thermal electricity, and solar fuels offer a clean, climate-friendly, very abundant and in-exhaustive energy resource to mankind. Solar power is the conversion of sunlight into electricity, either directly using photovoltaic (PV), or indirectly using concentrated solar power (CSP). The research has been under way since the ...


    By Greenshine New Energy LLC

  • Combined Heat and Power – Questions and Answers

     1. What are the benefits of CHP for business?   combined heat and power (CHP) is a well-proven technology, recognised worldwide as a cleaner alternative to traditional centralised generation. Its long-term future in the global energy markets is secured by CHP's ability to provide a multitude of financial, ...


    By ENER-G

  • Geothermal Energy... Power from the Depths

    The Earth's crust is a bountiful source of energy—and fossil fuels are only part of the story. Heat or thermal energy is by far the more abundant resource. To put it in perspective, the thermal energy in the uppermost six miles of the Earth's crust amounts to 50,000 times the energy of all oil and gas resources in the world! The word 'geothermal' literally means 'Earth' plus 'heat.' ...

  • Instantaneous voltage measurement technique for PWM voltage source inverters

    The pulse width modulated (PWM) voltage source inverter (VSI) is almost universally used in industrial motor drives. Although measurement of the VSI output voltage is required in many applications, accurate measurement is problematic due to the high frequency inverter switching. Many commonly used inverter output voltage measurement methods, such as indirect and direct voltage measurement, ...


    By Inderscience Publishers

  • Intelligent system supporting defect identification and sizing using eddy current testing signals in nuclear power plants

    Two premier issues in eddy current testing, namely the automatic identification of cracks from their noisy backgrounds and the sizing of cracks with complex morphologies, are dealt with in this paper. A signal processing method based on statistical pattern recognition is established to realise automatic crack identification, and a method for estimating crack depth is proposed, using a new ...


    By Inderscience Publishers

  • Countering security risks to nuclear power plants

    Between 1972 and 2007, altogether 17 major terror attacks or acts of sabotage were carried out against Nuclear Power Plants (NPPs). None of them resulted in an uncontrolled radioactive release. In order to reduce the security risk to NPPs due to terrorists in the future, preemptive measures are necessary to identify their motivation, incentives, and operational and logistical capabilities to ...


    By Inderscience Publishers

  • How much wind is needed to power a home turbine?

    First do you have what it takes? Whether you are considering a small rooftop unit or a large residential turbine you need to know how much wind power is in your area. Wind resource maps, published by the US Department of Energy show airflow speeds at 50 meters (150 feet) above the ground and are a great resource in deciding if you are in a viable location. That's great if you are installing a ...


    By Bosworth Instrument

  • World geothermal power generation nearing eruption

    With fossil fuel prices escalating and countries searching for ways to reduce oil dependence and greenhouse gas emissions, capturing the earth’s heat for power generation is garnering new attention. First begun in Larderello, Italy, in 1904, electricity generation using geothermal energy is now taking place in 24 countries, 5 of which use it to produce 15 percent or more of their total ...


    By Earth Policy Institute

  • Monitoring the Bavarian nuclear power plants online applying a Lagrangian model

    In 1997, the Monitoring System for Nuclear Power Plants (KFÜ) - located in the Bavarian office of environmental protection - was upgraded. The change included replacing the Gaussian plume model by a numerical dispersion model based on the Lagrangian theory. The KFÜ system allows the assessment of the doses workers receive in routine and emergency operation. Improvements of the new monitoring ...


    By Inderscience Publishers

  • Fuzzy logic based fault diagnosis of a PWR nuclear power plant

    Proper and timely fault diagnosis is of premier importance to guarantee the safe and reliable operation of Nuclear Power Plants (NPPs). If faults occur in NPPs, it is very difficult for a human operator to perform routine tasks, such as distinguishing normal from abnormal conditions and predicting future states, etc. In this paper, a fuzzy inference system is adopted for the diagnosis of abrupt ...


    By Inderscience Publishers

  • E.ON Benelux power station Maasvlakte, Rotterdam - Case Study

    Next Generation Power Production E.ON’s new Maasvlakte power station also known as MPP3 is built in the harbour of the Dutch metropolis Rotterdam. The modern supercritical hard coal fired unit with a capacity of 1100 MW is expected to have a thermal efficiency of more than 46 percent. The new plant built in the vicinity of the existing Maasvlakte station is designed as cogeneration ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you