Only show results in Virginia? Ok

Low Head Hydropower equipment for Hydro Energy

  • Kaplan Hydro Turbines

    Alstom's Kaplan turbines in operation cover low head applications ranging from about 15 to 50 meters, and outputs up to 130 MW.Compared to Bulbs, their vertical configuration allows larger runner diameters (above 10 m) permitting to increase the unit power and thus minimising the number of units.Kaplan turbines have the same challenge as Bulb ...

    By Alstom based in Saint-Ouen, FRANCE. from Kaplan Hydro Turbines Product line

  • 3Helix - Hydropower Turbine

    Power has been generated for thousands of years using water wheels, which convert falling water directly into energy.  Water wheels are quite efficient, but do have some significant limitations for both low and especially high head applications.    Water turbines were developed in the 1800’s to circumvent these ...

    By 3Helix Power based in VIRGINIA (USA).

  • ANDRITZ - Hydromatrix

    Hydromatrix is a new innovative concept of hydraulic energy generation, combining the advantages of proven technology and low cost installation, which is easily integrated into existing dam structures or weirs. Projects that are not economically feasible with conventional turbine-generator designs can now be developed profitably by using the ...

    By ANDRITZ AG based in Graz, AUSTRIA. from Hydromatrix Product line

  • ADDNEW - Model turbine - Hydro power Francis Turbine

    They operate in a head range of 10 meters to 300 meters and are primarily used for electrical power production. The power output ranges from 160KW to 20000KW, Runner diameters are between 0.35 and 2.5 meters. The speed range of the turbine is from 150 to 1000 rpm.* Excellent peak efficiency.* High efficiency also at partial water flow down to ...

    By Addnew Hydropower Limited based in Changsha, CHINA.

  • GE - Bulb Hydro Turbine

    Unrivaled power capacity ratio for low heads. With more than 300 bulb units installed worldwide, GE brings expertise in design, manufacturing, installation, commissioning and management of complex bulb projects, for a wide range of environmental conditions. The term 'Bulb' describes the shape of the upstream watertight casing which contains a ...

    By GE Renewable Energy based in Paris, FRANCE. from Bulb Hydro Turbine Product line

  • Cross-Flow Turbines

    The cross-flow turbine is a type of impulse turbine.  The design of this particular turbine was initially developed by Anthony Michell, an Austrian Engineer, in the early 1900’s.  The idea was further developed by Donát Bánki, a Hungarian engineer, and even later it was improved upon again by Fritz Ossberger, a German ...

    By HydroTech Engineering, LLC based in Sandy, UTAH (USA). from Cross-Flow Turbines Product line

  • Model (30KW-100KW) - Volute Axial Flow small hydro Water Turbine Generator

    It is applicable under low head conditions from 1.5 meters to 18meters with large flow. This new type of machine has solved the problem that ordinary axial flow generator has long main shaft and the bearings at the impeller must be immersed into water and thus cause easy damage; The open channel of the volute chamber can not utilize the water head ...

  • Fugesco - Radial Turbine Seal

    Radial type seals are used in hydroelectric turbines, pump-turbines and large pumps. The primary purpose of a mechanical radial shaft seal is to maintain a near watertight seal between the turbine shaft and the head cover. Depending on the pressure under the seal, two or more carbon segmented sealing rings are required. This seal is reliable, ...

    By Fugesco Inc. based in Pointe-Claire, QUEBEC (CANADA).

  • Ronamic - Low Head HydroPower High Power Turbine

    This turbine is a typical application of the RONAMIC technology in rivers and water reservoirs with (existing) dams where there is an abundance of water. This RONAMIC turbine is designed with a special flow system for high flow and high power output. Despite a slightly lower turbine efficiency, the generated power is substantially higher than that ...

    By Ronamic based in CW Noordwijk, NETHERLANDS.

  • Rickly - Nautilus Francis Turbines

    The Francis Turbine is a 'reaction' turbine, meaning that it works in a fully flooded chamber and reacts to the flow of water around it. These turbines typically work best in cases where there is low-medium head, or in areas of downstream pressure after the turbine.

    By Rickly Hydro based in Columbus, OHIO (USA). from Nautilus Francis Turbines Product line

  • ASFM Advantage™ - Flow Measurements in Hydroelectric Plants

    The ASFM Advantage provides the hydroelectric industry with a reliable, accurate and cost-effective method of measuring discharge, especially at low-head hydro plants with short or irregular intakes, where accurate discharge measurement has traditionally been difficult. If intake slots are available and the ASFM Advantage can be mounted on frames, ...

    By ASL AQFlow Inc. based in Victoria, BRITISH COLUMBIA (CANADA).

  • Scott - Cross Flow Turbine/Generator Unit

    Unlike most water turbines, which have axial or radial flows, in a cross-flow turbine the water passes through the turbine transversely, or across the turbine blades. As with a water wheel, the water is admitted at the turbine's edge. After passing the runner, it leaves on the opposite side. Going through the runner twice provides additional ...

    By Scott Hydroelectric based in WASHINGTON (USA).

  • Kaplan Turbines

    The axial turbines are designed for projects with low and very low heads with a strong flow variation. VAPTECH offers mainly the classic vertical shaft Kaplan turbine with 3 to 6 runner blades and with double regulation. For runner diameters up to 1400 mm we use a steel spiral casing and for bigger runner diameters we recommend a concrete spiral ...

    By VAPTECH Ltd based in Sofia, BULGARIA. from Kaplan Turbines Product line

  • Butterfly Valves

    Butterfly valves are used as safety hydraulic systems for low or medium pressure with minimum head loss when the water is passing through the rotor. They are used as gates and emergency devices at the turbine inlet or at the intakes.

    By VAPTECH Ltd based in Sofia, BULGARIA. from Butterfly Valves Product line

  • Bulb Hydro Turbines

    With more than 300 bulb units installed worldwide, Alstom has outstanding knowledge and experience in design, manufacturing, installation, commissioning and management of complex bulb projects, whatever the environmental conditions.

    By Alstom based in Saint-Ouen, FRANCE. from Bulb Hydro Turbines Product line

  • Global Hydro - Kaplan Turbines

    These are used particularly in low pressure plants that use large quantities of water with heads less than 40 meters.

    By Global Hydro Energy GmbH based in Niederranna, AUSTRIA.

  • Global Hydro - Pelton Turbines

    They are used for relatively low quantities of water with high heads up to 1000 meters. Efficiency and performance definitely remain constant, independent of whether conditions it is used in mountain regions or as storage power station.

    By Global Hydro Energy GmbH based in Niederranna, AUSTRIA.

  • Alstom - Bulb Hydro Turbines

    Alstom Bulb units provide the most efficient solution when faced with heads up to 30m. Bulb units have almost replaced Kaplan turbines for new low head power plants.With more 309 Bulbs installed worldwide, Alstom has outstanding knowledge and experience in design, manufacturing, installation, commissioning and management of complex Bulb projects, ...

    By Alstom based in Saint-Ouen, FRANCE. from Bulb Hydro Turbines Product line

  • Hydro Turbines

    Waterpumps WP Oy’s hydro turbines are designed for small hydro on low head sites. There are two main designs of turbines, tube and compact type. The designed head may vary from 1 to 30 meters and the flow of the unit can be fixed or regulated. Many of the plants designed for WP Oy’s products are equipped with several turbine generators ...

    By Waterpumps WP Oy based in Helsinki, FINLAND.

  • Model UKP-16001 - LitFinger Illuminated Disconnect Hook

    The LitFinger and LitLink are the world's first hotstick tights (patent pending). Both products have a built-in, high intensity LED light for safe and efficient operations in dark or low light areas. They connect to any major hotstick with a splined universal slotted connector. The LrtFinger has a machined alumi-num pointed head for fuse barrel ...

    By Provix Inc. based in Alliston, ONTARIO (CANADA). from LitFinger Illuminated Disconnect Hook Product line

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you